practical thermal design of shell-and-tube heat exchangers - r mukherjee (begell house, 2004) ww
practical thermal design of shell-and-tube heat exchangers - r. mukherjee (begell house, 2004) ww
... Engineering Editor: G.F. Hewitt Practical Thermal Design of Shell-and-Tube Heat Exchangers R. Mukherjee PRUH FRQYHQLHQW WR VSHFLI\ WXEHV E\ WKHLU RXWHU GLDPHWHU %HVLGHV RXWHU ... 7KH\DUHPHFKDQLFDOO\UREXVWWRZLWKVWDQGQRUPDOVKRSIDEULFDWLRQVWUHVVHVWKH ULJRUVRIWUDQVSRUWDWLRQDQGHUHFWLRQDVZHOODVWKHVWUHVVHVRIQRUPDODQGDEQRU PDORSHUDWLQJFRQG...
Ngày tải lên: 03/05/2014, 20:02
advances in thermal design of heat exchangers a numerical approach direct-sizing, step-wise rating, and transients
... evaluate heat- transfer per- formance over the range of valid Reynolds numbers for both sides of the exchanger. This provides a heat- transfer curve. Pressure-loss performance is similarly ... half-height surfaces optimal pressure loss exergy constraint but preferably design with Ma < 0.1 FOR RANGE OF Re VALUES FOR SIDE-1 GENERATE heat- transfer curve pre...
Ngày tải lên: 02/04/2014, 15:14
Tài liệu Practical Design of Ships and Other Floating Structures Volume I pdf
... hold of bulk carriers, bulk carrier losses have been drastically reduced. Requirements for longitudinal strength and fatigue strength of tankers are under review. Enhanced Survey Program (ESP) ... C.D. Barry NOVEL SHIP CONCEPTS - TRIMARAN The Design of Trimaran Ships: General Review and Practical Structural Analysis T. Coppola and M. Mandarin0 Calm Water Experimental...
Ngày tải lên: 13/02/2014, 16:20
compact heat exchangers selection design and operation
... Surface selection Process exchangers Refrigeration exchangers Automotive and prime mover sector Aerospace sector References Chapter 3 The Heat Exchanger as Part of a System: Exergetic (Second ... 261 262 xvii Thermal Design for Heat Exchanger Reactors Mechanical Aspects of Design Pressure containment Strength of bonds References Chapter 7 Compact Heat Ex...
Ngày tải lên: 02/04/2014, 15:23
fouling of heat exchangers, elsevier (1995
... Fouling of Heat Exchangers If the heat exchange area required for the required heat transfer is A, then the rate of heat transfer Q ev (2.7) In general the design of heat exchangers involves ... fuels are of course, extensively used for the generation of heat used to raise steam for the production of electrical power. Under these circumstances a large frac...
Ngày tải lên: 02/04/2014, 15:23
handbook for heat exchangers and tube banks design
... Heat Exchangers and Tube Banks Design, DOI 10.1007/97 8-3 -6 4 2-1 330 9-1 _2, C Springer-Verlag Berlin Heidelberg 2010 8 2 Design Computation For the computation of the heat transfer coefficient of ... tube banks the heating fluid transferring heat cools down, whereas the heated fluid receiving it warms up. In other words, the heat transfer implies the variability of...
Ngày tải lên: 02/04/2014, 15:24