drying in the process industry

... dielectric drying. Dielectric drying (radio-frequency drying and microwave drying) is the only process in which heat is developed in the material being dried rather than having heat diffused into the ... typically contains about 8%. Cal- cining of the bicarbonate to soda and drying take place in a single indirectly heated rotary-drum calciner, with the drying prece...

Ngày tải lên: 01/04/2014, 11:18

... conservation initiatives. One of our clients in the brewing industry, have reduced overall energy consumption (WAGES) by over 300% since implementing a monitoring program in 2006. Activity – Setting ... flowmeter combined with steam computer gives you direct energy readout. Water consumption is a big issue in the brewing industry, way too much water is wasted in ineffic...

Ngày tải lên: 22/02/2014, 05:20

... ENGINEERING IN THE AUTOMOTIVE INDUSTRY 4 look at the processes as they take place in the heart of the fuel cell system, i.e. in the electrodes and electrolyte in the fuel cell stack. These processes ... info@comsol.com Web:www.comsol.com CHEMICAL ENGINEERING IN THE AUTOMOTIVE INDUSTRY 3 Fuel Cells in the Automotive Industry The design of catalyst reactors h...

Ngày tải lên: 19/10/2013, 09:15

... protects against the contamination by these objects of the food, food-contact surfaces, or food-packaging materials. (5) Maintaining gloves, if they are used in food handling, in an intact, clean, ... environment. The Good Manufacturing Practices (GMPs) deÞne the regulatory expec- tations for sanitation. For a beverage processor, the beginning step in sani- tation is the...

Ngày tải lên: 25/10/2013, 21:20

Ngày tải lên: 07/12/2013, 17:20

... between the efforts of the individual enterprise and those of the industry as a whole. • Government agencies are now recognising the value of assessing the success of their programs in terms of ... be possible for individual sectors of the industry to be compared with other sectors. In an industry where the success of the whole depends on the contribution of each p...

Ngày tải lên: 18/01/2014, 15:20

... revealed in the impact of the remaining variables. Thus, increases in ROE have a significantly greater effect 16 on the level of risk-taking behaviour in Commercial banks than in Savings banks. Indeed, ... increase therefore the risk of the Savings bank. 3·. A risk-taking model In order to identify the factors that lead to a financial institution being unable to pa...

Ngày tải lên: 16/02/2014, 06:20

... on the wax being analysed and the linearity required for the calibration curve obtained by combining the columns. For the analysis of waxes, the columns and injector should be placed in a thermostated ... Connections Inc. [I lo]. This involves spraying the SEC eluent onto the edge of a rotating germanium disc, where the solvent is removed, and then analysing th...

Ngày tải lên: 21/02/2014, 01:21

... considered during the project design phase where a monitoring plan is included in the PDD. Information pertaining to the monitor- ing plan is included in a monitoring report prior to the verifi cation ... production plant, the remaining lifetime of the old plant prior to the project will defi ne the crediting period Table 2.1 Continued 2.4 Carbon Offsetting in the C...

Ngày tải lên: 21/02/2014, 18:20

... of the gut, and it must be able to adhere to the intestinal epithelium to overcome potential hurdles, such as the low pH of the stomach, the presence of bile acids in the intestines, and the ... competition against other micro-organisms in the gastro-intestinal tract [91,92]. The tentative ways for selection of probiotics as biocontrol agents in the poultry indus...

Ngày tải lên: 08/03/2014, 09:20