using shaded curvature analysis for surfaces

... bench press for 25 at room temperature The polymerization cycle that carried out using water bath at boiling temperature was then switched off and left for 15 It was then boiled again for 20 and ... procedure previously described HPLC Analysis for Evaluation 130 by Ohyama and Imai.5 The calculation content of MMA (x) in g was calculated using the following formula: (MMA) X = (Pvz x nst x Cst ... g sample of PMMA for heat-cure denture base material 10 Min Figure 2: Residual MMA diagram collected from g sample of PMMA for self-cure denture base material HPLC Analysis for Evaluation 132...

Ngày tải lên: 07/08/2014, 14:20

... 2.1. Framework for multi‐criteria analysis   Any  decision  problem  can  be  structured  into  three  major  phases:  intelligence  which  examines  the  existence  of  a  problem  or  the  opportunity  for ... relevant  to  the  decision problem and measures for achieving  those objectives.   2.5. Criterion weights   Fig. 3. Framework for multi‐criteria analysis.   2.2. Problem definition   A  decision  ... scores  for each  of  the alternatives and choose the most suitable  measures for the objectives and conditions of  the  study.  Two  factors  used  to  determine  these scores are scores for the measures with ...

Ngày tải lên: 22/03/2014, 12:20

... frequency analysis was performed on a waveform composed of four sinusoidal waves (see Table 1) Figure 11 shows the resulting waveform, and Figure 12 shows the frequency spectra of this waveform as ... depending on the analysis method Consequently, we calculated the suitable values for each signal waveform and compared the analysis methods with the most suitable segmental SNR For the case of ... Terada., et al, Non-stationary waveform analysis and synthesis using generalized harmonic analysis, in IEEE-SP International Symposium on TimeFrequency and Time-Scale Analysis, pp 429–432 (1994) 18...

Ngày tải lên: 20/06/2014, 22:20

... into array CGH analysis using a robust HMM,” Bioinformatics, vol 22, no 14, pp e431–e439, 2006 [15] T Yu, H Ye, W Sun et al., “A forward-backward fragment assembling algorithm for the identification ... array analysis, ” Cancer Research, vol 65, no 13, pp 5561–5570, 2005 [10] F Picard, S Robin, M Lavielle, C Vaisse, and J.-J Daudin, “A statistical approach for array CGH data analysis, ” BMC Bioinformatics, ... an improved Bayesian regression method for data that are noisy observations of a piecewise constant function and used this method for CNV analysis We have formulated the problem as a statistical...

Ngày tải lên: 21/06/2014, 11:20

... the matrix S Find the Fisher information matrix associated with this matrix as in (6) Calculate the determinant for the Gram matrix for each sensor using (12) for all sensors This is done by ... diagnosis for auto body assembly using pattern recognition,” Journal of Engineering for Industry, vol 118, pp 55–66, 1996 [11] D C Kammer, “Optimal sensor placement for modal identification using ... system model, and the problem formulation for optimum placement is presented in Section The sensitivity analysis is derived in Section The computational procedure for the optimal sensor placement...

Ngày tải lên: 22/06/2014, 19:20

... for 1024-bit string enables a per-symbol formulation for D p and results in a conservative approximation for R log2 (R) over the likely range of R The per-symbol descriptive cost can now be formulated: ... the GY-box motif (UGUCUUCCAU) is a target site for miR-7 itself entered this second analysis, which was performed independently of the multisequence analysis described in the paragraph above The ... the shortest prefix encoding for the length phrase In this way we achieve both a practical method for spelling out the model for implementation and an online method for determining model costs...

Ngày tải lên: 22/06/2014, 19:20

... be delivered for T2 tumor Therefore, more works needs to be done in future clinical study to explore the optimal doses should be delivered for tumors of different size Based on the analysis of ... new lesions that developed for weeks Patients whose disease did not meet the criteria for either a PR or progressive disease were classified as having stable disease for weeks Overall efficacy ... 0.000) The 1- and 2-year local control rates were 75% and 60% for tumor ≤3 cm; 84% and 71% for tumor sized 3~5 cm; 55% and 14.6% for tumor sized 5~7 cm; and 45%, 21% in those with tumor size...

Ngày tải lên: 09/08/2014, 09:20

... prepared for linkage analysis in the same way, using annotation files for the appropriate array The two Perl scripts used to extract genotypes from VCF files and format them for linkage analysis ... SAMtools produces a variant call format (VCF) file, from which we extracted genotypes using a Perl script These genotypes were formatted for linkage analysis using a modified version of the Perl ... genetic map positions required for linkage analysis We adapted our existing software [35] to extract HapMap Phase II SNP genotypes from WES data and format them for linkage analysis We anticipated two...

Ngày tải lên: 09/08/2014, 23:20

... Thus we should avoid any analysis that can confuse longer survival with better morality The Proportional Hazards model estimated using the methods of Fine and Grey or by using standard software ... Such an analysis would be seriously misleading An example of such an analysis is [7], which showed a highly significant difference in survival with a much more modest significance level for a comparison ... mortality The only advantage of using survival methods is that they provide a small increase in power that translates to a smaller sample size For instance, a trial using the log-rank test to test...

Ngày tải lên: 12/08/2014, 23:21

... number of interventions for the cost-effectiveness analysis In other words, cost-effectiveness assessments were not performed for a whole range of relevant interventions For instance, interventions ... as well as the National Health Information System [19] Using these two types of information, the total number of treatments by age and sex could be estimated for each disease under study Subsequently, ... following an intervention can be calculated using equation (5) A detailed explanation using worked examples of how to calculate DALYs for cost-effectiveness analysis has been presented by Fox-Rushby...

Ngày tải lên: 13/08/2014, 11:22

... Fundamental Analysis for Visible-Light Communication System using LED Lights 103 IV INTERSYMBOL INTERFERENCE Generally, lights are distributed within a room and the irradiance of light is wide for function ... is large and it depends on performance of the system greatly In this paper, we consider until the first reflection for convenience of computer analysis C SNR Performance with Intersymbol Interference ... discussed about the fundamental analysis for visible-light communication system using LED lights In visible-light communication system, it is important to meet the requirements for optical lighting and...

Ngày tải lên: 09/02/2015, 15:30

... studies on recommender systems using social network analysis are still deficient Therefore, developing the recommendation system research using social network analysis will be an interesting ... interest in the network It is useful information for recommendation We also developed and improved methods based on the collaborative network analysis approach for research paper recommendation [16] ... approach based on social network analysis is a potential approach For the future work, we have developed methods based on the science collaborative network analysis for recommender systems in the...

Ngày tải lên: 09/10/2015, 08:37

... of A Ros [6] and theory orbifold, we will give an estimate for the Gaussian curvature of minimal surfaces AN ESTIMATE FOR THE GAUSSIAN CURVATURE OF MINIMAL in R3 and R4 whose Gauss maps ramified ... the uniformization theorem, we can see that Mv is conformally equivalent to either the unit disk D or the complex plane C, and we can suppose that pv maps onto for each v If Mv is conformally ... map of complete minimal surfaces in R3 and R4 on annular ends, Ann Fac Sci Toulouse Math 23 (2014), 829-846 [8] P H Ha, An estimate for the Gauss curvature of minimal surfaces in Rm whose Gauss...

Ngày tải lên: 12/10/2015, 16:28

... a foreign format (1.1.8), say Microsoft Excel or comma-separated value format, will allow access to other tools for analysis and display > write.csv(ds, file="ds.csv") Creating data in SAS format ... (tools for working with URLs and HTTP), lubridate (date and time manipulations), markdown (for simplified reproducible analysis) , shiny (to build interactive web applications), swirl (for learning ... DBF format The second can be used with any SAS formatted dataset; it is based on a reverse-engineering of the SAS dataset format, which SAS has not made public 1.1.8 Reading datasets in other formats...

Ngày tải lên: 18/04/2017, 10:23

... Suitability Analysis for Residential Housing by Using Geographic Information System and Remote Sensing: the Case of Sululta Town,” that submitted in partial fulfillment of the requirements for the ... technologies for urban monitoring and planning Now a time there is need of construction of housing of Oromyia National regional state to give land for housing for dwellers and expansion of housing investment ... title of this thesis is “Monitoring urban expansion and suitability analysis for residential housing by using Geographic Information System (GIS) and Remote Sensing (RS) the case of sululta town...

Ngày tải lên: 15/08/2017, 15:12

... track information is then used to acquire the precise digitizations using a simple dialogue mechanism - the second pass This dialogue is done simultaneously in successive TDs for all tracks (for ... The existence of a first guess for the tracks will offer more time for fits which are not foreseen on the trigger processor Elements The electronic modules built for the CP-LEAR trigger processor ... It has inputs for launching the trigger processor (beam, test); for manipulating the fate of the event under evaluation (accept, good forever, cancel keep mode, panic, skip) ; for synchronization...

Ngày tải lên: 16/12/2017, 00:52

... changed, scenarios for each change type and their change propagation information should be specified and formalized Research background 2.1 Previous work about change impact analysis for the system ... and a process for changing the system model according to change propagation is established Second, the change propagation information is formalized using the OWL ontology Third, by using predefined ... implement the changes is the set of objectives (shaded in Fig 1) for the proposed approach For example, when new actions are added to an activity diagram for realizing a new functional requirement,...

Ngày tải lên: 06/01/2018, 17:06

... evolves using monthly rebalancing based on conditional expected returns using public information Panel B shows the cross-sectional means for the performance measures and t-statistics for the ... evolves using monthly rebalancing based on conditional expected returns using public information Panel B shows the cross-sectional means for the performance measures and t-statistics for the ... evolves using monthly rebalancing based on conditional expected returns using public information Panel B shows the cross-sectional means for the performance measures and t-statistics for the...

Ngày tải lên: 29/04/2013, 14:07

... acceptable Simulation for small area of project Alternative analysis by changing current configuration During the study, • • • • All data was analyzed and prepared for ArcView Tables are formed and those ... figure For the future situation analysis, this is the main target of the study, as the first step the population for 30 years was estimated To estimate population precisely, census information ... wastewater system is adequate for future flows (2033) The results are supported by the simulation where INFOWORKS simulation program has been used by using GIS data Therefore, a new stream channel...

Ngày tải lên: 05/09/2013, 08:40