environmental biotechnology handbook of environmental engineering volume 10
... the rate of bioremediation performed by indigenous microorganisms From: Handbook of Environmental Engineering, Volume 10: Environmental Biotechnology Edited by: L. K. Wang et al., DOI: 10. 1007/978-1-60327-140-0_1 c ... PhD • Professor, Laboratory of Biochemical Engineering and Environmental Technology, Department of Chemical Engineering, University of Patras, Pa...
Ngày tải lên: 01/04/2014, 11:44
... purposes. From: Handbook of Environmental Engineering, Volume 11: Environmental Bioengineering Edited by: L. K. Wang et al., DOI: 10. 1007/978-1-60327-031-1_1 c Springer Science + Business Media, LLC 2 010 1 ... Professor Emeritus of Civil Engineering, Department of Civil Engineering, University of Patras, Patras, Greece S UDHIR KUMAR GUPTA, Ph.D. • Professor, Centre...
Ngày tải lên: 01/04/2014, 11:44
handbook of offshore engineering volume-1
... “Golden Triangle” of the Gulf of Mexico, offshore West Africa and Brazil (fig. 1.6). As of this writing, HANDBOOK OF OFFSHORE ENGINEERING SUBRATA K. CHAKRABARTI Offshore Structure ... Handbook of Offshore Engineering S. Chakrabarti (Ed.) C 2005 Elsevier Ltd. All rights resened 1 Chapter 1 Historical Development of Offshore Structures Subrata Chakraba...
Ngày tải lên: 02/04/2014, 16:05
... Associate Professor, Division of Environmental Science and Engineering, National University of Singapore, Singapore E DWARD S.K. CHAIN, PhD • Retired Professor, School of Civil and Environmental Engineering, ... Assistant Professor, Department of Environmental Engineering, King Mongkut’s University of Technology, Thonburi, Bangkok, Thailand G UPTA SUDHIR KUMAR, PhD • Profes...
Ngày tải lên: 01/04/2014, 11:43
Handbook of Mechanical Engineering Calculations P1
... from a 100 0-MW electric generating plant using 9000 tons of coal per day is 30,000 tons of CO 2 , 600 tons of SO 2 , and 80 tons of NO. A nuclear fission plant using 14.7 lb (6.67 kg) of uranium ... 70 percent of the maximum possible enthalpy rise. What is the actual heat rate of the turbine? If 10 heaters instead of 3 were used and the water enthalpy were raised to 90 perc...
Ngày tải lên: 09/11/2013, 04:15
Handbook of Mechanical Engineering Calculations P2
... website. Source: HANDBOOK OF MECHANICAL ENGINEERING CALCULATIONS 2 .10 POWER GENERATION 6 IN. (152 CM) 10 IN. (254 CM) 1 1/4 IN. (32 CM) FIGURE 6 Typical sacrificial anode consists of a flat slab of the consumable ... m 2 ) of condensing surface, a circulating-water flow rate of 10, 000 gal/ min (630.8 L/s), 3 ⁄ 4 -in (1.9-cm) no. 16 BWG tubes, a water flow rate of 7 ft/ s (2...
Ngày tải lên: 09/11/2013, 04:15
Tài liệu Handbook of Mechanical Engineering Calculations P3 pdf
... combustion and increases the weight of the products of combustion per pound (kilogram) of coal burned. Therefore, the weight of the products of combustion is the sum of the weight of the combustion products ... weight of air. The total volume of the products of combustion is the sum of the column for perfect com- bustion, step 4, and the excess-air volume, above, or 3...
Ngày tải lên: 17/12/2013, 11:15
Tài liệu Handbook of Mechanical Engineering Calculations P4 pptx
... The percent volume of CO 2 ϭ (104 / 1206.3) (100 ) ϭ 8.6; the percent H 2 O ϭ (228.7/ 1206.1) (100 ) ϭ 18.96; the percent N 2 ϭ (853/ 1206.3) (100 ) ϭ 70.7; the percent O 2 ϭ (20.6/ 1206.3) (100 ) ϭ 1.71. 3. ... M ƒ ϭ lb of moisture per lb fuel burned; M a ϭ lb of moisture per lb of dry air to furnace; C b ϭ lb of carbon burned per lb of fuel burned ϭ C ϭ RC r ; C r ϭ lb of c...
Ngày tải lên: 17/12/2013, 11:15
Tài liệu Handbook of Mechanical Engineering Calculations P5 pdf
... subject to the Terms of Use as given at the website. Source: HANDBOOK OF MECHANICAL ENGINEERING CALCULATIONS 5 .10 POWER GENERATION traction throttle flow is (SR)(kW output) ϭ 9.25 (10, 000) ϭ 92,500 ... the above calculation with this rule of thumb shows reasonably good agreement. 3. Determine the heater volume With a capacity of W lb /h of water, the volume of a direct-...
Ngày tải lên: 17/12/2013, 11:15
Tài liệu Handbook of Mechanical Engineering Calculations P6 pdf
... cost per 10, 000 Btu (10, 550 kJ) ϭ $0.0825/[(18.941/ 10, 000)(7.578)] ϭ $0.00574, or 0.574 cent per 10, 000 Btu (10, 550 kJ). For the 28 Њ API oil, cost per 10, 000 Btu ϭ $0.0 910/ [(19,157/ 10, 000)(7387)] ϭ $0.00634, ... average heat of vaporization of 100 0 Btu / lb (2330 kJ / kg) of steam, this exhaust gas flow could generate 8,880,000 /100 0 ϭ 8880 lb/h (4032 kg/h) of steam...
Ngày tải lên: 17/12/2013, 11:15