use the right tool for the job

... Table 8, where the numerical values in the table form the basis for the comparisons The figures in the left-hand column are typical for most two-axis turning centres, where: manual tool- changing ... further reinforce the correctness of the decision to purchase a quick-change tooling system, since it quickly buildsup the pay-back on the initial investment for this type of tooling strategy The ... precisely located in their respective toolholders The ‘Block tool is located in the following manner: the cutting unit slips in from above the coupling (i.e of the receiving toolholder) to firmly...

Ngày tải lên: 21/06/2014, 22:20

... ‘maintenance window’ occurs the number of different tools in the tooling inventory, then a company can be assured that when the tools are ‘called-up for use in the manufacturing process they will be available ... the system together with the tool stores should support the tooling from the tool file, with such items as: spares, consumables, plus back-up tooling In order to achieve this objective, the tool ... necessary to gather the data together, because the performances of either categories are independent If a tooling survey is approached in a m ­ ethodical and step-wise manner, then the following...

Ngày tải lên: 21/06/2014, 22:20

... of information to the tool stores Often, for the most frequently used tools, they are assembled into a composite forms, then issued as ‘grouped-tools’ in the form of kits for a specific job (i.e ... the machine tool on which they will be used, the number and identification of these tools, together with the date of issue A major benefit of creating an area set-aside close to the machine tools ... precision-ground tooling surfaces – while being kept in the open, • Time is lost looking for tools – due to the lack of any form of tool management, tools must be looked for located, then assembled...

Ngày tải lên: 21/06/2014, 22:20

... 143.  A computerised tool management system for an FMS facility [Courtesy of Yamazaki Mazak] Modular Tooling and Tool Management the tools to-and-from each machine – changing the ‘stand-alone’ machine ... a simple form of flexible manufacturing system (FMS) It consists of a tool hive’ stocker, which acts to store tools in a centralised and convenient location within the shop, having a tool tarnsport ... increases the overall utilisation rate of these automated CNC machine tools References Journals and Conference Papers Chandler, B Crib Control [Organising Tooling Workplace] Cutting Tool Eng’g.,...

Ngày tải lên: 21/06/2014, 22:20

... and the findings as they relate to prescribing and medicines use For those interventions where no reviews were identified, we include a comment in the database, informing the users that there ... groups, we developed the methods used for the synthesis and the presentation of the findings for this database Human resources required in successfully maintaining Rx for Change equals four highly ... directed at consumers to improve medicines use [7] For the Rx for Change database, the CC&CRG is responsible for maintaining and updating the evidence on the effect of consumer-targeted interventions,...

Ngày tải lên: 10/08/2014, 10:23

... time Welcome The clinic uses the administrative portal to enter initial patient contact information into the Connection to Health database The system then sends an e-mail or letter to the patient ... assessment package Use of RE-AIM for Connection to Health development We used the RE-AIM model [19,33,35] in developing the Connection to Health tool, by applying it to the goals of the PCMH Table ... because the system might cause them to feel separated from their patients However, if the system is well-integrated within the practice, it will need to be done is a manner that minimizes the...

Ngày tải lên: 10/08/2014, 11:20

... different information on the samples for the home -use One group in both age cohorts was informed about the organic quality of the sample and another group received information about the sample’s ... relevant enough for this study, the data were pooled together over the information conditions Home -use test Olfactory test For the home -use test, subjects received three cups (150 g each) of the snack ... they preferred the strong tea During the exposure, they also consumed more of the weaker tea than the stronger one In our study, the intake of neither of the two samples changed during home-use...

Ngày tải lên: 03/04/2013, 21:06

... Beyond the Look of the Letter How I know which font is right for the job? Why some fonts cost more than others? Why are there so many versions of the same typeface? These are good questions Fortunately, ... fonts 415.252.1003 The font has the right form What about the function? A few years ago, you had to make a decision between TrueType or PostScript and Mac or Windows Today, the choice is usually ... QuarkXPress® It’s often the best choice for non-designers as well, such as users in the corporate environment who want cross-platform compatibility or who set type in Greek, Russian, or other Eastern European...

Ngày tải lên: 18/07/2013, 08:49

... ANOVA for just the values obtained in 2003 As is the case examining FC values for both years along the length of the creek, the FC concentrations would not index any particular source as cause for ... presents the average values for the AC/TC and FC/FS ratios, irrespective of weather conditions, at these different types of fecally impacted sites for the year studied As can be seen, the AC/TC ... a week at these sites for a multi-year period and the information evaluated for insights into fecal source by the conventional fecal coliform/fecal streptococci ratio (FC/FS), and the new AC/TC...

Ngày tải lên: 05/09/2013, 09:08

... those for silica sand This is because the degree of the solute dispersion in Andisol is larger due to the difference between the soil properties such as the uniformity coefficient and the mean ... HWCs while there is a slight change of the peak concentration in Andisol (Fig (b)) except for the more pronounced tailing of the BTCs with the increase of HWCs The peak concentrations for Andisol ... moisture content inside the column uniform while water was sprinkled over the top of the medium until the outflow from the bottom of the column equaled the volume of the water input Prior to an application...

Ngày tải lên: 05/09/2013, 10:15

... Efficiency for Ammonium Removal Fig illustrates the efficiency of the reactors for the removal of ammonium The efficiency of the reactors in removing ammonium is clearly seen in the graph The most ... Efficiency for Total Phosphorus (TP) Removal Fig illustrates the efficiency of the reactors for the removal of TP The highest efficiency for the removal of TP was obtained upon using reactor II, and the ... to a certain extent, because the radius of H+ is less than the radius of K+, Na+ and Ca2+ The H+ ion replaces the positive ion K+, Na+, Ca2+ hole volume is enlarged, force of chemical bond between...

Ngày tải lên: 05/09/2013, 10:17

Ngày tải lên: 06/09/2013, 00:10

... needs The between -the- lines information represents the nuances of effective correspondence that are rarely stated but which are often inferred The classic example is the individual who applies for ... French Literature from the Massachusetts Institute of Technology Moreover, during my Fulbright Scholarship for the study of French literature at the Sorbonne, I read extensively the works of writers ... Newspapers and the Associated Press My most recent publication is the second edition of my book, Technical Documentation on the Internet Correspondence for the Application Process and the Job Search...

Ngày tải lên: 25/10/2013, 18:20

... years through the development and use of a succession of live food organisms as feed for the developing larvae The aim of the present manual was therefore to review and summarise the latest developments ... without the prior permission of the copyright owner Applications for such permission, with a statement of the purpose and extent of the reproduction, should be addressed to the Director, Information ... organisms as feed for the developing larvae The present manual describes the major production techniques currently employed for the cultivation of the major types of live food commonly used in larviculture,...

Ngày tải lên: 15/12/2013, 00:15

... between the culture medium and the air The latter is of primary importance as the air contains the carbon source for photosynthesis in the form of carbon dioxide For very dense cultures, the CO2 ... Fluorescent tubes emitting either in the blue or the red light spectrum should be preferred as these are the most active portions of the light spectrum for photosynthesis The duration of artificial ... whether the operation aims at the mass-production of larvae for remote setting or growing millions of seed till planting size In either case, the juveniles, representing the largest biomass in the...

Ngày tải lên: 15/12/2013, 00:15

... a disinfectant The eggs are then separated from the dead bodies on a 50 àm sieve and incubated for hatching and the offspring used for starting the stock cultures However, if the rotifers not ... are rinsed, a small part is used for maintenance of the stock, and the remaining rotifers can be used for upscaling Furthermore, after some months of regular culture the stock cultures will be ... (Hirayama, 1987) Most probably the reason for these crashes was explained by the poor digestibility of the yeast, which requires the presence of bacteria for digestion Moreover, the yeast usually needs...

Ngày tải lên: 15/12/2013, 00:15

... However, with the expansion of aquaculture production in the 1970’s, the demand for Artemia cysts soon exceeded the offer and prices rose exponentially, turning Artemia into a bottleneck for the expansion ... reproduction to the other The cysts usually float in the high salinity waters and are blown ashore where they accumulate and dry As a result of this dehydration process the diapause mechanism is ... marine larviculture Through multidisciplinary studies in the eighties both the causes for the nutritional variability in Artemia and the methods to improve poor-quality Artemia were identified...

Ngày tải lên: 15/12/2013, 00:15

... for instar I nauplii (see 4.2.3.; Fig 4.3.4.) For example, for the culture of carp larvae during the first two weeks, the use of decapsulated cysts constitutes a saving of over one third in the ... ¨ either 0.67 NaCO3 or 0.4 g CaO for bleaching powder; dissolve the bleaching powder before adding the alkaline product; use only the supernatants of this solution; ¨ seawater to make up the ... When the reagent turns blue, washing and deactivation has to be continued USE · Incubate the cysts for hatching, or store in the refrigerator (0-4°C) for a few days before hatching incubation For...

Ngày tải lên: 15/12/2013, 00:15

... swallow their prey in one bite the size of the nauplii is particularly critical For example, fish larvae that are offered oversized Artemia nauplii may starve because they cannot ingest the prey For ... 1986) On the other hand, instar II stages may be more susceptible to digestive enzyme breakdown in the gut of the predator since these enzymes can also penetrate the digestive tract of the Artemia ... Artemia strains (see further) Commercial provisions of Artemia cysts containing high EPA levels are limited and consequently, these cysts are very expensive Therefore, the use of the high-EPA cysts...

Ngày tải lên: 15/12/2013, 00:15

... prohibitive Therefore, a simplified but reliable technique for the short-term intensive culture of Artemia juveniles for use as a nursery diet for fish and shrimp was developed at the ARC The idea ... installations, on the other hand, there is a significantly higher mortality during the end of the first culture week that can be explained by the deterioration of the water quality, probably because the early ... autonomously for much longer periods than traditional nylon mesh-filters Therefore, proportionally smaller welded-wedge filters can be used, leaving more volume for the animals in the culture tank Furthermore,...

Ngày tải lên: 15/12/2013, 00:15