using static members and the self keyword

... generated by the command \tetrahedral The macros \rtrigonal and \ltrigonal are used to draw right-handed and left-handed trigonal units, respectively For instance, the commands below output the pictures ... simplify the example and the comprehension of the analysis, the authors present in the qualia structures just the elements that are essential to explain the parsing process Throughout the analysis, the ... in the example above, the disambiguation function f that treats the input name retrieves as lexical items the locants 4, 3, and 1, the radicals methyl and ethyl, the carbon chain pent and the...

Ngày tải lên: 05/03/2014, 20:20

... hips and knees extended One strip of plaster of Paris bandage (Gypsona ® ) was then applied to the rearfoot and one to the forefoot The foot was then placed in subtalar joint neutral position, the ... derived from the summer studentship programme Authors’ contributions MC and KR designed the study MC and MAE collected and inputted the data MC and KR conducted the statistical analysis MC and MAE, ... definition [8] Standard error of the measurement (SEM) calculations were undertaken to assess the difference between the actual measured score across the casts and digital images and the estimated...

Ngày tải lên: 10/08/2014, 21:24

... the right latissimus dorsi, the left trapezius, the left quadratus lumborum, and the left rhomboid muscles Standing anteroposterior and lateral cervical and lumbar radiographs were obtained and ... Intervention and outcome The initial weeks of care consisted of manipulative and rehabilitative therapy designed to improve the static align- http://www.chiroandosteo.com/content/14/1/1 ment of the sagittal ... take place The goals of the chair are to promote lumbar stability, muscular coordination, and increase flexibility However, the benefits of the chair itself remain to be investigated The Wobble...

Ngày tải lên: 13/08/2014, 14:20

... of the Write Enable command Chip Select is brought low (active) and the opcode is sent out through the SPI port The Write Enable command must be given before a write is attempted to either the ... to either the STATUS register or the array Figure shows an example of the Read Status Register command to check for the WEL bit The WEL bit must be set before a write is attempted to either the ... COMMAND (OPCODE, ADDRESS AND DATA) Figure shows an example of the Write command For this, the device is selected and the opcode, 0x02, is sent The High Address byte is given 0x00, followed by the...

Ngày tải lên: 11/01/2016, 16:37

... 7, while the instructions in the first FP are in the first execution phase E1 (which may be the only one), the instructions in the second FP are in the decoding phase, the instructions in the third ... to AMR The two move instructions MVK and MVKLH (using the S unit) move 0x0004 into the 16 LSBs of register B2 and 0x0005 into the 16 MSBs of B2 The MVC (move constant) instruction is the only ... instruction that can access the AMR and the other control registers (shown in Appendix B) and executes only on the B side in conjunction with the functional units and registers on the side B A 32-bit...

Ngày tải lên: 17/10/2013, 19:15

... the order of the lter The larger the value of Q, the higher the order of the FIR lter and the better the approximation in (4.32) of the desired transfer function The truncation of the innite series ... in memory with the newest sample at the beginning of the buffer and the oldest sample at the end of the buffer The convolution starts with the newest sample and the rst coefcient using y(n) = h(0)x(n) ... updated, by using the index i < N The second method (method B) performs the convolution and updates the delay samples using one loop The convolution starts with the oldest coefcient and the oldest...

Ngày tải lên: 24/10/2013, 09:15

... inside the unit circle in the z-plane The right region in the s-plane, corresponding to s > 0, maps outside the unit circle in the z-plane The imaginary jw axis in the s-plane maps on the unit ... However, for the other stages, the input x(n) is the output y(n) of the preceding stage The coefficients b[i][0] and b[i][1] correspond to b1 and b2, respectively; where i represents each stage The delays ... H(z) using the BLT equation (5.24), or H (z) = H ( s w A ) s =( z -1) ( z +1) (5.30) In the case of bandpass and bandstop filters with lower and upper cutoff frequencies wD1 and wD2, the two analog...

Ngày tải lên: 28/10/2013, 16:15

... placing their good hand under the middle of the tray and lifting But anosognosics attempted to lift it by placing their right hand on the right side of the tray and lifting, despite the fact that the ... the truth The formerly self- deceived themselves sometimes make this kind of claim, saying they ‘‘really knew all along’’ the truth concerning which they deceived themselves Many theories of self- deception ... However, when they were asked which house they would prefer to live in, they picked the other – non-burning – house Even though the houses looked identical to them, they preferred one to the other.2...

Ngày tải lên: 01/11/2013, 09:20

... the results: Select View Æ Watch Window and insert the two expressions j and out (right click on the Watch window) Click on +out to expand and view out[0] and out[1] that represent the real and ... function, used with the C31 DSK and the C30 EVM, is listed and described in Refs 13 and 14 The twiddle constants are generated within the program The imaginary components of the input data are ... 64, represented by six bits, the first and sixth bits, the second and fifth bits, and the third and fourth bits are swapped Several examples in this chapter illustrate the FFT algorithm, incorporating...

Ngày tải lên: 07/11/2013, 10:15

... (Continued) (the wideband signal desired) As a result, the samples of the interference are highly correlated On the other hand, the samples of the wideband signal are relatively uncorrelated The characteristics ... bit rate of kHz The wideband random sequence generated (with the file wbsignal.h) represents the signal desired The narrowband interference is an external signal The bandwidth of the interference ... fixed unknown FIR bandpass filter A pseudorandom noise sequence is generated within the program (see Examples 2.16 and 4.4) and becomes the input to both the fixed (unknown) and the adaptive FIR...

Ngày tải lên: 07/11/2013, 10:15

... calculated within the loop Outside the loop, the final summation of the even and odd terms is obtained For a floating-point implementation, the function and the variables sum, suml, and sumh in Figure ... increments the pointer to the next 32-bit word The load, multiply, and branch instructions must use the D, M, and S units, respectively; the add and subtract instructions can use any unit (except M) The ... instructions MPY and MPYH, respectively Whereas the even and odd sum of products are calculated within the loop, the final summation is taken outside the loop and returned to the calling function...

Ngày tải lên: 14/12/2013, 14:15

... and separates it into a low band and a high band The filter coefficients represent a 4-kHz lowpass filter The sampled signal is separated into odd and even samples, with the effect of aliasing the ... sent to the function that selects the frequency with the highest amplitude, corresponding to the upper bits of the sampled data The process is repeated for the lower bits of the sampled data The ... than the other, the signal received by the more-distant microphone is delayed in time This time shift corresponds to the angle where the source is located and the relative distance between the...

Ngày tải lên: 14/12/2013, 14:15

... registers The C67xx (such as the C6701 and C6711) belong to the family of the C6x floating-point processors; whereas the C62xx and C64xx belong to the family of the C6x fixed-point processors The C6711 ... press the toolbar with the three down arrows This compiles and assembles all the C files using cl6x and assembles the assembly file vectors_11.asm using asm6x The resulting object files are then ... Open the two C source files C6xdskinit.c and sine8_intr.c Open (to add to project) one file at a time; or place the cursor to one of these files, then to the other while holding the Shift key, and...

Ngày tải lên: 26/01/2014, 07:20

... Verify that the output consists of the 2-kHz carrier signal and two sideband signals The sideband signals are at the frequency of the carrier signal + or - the frequency of the sideband signal, ... at 1600 and 2400 Hz Load the GEL file AM.gel, increase the variable amp, and verify the baseband signal being modulated Note that the product of the carrier and baseband signals (within the output ... Note that due to the 16-bit codec, the valid input data to the codec are between -215 and (215 - 1) or between -32,768 and 32,767 Change the values in the first half of the table using 0x8000 =...

Ngày tải lên: 26/01/2014, 07:20

... removal of the CUB domains and thereby activation of the growth factor domains PDGF-C and -D contain both the CUB and growth factor domains when they are secreted and proteolytic cleavage is therefore ... of the proposed PDGF-C model [57] displaying the twisted b-sheets and the N-terminal a-helix of the PDGF-C monomer (A) and the PDGF-CC dimer (B) The N-terminal (N) and C-terminal (C) ends for the ... the cytoplasm and nucleus, a feature also described for PDGF-B [31,32] The function of these two PDGFs in the nucleus is unclear The region N-terminal of the CUB domain in PDGF-C and PDGF-D The...

Ngày tải lên: 19/02/2014, 07:20

... statement, and they share with the Research and Policy Committee the privilege of submitting individual comments for publication The recommendations presented herein are those of the trustee members ... of the Research and Policy Committee and the responsible subcommittee They are not necessarily endorsed by other trustees or by nontrustee subcommittee members, advisors, contributors, staff members, ... Furthermore, states should welcome a diverse set of providers that meet quality standards and the needs of the parents and communities they serve Business leaders should advocate preschool and...

Ngày tải lên: 20/02/2014, 20:20

... enormous attention The present study demonstrates the utility and limitations of PCR Among the total of 144 specimens studied, the sensitivity of smear, culture and PCR was 51%, 68% and 91.5% respectively ... like to thank Dr A K Chakraborty and the anonymous reviewers for comments and suggestions on the manuscript, Dr N S Deodhar for comments and suggestion on the work and Drs Anil Ravetkar, former ... microscopy and culture Table presents the comparative efficiency of PCR to diagnostics like microscopy and culture The sensitivity, specificity, positive and negative predictive values for each of the...

Ngày tải lên: 06/03/2014, 04:20

... Rotterdam, the Erasmus University Rotterdam, the Netherlands Organization for Health Research and Development (ZonMw), the Netherlands Organisation for Scientific Research (NWO), the Ministry ... at these stations are considered as the sum of the background concentration and the contribution from local emission sources We modelled the contribution of local emission sources to the PM10 and ... PM10 and NO2 in our cohort, because these pollutants have been routinely measured in the National Air Quality Monitoring Network during the study period, and they often exceed the air quality standards...

Ngày tải lên: 06/03/2014, 19:20

... supply and demand), and it is necessary to understand these changes, how the people themselves perceive these changes and how they have adapted their livelihood strategies in response to these ... information to the map Approaching the Topic Desk research was undertaken prior to the start of the fieldwork to gain an understanding of the fisheries sectors and the key issues involved In the India ... their livelihoods, and thus differing reasons for their vulnerability G G G the institutions, policies and organizations that determine their access to assets/ opportunities and the returns they...

Ngày tải lên: 07/03/2014, 00:20

... important One of these, the TRP sequence, includes the start of the C-terminal helix as well as the structured loop between the 1440 ATPase domain and the C-terminal helix and in the 3D structure ... Furthermore the TRP sequence is positioned very close to the ATP-binding pocket in the adjacent subunit Thus the TRP sequence at the beginning of the C-terminal helix and the RDF sequence at the ... sequence in modulating the function of the SRH The C-terminal region of human VPS4B contains the b domain (b strands and 8), the final helix of the AAA domain (a helix 10) and the C-terminal helix...

Ngày tải lên: 07/03/2014, 05:20