using the format and strategy classes alone

... They involve copying all the elements from another object into the vector The elements are copied from a Collection They can be added either at the end of the current vector or somewhere in the ... middle, where the index acts just like the one in the add() and insertElementAt() pair The order in which the vector adds the elements from the collection is the same order in which the iterator() ... Vector, and reports if the elements of the collection are a subset of the vector's elements In other words, is each element of the collection also an element of the vector? The vector can contain other...

Ngày tải lên: 05/10/2013, 12:20

... configuration, issue the clear ip bgp * command on ISP1A Wait several seconds, and then use the show ip bgp command to view ISP1A’s BGP table Both paths should again be present in the table, but the best ... Configure BGP for normal operation Enter the appropriate BGP commands so that SanJose3 advertises its Ethernet network and the other routers advertise the 10.0.0.0 network: ISP1A(config)#router ... always-compare-med Issue the clear ip bgp * command on SanJose3, wait several seconds, and then check SanJose3’s BGP table with the command show ip bgp SanJose3 should have two paths to the 10.0.0.0 network,...

Ngày tải lên: 18/01/2014, 05:20

... resolve the problem There is an option to convert recovered data to a text file However, this will clutter the drive with many text files of garbled information Select the option to discard the information ... Note: Make sure that the screensaver and any other programs that automatically start are temporarily disabled or they can interrupt the defragmenting process Troubleshooting If Scandisk reports a ... information Select the option to discard the information and continue Reflection List any other utilities that come with Windows that can help in the preventative maintenance of a system: ...

Ngày tải lên: 24/01/2014, 19:20

... interests of other actors and what they to realise them?’ If issues concern the Netherlands alone, they come under ‘Narrow interests’ on the left-hand side The more the Netherlands shares such ... for the Netherlands? What are the interests of other actors and what they to realise them? Where can the Netherlands make a difference? 44 attached to the world Questions and are in line with the ... to the Netherlands and the interests of Dutch citizens; where there are the most substantial interfaces between global public goods and the Dutch interests; and how and how much the Netherlands...

Ngày tải lên: 22/03/2014, 15:20

... 'current' Furthermore, only the PTSD and depression sections of the K-SADS-PL were administered The screen interview and diagnostic supplement format is unique to the K-SADS-PL and greatly facilitates ... placing a cap on the level of agreement General Implications of Findings The K-SADS and CATS yield different information about the level and type of trauma exposure, therefore researchers and clinicians ... appropriate for the sample First, using the K-SADS as the "gold" standard for a diagnosis of PTSD (a measure that identifies those individuals who have or not have a disorder), the sensitivity and specificity...

Ngày tải lên: 08/08/2014, 21:20

... organization and its related change This reinforces the fluid nature of the dimensions, the signs, and their inter-relationship – the pattern of which may vary from organization to organization and within ... utilization among the management, and organizational support [37]." Ferlie and Shortell [38], after assessing initiatives on the quality of health care in the United Kingdom and the United States ... participants (for interviews) and groups (for observations) will be purposively sampled (e.g., the CNO, EBP project groups and their leads, and the procedure committee) Both nursing and interdisciplinary...

Ngày tải lên: 11/08/2014, 05:22

... side of the Wheatstone bridge, the MCU switches the multiplexer (A2) to the leg of the other side of the sensor With the voltage of the other leg of the sensor connected to the input of the amplifier, ... a reduction in the dynamic range of the system The combination of the sensor error and the capacitor error increases the requirements on the input range to the modulator configuration Hardware ... care is not taken in limiting the charge and discharge range of the device If the R/C time constant of the circuit is greater than the inverse of the sample frequency, the non-linearity of this time...

Ngày tải lên: 11/01/2016, 11:33

... DEVELOPING THE SCALE APPLICATION USING THE TC500A AND THE TC520 Input Stage The first consideration for a low signal level source is the amount of gain required for the input amplifier The TC500A ... expression for the pressure on the strain gauge (PSG), the strain gage constant (K) and the gain of the amplifier (G) The actual differential reference voltage is determined only by the ratio of ... referenced to ground Rather than using a precision reference for the TC500A and a precision supply for the strain gauge, combining eq3/a and eq3/b into eq4 produces an equation for the system: TDEINT...

Ngày tải lên: 11/01/2016, 11:39

... Figure The concept is to enable the MCP2515 CAN controller, the PIC16F876 microcontroller and the MCP3201 ADC to efficiently communicate among each other, utilizing the SPI The MCP2515 handles the ... OVERVIEW The MCP2515 CAN controller is the heart of the CAN interface It handles all of the transmitting and receiving of message packets that contain useful information for other nodes on the network ... When the value of the variable is a logic ‘0’, the PIC® device reads the pressure sensor, and when the value of the variable is a logic ‘1’, the PIC® device reads the reference A/D The microcontroller...

Ngày tải lên: 11/01/2016, 11:45

... loads the ADRES register value into the MCP2515 Transmit Buffer and Data Byte 0, and sends the RTS command If the match occurred on Filter 3, then the PIC MCU reads the TXRTSCTRL register for the ... top of the PIC ROM memory During the MCP2515 initialization, the values are sequentially read by the table read function and then written to the MCP2515, via the SPI interface TIMER0 MODULE The ... the source of the interrupt, Timer0 or external INT pin and then branches to the appropriate code to process the interrupt Figure and Figure show the program flow for the Timer0 and CAN message...

Ngày tải lên: 11/01/2016, 11:45

... constants and the time the user gets using an MHz input clock Delay constants and the time that the user gets at 20 MHz and MHz input clock speeds are given in the source code listing of the full-duplex ... such that the user gets control for approximately half the time of the bit rate and the rest of the time is used up by the Operating System (and software delays) Please refer to Table for the delay ... Whereas, the transmission is totally under user control, the Reception is under the control of the Operating System As long as the user does not set the X_flag, no transmission occurs On the other hand...

Ngày tải lên: 11/01/2016, 11:47

... worth the effort The dominant error sources are covered in this section They will be covered in the same sequence they propagate through the circuit and algorithm Their impact on RH accuracy, and ... contribute to the current imbalance The common mode voltage setting resistors (RCM1 and RCM2) and the op amp (U1) dominate the VCM errors If RCM1 is 1% low and RCM2 is 1% high, then the relative ... (INTRVL) to the correct row of the table The bottom bits of CSN (CSN – ACSN, interpreted as integers between and 15) are the input to the linear interpolation formula using the coefficients for the current...

Ngày tải lên: 11/01/2016, 16:36

... cytokine release including TNF-α in these animals and inhibit tumor growth However, further study is needed to determine how they are induced and the mechanisms they inhibit cancer cell growth in ... treatment groups They were fed intragastrically (i.g.) daily for 14 and 28 days Tumor areas were measured every days using a caliper, and the tumor area was calculated according to the formula: tumor ... investigate the effect on tumor growth To further examine the anti-tumor mechanism, the three important biological parameters in tumorigenesis including cell proliferation and apoptosis [7], and also...

Ngày tải lên: 03/11/2012, 09:54

... and atmospheric condition The samples were taken then acidified and analyzed for residual arsenic concentration A mixture of 70% As[III] and 30% As[V] was used in all of the experiments and the ... in the values of the regression coefficient r2 Therefore, adsorption process of arsenic onto LA and AC-Fe may be described by Langmuir isotherm and the adsorption capacities were 0.48mg/g and ... for LA and AC-Fe are 0.48mg/g and 1.18mg/g, respectively) However, it is also possible to realize that the longer the portion of AC-Fe, the higher the adsorbent cost Therefore, optimizing the AC-Fe...

Ngày tải lên: 05/09/2013, 09:38

... by key, these methods essentially say, "Don't bother using a key to look up the value Instead, look at all the values and tell me if this specific value is among them." In other words, the system ... properties The load() and store() methods not close() the stream for you While the load() method will read in the format that store() saves the data in, it also understands several other styles ... System.out.println(args[i] + " : " + digest); } } } The bulk of the work in the program reads in the input files and formats the output When run against itself, the program generates the following output: CRCTest.java...

Ngày tải lên: 05/10/2013, 12:20

... wouldn’t be the end of the world if the receipt wasn’t dispensed Apply the rule to the other Use Cases, and you’ll find that really, none of them describe the goal of the user The goal of the user ... part of the consortium, including Hewlett-Packard, Microsoft and Oracle The UML was adopted by the OMG2 in 1997, and since then the OMG have owned and maintained the language Therefore, the UML ... and Design using the UML Chapter An Overview of the UML Before we begin to look at the theory of the UML, we are going to take a very brief run through some of the major concepts of the UML The...

Ngày tải lên: 10/12/2013, 14:16

... piston The product of the piston velocity and the post-yield plastic damping coefficient The product of the piston position and the factor that accounts for the accumulator stiffness and the MR ... mi is the mass of the ith floor, ¨ B is the ground acceleration and qi is the ith restoring force, including viscous damping The quantities ui are the relative displacement of the ith and the i ... easily that the stability proof of the feedback connection is exactly the same as in Theorem 13 In the following, the simplified version of Theorem 13 given in Theorem 14 is used Then the conditions...

Ngày tải lên: 12/12/2013, 22:41

... the observations=inputs and the parameter values The M-step involves system identification using the state estimates from the smoother Therefore, at the heart of the EM learning procedure is the ... outputs, and the conditional distributions over the hidden states For the model we have described, the parameters define the nonlinearities f and g, and the noise covariances Q and R (as well as the ... by picking randomly the values of the nodes that have no parents It then picks randomly the values of their children Stationarity means here that neither f nor the covariance of the noise process...

Ngày tải lên: 23/12/2013, 07:16

... the data row, and thus the dataset In short, the data row holds the original state of the Customers row, whereas the class-level variables hold the current state At the moment, the ReadValuesFromDataRow ... to add code to the click event of the Retrieve button to use the constructor, as well as a method that copies the values of the object to the form's text boxes Listing 9.25 shows the code behind ... class, or you could have the CCustomer class "inherit" all of the code in the CCustomerData class You've probably done the former before, so try the latter In the declaration of the CCustomer class,...

Ngày tải lên: 24/12/2013, 06:17

... another of the thousands of IRC channels.) IRC ops, on the other January 2002 13:14 126 Chapter 6: Using the Internet and Other Networks hand, are technical people in charge of the servers themselves; ... happening on the server and the channel; the bottom part (a single line) is where you type commands and text In between the two parts is a status line with the time of day, your nick, and other information ... Chapter 6: Using the Internet and Other Networks Here’s the syntax: talk user name@hostname If the other user is logged onto the same computer as you, omit the @hostname After you run that command,...

Ngày tải lên: 17/01/2014, 16:20