IEC 61158 2 physical layer specification and service definition
IEC 61158 2 physical layer specification and service definition
...
19
2 Normative references
20
3 Terms and definitions
22
3.1 Common terms and definitions
22
3 .2 Type 1
:
Terms and definitions
26
3.3 Type 2: Terms and definitions
27
3.4 ...
23 6
23 Type 3: Medium Attachment Unit: Asynchronous Transmission, optical medium
24 2
24 Type 4: Medium Attachment Unit: RS-485
25 2
25 Type 4: Medium Attachment Unit: RS -2...
iec 60439-2 low-voltage switchgear and controlgear assemblies - particular requirements for busba
... Handling Services
COPYRIGHT International Electrotechnical Commission
Licensed by Information Handling Services
COPYRIGHT International Electrotechnical Commission
Licensed by Information Handling ... Handling Services
COPYRIGHT International Electrotechnical Commission
Licensed by Information Handling Services
COPYRIGHT International Electrotechnical Commission
Licensed by Information Handli...
Tài liệu Lab Exercise 2 - Inter-VLAN Routing and Multi-layer Switching pdf
... Addresses
Switch A 10.1.1.1 /24
Switch B 10.1.1 .2/ 24
PC-1 10 .2. 1.1 /24
PC -2 10 .2. 1 .2/ 24
PC-3 10.3.1 .2/ 24
Router
VLAN 1 - 10.1.1 .25 4 /24
VLAN 2 - 10 .2. 1.1 .25 4 /24
VLAN 3 - 10.3.1.1 .25 4 /24
CertificationZone ... 0/0 .2
Router(config-subif)#ip address 10 .2. 1 .25 4 25 5 .25 5 .25 5.0
Router(config-subif)#encapsulation isl 2
Router(config-subif)#int fa 0/0.3
Router...
Tài liệu Chapter 4: Configuring Layer 1 and Layer 2 Features docx
... address VC ID Status
Po1 Eth VLAN 2 1 72. 2 .2. 2 2 UP
Po1 Eth VLAN 2 1 72. 4.4.4 2 STANDBY
Use the show etherchannel summary command to display the status and identity of the MLACP
member links.
MLACP-PE1# ... lag-priority 28 000
mlacp interchassis group 100
service instance 2 ethernet
encapsulation dot1q 2
rewrite ingress tag pop 1 symmetric
xconnect 1 72. 2 .2. 2...
IEC 60947 6 2 low voltage switchgear and controlgear multiple function equipment control and
... `,``,``,``,`,````,,`,``,```,`-`-`,,`,,`,`,,`
60947-6 -2 IEC: 20 02 – 21 –
IEC 60695 -2- 13 :20 00, Fire hazard testing – Part 2- 13: Glowing/hot-wire based test methods –
Glow-wire ignitability test method for materials
IEC 60947-1:1999, ... attributes
IEC 60695 -2- 10 :20 00, Fire hazard testing – Part 2- 10: Glowing/hot-wire based test methods –
Glow-wire apparatus and com...
IEC 61131 2 programmable controllers equipment requirements and tests
...
10
Scope and object
10
Compliance with this standard
11
2 Type tests
13
2. 1
2. 2 Special features for immunity and EMC tests
15
2. 3 Withstand test conditions
16
2. 4 Verification ...
17
Normal service conditions and requirements
24
Mechanical service conditions and requirements
25
Electrical service conditions and requirements
27
3
4...
IEC 61158 1 overview and guidance for the IEC 61158 series
... 02/ 23 /20 06 00 :22 :26 MST
No reproduction or networking permitted without license from IHS
``,,,,,``,,,``````,`````-`-`,,`,,`,`,,`
– 10 – TR 61158- 1 © IEC: 20 03(E)
7 .2 The IEC 61158 Data Link Layer
In ... systems:
Part 1: Overview and guidance for the IEC 61158 series
Part 2: Physical Layer specification and service definition
Part 3: Data Link Service...
IEC 61158 3 data link service definition
... the IEC 61158 series
Part 2: Physical Layer specification and service definition
Part 3: Data Link Service definition
Part 4: Data Link Protocol specification
Part 5: Application Layer Service definition
Part ... channels 26 1
Table 122 – DL-Put primitive and parameters 26 1
Table 123 – DL-B
UFFER-SENT primitive and parameters 26 2
Table 124 – DL-B
UFFER-RE...
The network layer Addressing and routing
... 194. 12. 230.65 (01
000001) has 194. 12. 230. 126 (01 111110)
- Commercial network in 194. 12. 230. 128 /25 5 .25 5 .25 5.1 92 address range:
194. 12. 230. 129 (10 000001) has 194. 12. 230.190 (01 111 110)
- 194. 12. 230.1 92/ 255 .25 5 .25 5.1 92 ... sub-network.
- 194. 12. 230.0 /25 5 .25 5 .25 5.1 92 Administrative sub network address range: 194. 12. 230.1
(00 000001) has 194. 12. 230....