SURFACE ppt

... to create. [NX8-HELP] SURFACE 2 Surface drive24ward (meslab.org/mes) 1.1. Create a surface using four points 1. Choose Insert Surface Four Point Surface to open the Surface by 4 Points dialog ... Builder Midsurface Patch Openings 1. Four Point Surface Use the Four Point Surface command to create a surface by specifying four points. This is useful for creating b...

Ngày tải lên: 19/03/2014, 12:20

... the rainy season (N GUYEN VIET PHO, 2000), surface water bodies are polluted by acid sulphate soils (L E QUANG MINH, 1996), saltwater intrudes into the surface and ground water bodies from the ... to 10 m below surface. Underneath that Holocene layer is the upper middle Pleistocene aquifer which consists of middle to coarse sand. 3. Methods For the appraisal of the surface water...

Ngày tải lên: 16/01/2014, 17:20

... maps. 22 2.4.2 Shape of generated surface One of the first aspects evaluated by the user of interpolating technique is the shape of the created surface – the surface should be smooth, local extremes ... ji t , are higher at nodes where the surface has a local extreme and lower at nodes where the surface is de- creasing / increasing. Fig. 2.2.7: Smoothing of the surface. The...

Ngày tải lên: 21/01/2014, 07:20

... second surface is greater than the z-value of the first surface, the resulting value is the average. Both mentioned operations were applied for the presented surfaces and the resulting new surfaces ... curvature of the resulting surface. Instead, it provides tools for modelling the resulting surface based on numerical tensioning and smoothing enabling to create a broad range of sur...

Ngày tải lên: 21/01/2014, 07:20

... the surface finish is produced. The quality of the surface finish, or surface roughness, affects several functional attributes of parts, such as surface friction, wear, reflectivity, heat transmission, ... a two-dimensional worst-case analysis of the slot floor surface. However, the model for the slot floor surface significantly underpredicted surface roughness values. Research by Kola...

Ngày tải lên: 23/01/2014, 01:20

... Select the to finish the surface creation. 11 The resulted surface is shown in the Figure on the left. Create another surface at the bottom by selecting Edit ... bottom edge of the surface. Pick the bottom edge of the bottle. Click the icon to finish. To create a thin solid from a surface quilt, Select the surface quilt...

Ngày tải lên: 25/01/2014, 06:24

... hydrophobic surface area upon phosphorylation by PKA (Fig. 5 C,D). Electron microscopy of phosphorylated and nonphosphorylated HSL As a first attempt to investigate whether the increase in hydrophobic surface ... study, we provide evidence that HSL gains accessible hydrophobic surface area upon PKA phos- phorylation. This gain in hydrophobic surface area presumably accounts for the inc...

Ngày tải lên: 18/02/2014, 11:20

... is present on the surface of a variety of cell lines [42,48,52,55,56] and on the surface of endothelial cells [57,58]. To address whether nucleo- lin is also present on the surface of developing ... Fig. 6F) and surface nucleolin (red) showed nucleolin patches on the surface of developing myotubes (arrows in Fig. 6F). This form of nucleolin should therefore be accessible to cell su...

Ngày tải lên: 19/02/2014, 05:20

... interac- tion with high af®nity cell surface bFGF receptors (FGFR-1 to FGFR-4) [ 10]. In addition, bFGF b inds to h eparan sulfate proteoglycans (HSPG) on the cell surface [11]. Oligosaccharidic sequences ... observed (Table 3). In conclusion, bFGF requires c ell surface HSPG for t he inhibition of steroidogenesis in developing Sertoli cells. Cell surface HSPG are bFGF targets during...

Ngày tải lên: 21/02/2014, 03:20

... causing rapid conformational changes on the surface. On the other hand, anionic surfactants such as SDS and LAS bind to the surface regions of protein, and the surface regions would be unfolded and ... altered residues causing the sensitivity of ALP I interacted with the molecular surface region, or were located on the surface of the molecule [12,13]. Twelve consensus amino acid resi...

Ngày tải lên: 21/02/2014, 03:20