using the cisco discovery protocol cdp

... should have the stream activated on the client before executing these commands This will give you the full effect of the troubleshooting information a Show the CAM entries in the DLSwitch The content ... * Note: Verify using DLRouter#show run d Assign the PortChannel to the Gigabit interfaces channeling to the switch This is required for the VLANs to establish communication to the Switch We are ... IGP routing protocols EIGRP and OSPF are of course very popular In this lab we will be using the EIGRP routing protocol This is fairly subjective Setting it to EIGRP will ensure that Cisco devices...

Ngày tải lên: 21/12/2013, 19:15

... Verify using DLRouter#show run f Set the PIM Rendezvous Point (RP) address The path to every receiver in the multicast group from the RP is the shortest path tree Assume the RP is the receiver of the ... Verify using Branch#show run e Set the PIM Rendezvous Point (RP) address The path to every receiver in the multicast group from the RP is the shortest path tree Assume the RP is the receiver of the ... Verify using CORP#show run Configure the Branch router with the following information: a Configure the hostname Branch on the external 2600 Router(config)#hostname Branch * Note: Verify using...

Ngày tải lên: 21/12/2013, 19:15

... how the theoretical methods were translated into practical strategies and how these relate to the levels of the intervention Furthermore, Table shows how the focus group results informed the ... modules at the level of the community, the schools (including kindergartens and primary schools) and the family An overview of the intervention at these levels and the related modules and their respective ... form to the main coordination centre In the months before the start of the intervention, all centres organised local training(s) for the research staff being responsible for the adoption of the IDEFICS...

Ngày tải lên: 14/08/2014, 08:20

... Incomplete) If the origin codes are the same, prefer the path with the lowest MED attribute If the paths have the same MED, prefer the external path over the internal path If the paths are still the same, ... the update Prefer the path with the largest weight If the weights are the same, prefer the path with the largest local preference If the local preferences are the same, prefer the path that was ... to Set the Weight Attribute Using a Route Map to Set the Weight Attribute Using the neighbor weight Command to Set the Weight Attribute Using an Access List to Set the Weight Attribute The following...

Ngày tải lên: 16/11/2014, 19:49

... structure exists in the sentence labels, the document collection was randomly split into training and test sets The automaton produced by MDI was learned using the training data, and the probability ... and the randomly generated sequences are shown in Figure The test and random sequences are sorted by probability The vertical axis shows the rank in each sequence and the horizontal axis shows the ... calculated using the kappa statistic that was first proposed by (Cohen, 1960) This measure calculates and removes from the agreement rate the amount of agreement expected by chance Therefore, the results...

Ngày tải lên: 20/02/2014, 12:20

... 172.16.1.63 for the company to use The network manager has decided to use 172.16.1.1 for the inside interface on the Internet router and 172.16.1.2 for the outside interface on the PIX You are then left ... through 172.16.1.62 Cisco − Using NAT and PAT Statements on the Cisco Secure PIX Firewall If you have the output of a write terminal command from your Cisco device, you can use the Output Interpreter ... Telnet, and must convert all of the internal addresses, which Cisco − Using NAT and PAT Statements on the Cisco Secure PIX Firewall are in the 10.0.0.0/8 range The network manager can this with:...

Ngày tải lên: 05/07/2014, 23:50

... per EBP: Integrated into the everyday work of the clinical setting, in the policies, in the practices, in documentation, in the infrastructure, etc • Normalization: It is the routine occurrence ... recipe by which these common factors come together to create success [17,51] Given the differential views available regarding the meaning of each of the three overarching dimensions of the framework ... the summarized findings will be used to assess each of the three RU/EBP models as to their degree of inclusiveness of key contextual elements identified by the case study These results will then...

Ngày tải lên: 11/08/2014, 05:22

... part of the same domain where the service components reside The second category of front-end consumers is the external Web service clients and other services, shown at the top of the diagram These ... essential to understanding the material in the second half of the book The remaining chapters of the book cover all of the WS-Specifications that are implemented by WSE 2.0 Finally, the book closes with ... guarantees They are what they are, and you simply use them But what happens if the type definition gets out of sync with the component it is supposed to describe? This happens all the time in the COM+...

Ngày tải lên: 20/08/2012, 13:59

... to the others For example, the flow from University to Industry and vice versa Therefore, these flows become the main factor in the individual model and are considered as the third level The ... structural The former is the familiar contextual dependence of elements on other elements in performing their function, whereas the later is the dependence of the priority of elements on the priority ... from the top with the goal having the greatest influence of importance The AHP model formulation process starts both from bottom (the alternatives) and from the top (the objective, goal) or the...

Ngày tải lên: 23/04/2013, 10:29

... that the organic matter for the rest of the soil profile (the third layer to the eighth layer) were half of the previous layer We did not have field measurements for the microbial pools; therefore ... load into the RBS and the runoff depth from the cornfield increased the atrazine mass loss in runoff leaving the RBS increased (Table 4) Atrazine mass in runoff leaving the RBS were in the range ... concentrations in the seepage under the RBS were many orders of magnitude below 1-µg L-1 This may be due to the fact that there was no residual atrazine in the RBS soil profile at the beginning of the simulation...

Ngày tải lên: 05/09/2013, 09:08

... is also possible to realize that the longer the portion of AC-Fe, the higher the adsorbent cost Therefore, optimizing the AC-Fe portion in the column is one of the key factors for a feasible arsenic ... ratio, the value of V/WACFe (V, the volume of drinkable water produced from the start using adsorbents until breakthrough / WACFe, the weight of AC-Fe in the column) was calculated and found that the ... solute (arsenic anions) in the bed is decreased resulting to shorter contact between the feed and the adsorbent In addition, the higher the flow rate, the smaller the film resistance, implying...

Ngày tải lên: 05/09/2013, 09:38

Ngày tải lên: 21/09/2013, 05:29

... Check whether the file has the set-group-id bit set -h file Check whether the file is a symbolic link (same as –L) -k file Check whether the file has the sticky bit set -L file Check whether the file ... displays only the path to the man page (the second element on the line) Using backticks, you can execute one section of a command line first and feed the output of that command to the rest of the command ... bash` The first command line in the preceding example finds the full path of the ps command and finds the package that contains that ps command The second command line finds the full path to the...

Ngày tải lên: 29/09/2013, 22:20

... text at the end of the line Insert text before the cursor Insert text at the beginning of the line Open a new line below the cursor Open a new line above the cursor Positioning Commands The following ... list the vi editor’s editing and positioning commands, which are used to make changes The vi editor is case sensitive, so use the specified case when using the editing and positioning commands The ... end-of-line characters The set command is used from last-line mode to control these options These options can also be placed in a file the user creates in their home directory called exrc The set options...

Ngày tải lên: 02/10/2013, 09:20

... icons appear on the map These icons are called pushpins, and they simply enumerate the search results while showing their location on the map You’ll see how to implement them in the Using Pushpins” ... you can also set the zoom level of a map by using the SetZoomLevel accessor method of the VEMap control Using the following method call for the map, you will see the map of the world as shown ... top The PanXY JavaScript function you saw in the preceding code segment reads the X and Y coordinates from the text boxes on the page and pans the map accordingly using the Pan method of the...

Ngày tải lên: 05/10/2013, 10:20

... when you click on the arrows of the Calendar control Of course, you can further enhance the appearance of the control by using CSS and assigning it to the CssClass property of the Calendar control ... SuppressPostBack="true" /> The first panel (Panel2) is essentially the header where the image to expand/collapse the panel is located The majority of the actual content is in the second panel In this case, the content ... button next to the text box as the agent to open the calendar, all you have to is set the PopupButtonID property of this control to the ID of the button CascadingDropDown Control The CascadingDropDown...

Ngày tải lên: 05/10/2013, 10:20

... defined, the pop-up panel by default launches in the center of the screen Also the Panel3 control is used to define the header of the main panel as a section where the user can drag and drop the panel ... Although the CAPTCHA controls can offer somewhat better security, they also have the downside of causing extra inconvenience for the users Not only they require additional input from the user, but they ... control the appearance of the lower-right drag handle for the resize Furthermore, using the OnClientResize property, you can write a client-side JavaScript function to modify the behavior of the...

Ngày tải lên: 05/10/2013, 10:20

... Campus Management Using the ADC StarGazer EMS StarGazer for Campus 7.0 Supported Products Network Product Minimum Version CMU-710 4.4 CMU-810 5.0G The following table lists the Campus Line Cards ... c o m • + - - - 8 • - 0 - 6 - StarGazer EMS Campus Management Using the ADC StarGazer EMS StarGazer Ordering Information To obtain the necessary products for installing one StarGazer server, you ... License and one SGMEDIA8.3, which comprises the installation CDs and user documentation You can order SGMEDIA8.3 and the StarGazer NetworkProduct License(s) at the same time or at different times, but...

Ngày tải lên: 16/10/2013, 14:15

... to restore the settings, copy the file to your hard drive, open the wizard, and choose Restore Previously Saved Settings to This Machine Browse to the file you created earlier and run the wizard ... that you install the same Outlook add-ins that you had on the computer that you saved the settings from If not, you'll receive errors mentioning missing files when you start Outlook The File and ... Wizard can move your Outlook files, including the *.PST and other files The Office Save My Settings Wizard saves only settings—you have to save the files yourself [ Team LiB ] ...

Ngày tải lên: 17/10/2013, 18:15

... IV of the book and include the full-blown application examples from Part V of the book In a few instances, numbered listings in the book may be too small to have their own listing files on the CD-ROM ... File menu (the Open Page in Navigator choice in the Macintosh version) and use the file dialog box to locate the file named lst19-01.htm inside the Chap19 directory To examine and modify the HTML ... with the help of the Adobe Acrobat Reader, included with the CD-ROM The file NS4_Obj.pdf contains this illustration in pdf format Start Acrobat Reader on your computer, and open the file from either...

Ngày tải lên: 18/10/2013, 18:15