what s the story of sqlt

... COMPLETED SYSSTATS_INFO DSTART 09-29-2012 11:01 SYSSTATS_INFO DSTOP 09-29-2012 11:02 SYSSTATS_INFO FLAGS SYSSTATS_MAIN CPUSPEEDNW 972.327 SYSSTATS_MAIN IOSEEKTIM 10 SYSSTATS_MAIN IOTFRSPEED 4096 SYSSTATS_MAIN ... environment This screenshot also shows the “Current System Statistics” and the top of the “Basis and Synthesized Values” section Notice, when the System Statistics collection was started It was begun ... with system statistics System Statistics System statistics are an often-neglected part of the cost-based optimizer environment If no system statistics have been collected for a system then the SQLT...

Ngày tải lên: 17/03/2014, 19:20

... Display of Assigns command to clear the display of the assigned loads Step Assign Gravity Loads - 27 Introductory Tutorial for SAP2000 Version Step Assign Area Stiffness Modifiers In this Step, ... invalidate the analysis results Step Graphically Review the Analysis Results In this Step, the analysis results will be reviewed using graphical representation of the results A Make sure that the X-Y ... is active Then click on the XZ View button to reset the view to an elevation B Click the Show Frames/Cables Forces/Stresses button, , or the Display menu > Show Forces/Stresses > Frames/Cables...

Ngày tải lên: 06/09/2012, 15:56

... Evolved Gas Analysis Simultaneous TG/MS and TG/gas chromatography (GC)/MS analysis were performed on several samples A split was used to send a fraction of the evolved gases to a quadruple mass spectrometer ... results of the component pure polymorphs In some cases, however, the assignment of component polymorphs to sample mixtures depended on the XRPD results Conclusions Interconversions of the Polymorphs ... dicarboxylate disodium salt Mixtures of Forms Using the DSC and XRPD profiles discussed above for the several pure polymorphic forms of this study, we were able to assign combinations of two or more...

Ngày tải lên: 14/02/2014, 03:20

... explanations of individual actions makes the explanations meaningless, thus useless, seen from the agent s perspective This is where TSC reappears to rescue DST —DST in other circumstances being used ... 197) DST describes the interrelations between coupled individual systems, while leaving the nature of the systems out of the description It is not what these component systems are that is important ... explanatory scope of TSC sometimes is misunderstood as stopping short at the boundaries of the physical body, leaving embeddedness out of the account However, the main unit of the analysis of cognition...

Ngày tải lên: 19/02/2014, 17:20

... hierarchy of topics Our algorithm selects what queries to issue based in part on the results of the earlier queries, thus focusing on the topics that are most representative of the database in question ... as content summaries, usually include the document frequencies of the words that appear in the database, plus perhaps other simple statistics These summaries provide sufficient information to the ... database selection algorithms did suffer when we use the (less complete) summaries that result from only inspecting snippets In the hierarchical case the precision of the FP-SVM-Snippets was 0.18...

Ngày tải lên: 23/03/2014, 16:21

... that describe the behaviour of atmosphere for a specific pollutant to be sampled may also be required What it includes: a) Selection of sampling procedures including procedures of analysis of samples ... Nm3 of any gas (measured at °C and atm pressure) equals 37.326 scf of that gas (measured at 60 °F and atm pressure) and thus Nm3 per hour of any gas equals 0.622 scf per minute of that gas kg-mol ... study It should be such that the measurable quantities are trapped in the sample at the end of the sampling It is preferable to observe sampling period consistent with the averaging times for which...

Ngày tải lên: 29/03/2014, 14:20

... combos are added SRSS type: The square root of the sum of the squares of the results from the included analysis cases and combos is computed Envelope type: Results from the included analysis cases ... types of components: Units Objects Groups Coordinate systems and grids Properties Load cases Functions Analysis cases Combinations Design settings 3-1 SAP2000 Getting Started Output and display ... different section properties associated with it: An “analysis section” used in the previous analysis, and A “design section” resulting from the current design The design section becomes the analysis section...

Ngày tải lên: 01/04/2014, 03:20

... on this document please contact Dr Vassilis Harismiadis (V.Harismiadis@hyperion.com.cy) OWNERSHIP This document, the concepts, ideas, designs and commercial offers included therein are the sole ... pressure, flow and composition as well as the valve openings and the process control system output are calculated at every point of interest Thus, the interactions between the process subunits ... System Design The process design can be relatively easily modified and troubleshot with a dynamic simulator • Technical assessment of alternative design solutions • Dynamic studies: Analysis of controllability,...

Ngày tải lên: 01/04/2014, 10:51

Ngày tải lên: 03/05/2014, 16:07

... DETAILS The experimental setup of the near-field optical lithography system consists of two subsystems as shown in Fig 1: the lithography system and the ISPI system In the lithography system, ... contact with the surface of the mask The ISPI data are recorded when the substrate is moved toward the mask as shown in Fig 7(a) It is seen that the gap decreases linearly when the substrate is moving ... Since the position of the mask is fixed, when the height of the piezoelectric stage is increased, the gap between the mask and the substrate is decreased From the experimental data, the frequency signal...

Ngày tải lên: 06/05/2014, 08:53

... this volume It also discusses some of the limitations of this proposal with the hopes of stimulating future research Finally, it includes some brief comments on some extensions of the proposals ... problems with the Headedness Parameter, it comes as no surprise that one would resurrect the Universal Base Hypothesis.3 The form of the Universal Base Hypothesis adopted here, of course, is Antisymmetry ... the basis of the prevalence of SVO and SOV patterns crosslinguistically, it comes as no surprise that the two contenders for this hypothesis are the S- H-C order (Kayne 1994, inter alia) and S- C-H...

Ngày tải lên: 30/05/2014, 22:57

... residential building may be set apart as restricted areas Sievert (Sv): The SI unit of any of the quantities expressed as dose equivalent The dose equivalent in sieverts is equal to the absorbed ... and the measurement of external radiation for the purpose of demonstrating compliance with applicable standards, assessing radiation exposures to members of the public, and assessing any impacts ... to “disintegrate” spontaneously with the emission of energy in the form of radiation The unit of radioactivity is the curie Rem: The special unit of any of the quantities expressed as dose equivalent...

Ngày tải lên: 18/06/2014, 19:20

... additional substances will be added to these lists The only time a substance can be removed from the Class II list is if it is moved to the Class I category No substances on the Class I list can ... description and the quantity of waste received, results of waste analysis testing, inspection findings, summary reports of incidents, closure and postclosure cost estimates, land disposal restriction ... toxicity Subpart D Lists of Hazardous Wastes: A solid waste is a hazardous waste if it is listed in this subpart This subpart presents tables which identify the F, K, P, and U listed waste codes that...

Ngày tải lên: 18/06/2014, 19:20

... systems are less sensitive than the HPGe system 3.3.1.4 Passive Integrating Detectors There is an additional class of instruments that consists of passive, integrating detectors and associated ... applicable Source tests consist of checking source response, geotropism, variability of readings, stability, temperature response, humidity response, and photon energy response These tests should ... parts Loose or missing screws Loose or misaligned knobs Calibration potentiometers not aligned with access holes Circuit boards not secured Loose wires Loose connectors Loose components Testing of...

Ngày tải lên: 18/06/2014, 19:20

... discussion of statistical hypothesis testing, a number of statistical hypothesis tests will be outlined Although a comprehensive discussion of hypothesis testing is beyond the scope of this book, ... collecting some small subset of all possible samples The interpretation of the results of any statistical hypothesis test is essentially the same, even though the details of conducting the test may ... Statistical Hypothesis Tests There are two basic kinds of statistical hypothesis tests: parametric and nonparametric Both types of tests have assumptions that must be met before the results of...

Ngày tải lên: 18/06/2014, 19:20

... which samples When the laboratory receives a sample shipment, it assumes custody of the samples by signing the chain -of- custody form The sample bottles in the shipment are then counted, and the ... gross alpha and gross beta/gamma measurements should be collected from the outside surfaces of the individual sample containers and the shipping container and the results recorded on the shipping ... how it was addressed; Summary of all discussions and agreements made with other team members, subcontractors, and the client; Summary of all telephone conversations; Detailed description of any...

Ngày tải lên: 18/06/2014, 19:20

... procedures This ensures the analytical process and instrumentation used to perform the analyses met all of the data quality requirements specified in the DQOs and Sampling and Analysis Plan Focus is ... methods specified in the Sampling and Analysis Plan; • Samples did not exceed the maximum analytical holding times specified in the Sampling and Analysis Plan; • Sample chain -of- custody was not ... databases More sophisticated and useful documentation is implemented by several organizations in the form of reason codes applied to the traditional qualification flags These codes express in detail...

Ngày tải lên: 18/06/2014, 19:20

... soil sampling results, and not in the original soil sampling results themselves For final status survey purposes, the statistics derived from a MARSSIM-style analysis may be as important as the ... activities Select subsets of samples were sent off site for a broader suite of analyses The characterization program was designed so that the selection of sampling locations and the evolution of the ... ENVIRONMENTS plan needs to identify each of the sources of information The obvious sources of data are results from physical samples that are collected and analyzed Less obvious but often just as important...

Ngày tải lên: 18/06/2014, 19:20

... Press LLC DATA QUALITY ASSESSMENT 307 8.4 DQA STEP 4: VERIFY THE ASSUMPTIONS OF THE STATISTICAL HYPOTHESIS TEST This step is performed to assess the validity of the statistical hypothesis test ... the reasonableness of the assumptions Table 8.3 presents a list of the statistical analyses that should be considered Table 8.3 Statistical Analyses for Verifying Assumptions Type of Test Tests ... DQA STEP 3: SELECT THE STATISTICAL HYPOTHESIS TEST This step requires the selection of the most appropriate statistical hypothesis test for drawing conclusions from the data set All statistical...

Ngày tải lên: 18/06/2014, 19:20

... tape to the surface of the equipment Remove the tape Repeat Steps and until the entire surface of the equipment has been covered Scan the surfaces of the equipment for gross alpha and gross beta/gamma ... meets radiological release limits Collect swipe samples from the areas showing the highest activity (based on the scanning measurements) to determine if equipment meets radiological release limits ... for gross alpha and gross beta/gamma activity to determine if equipment meets radiological release limits Collect swipe samples from the areas showing the highest activity (based on the scanning...

Ngày tải lên: 18/06/2014, 19:20