using the parser and sax api saxsample java

... configuration, issue the clear ip bgp * command on ISP1A Wait several seconds, and then use the show ip bgp command to view ISP1A’s BGP table Both paths should again be present in the table, but the best ... Configure BGP for normal operation Enter the appropriate BGP commands so that SanJose3 advertises its Ethernet network and the other routers advertise the 10.0.0.0 network: ISP1A(config)#router ... always-compare-med Issue the clear ip bgp * command on SanJose3, wait several seconds, and then check SanJose3’s BGP table with the command show ip bgp SanJose3 should have two paths to the 10.0.0.0 network,...

Ngày tải lên: 18/01/2014, 05:20

... Note: Make sure that the screensaver and any other programs that automatically start are temporarily disabled or they can interrupt the defragmenting process Troubleshooting If Scandisk reports a ... resolve the problem There is an option to convert recovered data to a text file However, this will clutter the drive with many text files of garbled information Select the option to discard the information ... information Select the option to discard the information and continue Reflection List any other utilities that come with Windows that can help in the preventative maintenance of a system: ...

Ngày tải lên: 24/01/2014, 19:20

Ngày tải lên: 23/03/2014, 22:21

... 'current' Furthermore, only the PTSD and depression sections of the K-SADS-PL were administered The screen interview and diagnostic supplement format is unique to the K-SADS-PL and greatly facilitates ... children and adolescents Procedures Permission to carry out the study was obtained from the Western Cape Department of Education and the Ethics Committees of the Universities of Stellenbosch and Cape ... appropriate for the sample First, using the K-SADS as the "gold" standard for a diagnosis of PTSD (a measure that identifies those individuals who have or not have a disorder), the sensitivity and specificity...

Ngày tải lên: 08/08/2014, 21:20

... organization and its related change This reinforces the fluid nature of the dimensions, the signs, and their inter-relationship – the pattern of which may vary from organization to organization and within ... utilization among the management, and organizational support [37]." Ferlie and Shortell [38], after assessing initiatives on the quality of health care in the United Kingdom and the United States ... purposively sampled (e.g., the CNO, EBP project groups and their leads, and the procedure committee) Both nursing and interdisciplinary groups will be recruited In terms of the interviews, approximately...

Ngày tải lên: 11/08/2014, 05:22

... ‘Enabling The Smart Society’  Devices in a smart society must efficiently use their available resources Eliminating the need for external components when they can be incorporated inside the MCU ... rights reserved The Solution – Data Flash & Record Management  Use data flash and existing Flash API for low level  Add layer to handle record management Virtual??? EEPROM Flash API 10 © 2012 ... Devices in a smart society must efficiently use their available resources Eliminating the need for external components when they can be incorporated inside the MCU is vital 43 © 2012 Renesas Electronics...

Ngày tải lên: 22/06/2015, 14:17

... the PC clock and set alarms and interval interrupts using the RTC b Memory demo including RAM and Data Flash (EEPROM) c Self Test – Highlights the self-test features of the RL78 and memory protection ... reading Step 1.10 Select the “Stop” button and record the multimeter current mA Stop mode stops the clocks to the CPU and peripherals but can allow the WDT and RTC to be functional ... Click the Download/Debug button on the toolbar download it to rebuild the program and Step 4.9 Click “Debug-> Go” or press F5 to RUN the program and record the current mA Notice the...

Ngày tải lên: 22/06/2015, 14:17

... side of the Wheatstone bridge, the MCU switches the multiplexer (A2) to the leg of the other side of the sensor With the voltage of the other leg of the sensor connected to the input of the amplifier, ... a reduction in the dynamic range of the system The combination of the sensor error and the capacitor error increases the requirements on the input range to the modulator configuration Hardware ... care is not taken in limiting the charge and discharge range of the device If the R/C time constant of the circuit is greater than the inverse of the sample frequency, the non-linearity of this time...

Ngày tải lên: 11/01/2016, 11:33

... DEVELOPING THE SCALE APPLICATION USING THE TC500A AND THE TC520 Input Stage The first consideration for a low signal level source is the amount of gain required for the input amplifier The TC500A ... expression for the pressure on the strain gauge (PSG), the strain gage constant (K) and the gain of the amplifier (G) The actual differential reference voltage is determined only by the ratio of ... referenced to ground Rather than using a precision reference for the TC500A and a precision supply for the strain gauge, combining eq3/a and eq3/b into eq4 produces an equation for the system: TDEINT...

Ngày tải lên: 11/01/2016, 11:39

... Figure The concept is to enable the MCP2515 CAN controller, the PIC16F876 microcontroller and the MCP3201 ADC to efficiently communicate among each other, utilizing the SPI The MCP2515 handles the ... When the value of the variable is a logic ‘0’, the PIC® device reads the pressure sensor, and when the value of the variable is a logic ‘1’, the PIC® device reads the reference A/D The microcontroller ... device on the node (such as a microcontroller) to the MCP2515 are through the SPI bus The PIC® device used on the Node Board fully supports the SPI in the Master mode Command strings are sent and received...

Ngày tải lên: 11/01/2016, 11:45

... loads the ADRES register value into the MCP2515 Transmit Buffer and Data Byte 0, and sends the RTS command If the match occurred on Filter 3, then the PIC MCU reads the TXRTSCTRL register for the ... the source of the interrupt, Timer0 or external INT pin and then branches to the appropriate code to process the interrupt Figure and Figure show the program flow for the Timer0 and CAN message ... complete, the ADRES value is loaded into the MCP2515 Transmit Buffer 0, Data Byte 0, and an RTS command is issued for Buffer The TMR0 register is then reloaded and the interrupt flag is cleared The...

Ngày tải lên: 11/01/2016, 11:45

... constants and the time the user gets using an MHz input clock Delay constants and the time that the user gets at 20 MHz and MHz input clock speeds are given in the source code listing of the full-duplex ... such that the user gets control for approximately half the time of the bit rate and the rest of the time is used up by the Operating System (and software delays) Please refer to Table for the delay ... Whereas, the transmission is totally under user control, the Reception is under the control of the Operating System As long as the user does not set the X_flag, no transmission occurs On the other hand...

Ngày tải lên: 11/01/2016, 11:47

... worth the effort The dominant error sources are covered in this section They will be covered in the same sequence they propagate through the circuit and algorithm Their impact on RH accuracy, and ... contribute to the current imbalance The common mode voltage setting resistors (RCM1 and RCM2) and the op amp (U1) dominate the VCM errors If RCM1 is 1% low and RCM2 is 1% high, then the relative ... (INTRVL) to the correct row of the table The bottom bits of CSN (CSN – ACSN, interpreted as integers between and 15) are the input to the linear interpolation formula using the coefficients for the current...

Ngày tải lên: 11/01/2016, 16:36

... a 1; in other words, the carry is simply the AND of the two addends, while the sum (excluding the carry) is if the first number is or the second number is 1, but not both: the XOR of the two addends ... example, the local bus connects the CPU with high-speed memory stored on the CPU’s motherboard (often on the CPU chip itself) The system bus connects the memory board, the CPU motherboard, and an ... starting with the Intel 8088 and progressing through the 80286, 80386, and 80486 The so-called “x86 series” became the basis for the best-selling IBM personal computers (PCs and their clones) and is...

Ngày tải lên: 15/03/2014, 02:20

... fear them because they don’t understand them or don’t know what they are To understand them, here is an analogy: Imagine a large crowd of people, and two people in the crowd are Alma and John They ... changes, and then export the project to overwrite the files You not have to import them again into Xcode Next, right-click the Parts group and import the files in the Parts folder Repeat this for the ... used by the application Expand the Targets selection near the bottom of the screen, and then expand your application and the Copy Bundle Resources listing.You can now see the resource files needed...

Ngày tải lên: 28/04/2014, 16:15

... cytokine release including TNF-α in these animals and inhibit tumor growth However, further study is needed to determine how they are induced and the mechanisms they inhibit cancer cell growth in ... treatment groups They were fed intragastrically (i.g.) daily for 14 and 28 days Tumor areas were measured every days using a caliper, and the tumor area was calculated according to the formula: tumor ... investigate the effect on tumor growth To further examine the anti-tumor mechanism, the three important biological parameters in tumorigenesis including cell proliferation and apoptosis [7], and also...

Ngày tải lên: 03/11/2012, 09:54

... and atmospheric condition The samples were taken then acidified and analyzed for residual arsenic concentration A mixture of 70% As[III] and 30% As[V] was used in all of the experiments and the ... in the values of the regression coefficient r2 Therefore, adsorption process of arsenic onto LA and AC-Fe may be described by Langmuir isotherm and the adsorption capacities were 0.48mg/g and ... for LA and AC-Fe are 0.48mg/g and 1.18mg/g, respectively) However, it is also possible to realize that the longer the portion of AC-Fe, the higher the adsorbent cost Therefore, optimizing the AC-Fe...

Ngày tải lên: 05/09/2013, 09:38

... wouldn’t be the end of the world if the receipt wasn’t dispensed Apply the rule to the other Use Cases, and you’ll find that really, none of them describe the goal of the user The goal of the user ... part of the consortium, including Hewlett-Packard, Microsoft and Oracle The UML was adopted by the OMG2 in 1997, and since then the OMG have owned and maintained the language Therefore, the UML ... Analysis and Design using the UML Chapter The Elaboration Phase In the Elaboration Phase, we are concerned with exploring the problem in detail, understanding the customer’s requirements and their...

Ngày tải lên: 10/12/2013, 14:16

... piston The product of the piston velocity and the post-yield plastic damping coefficient The product of the piston position and the factor that accounts for the accumulator stiffness and the MR ... mi is the mass of the ith floor, ¨ B is the ground acceleration and qi is the ith restoring force, including viscous damping The quantities ui are the relative displacement of the ith and the i ... easily that the stability proof of the feedback connection is exactly the same as in Theorem 13 In the following, the simplified version of Theorem 13 given in Theorem 14 is used Then the conditions...

Ngày tải lên: 12/12/2013, 22:41

... the observations=inputs and the parameter values The M-step involves system identification using the state estimates from the smoother Therefore, at the heart of the EM learning procedure is the ... outputs, and the conditional distributions over the hidden states For the model we have described, the parameters define the nonlinearities f and g, and the noise covariances Q and R (as well as the ... by picking randomly the values of the nodes that have no parents It then picks randomly the values of their children Stationarity means here that neither f nor the covariance of the noise process...

Ngày tải lên: 23/12/2013, 07:16