test validation and debug of high speed serial interfaces

... Accelerating Test, Validation and Debug of High Speed Serial Interfaces Yongquan Fan · Zeljko Zilic Accelerating Test, Validation and Debug of High Speed Serial Interfaces 123 Dr Yongquan Fan High Performance ... information on high- speed serial interface standards The chapter then enumerates the challenges that we are facing in high- speed serial interface testing, validation and debugging, and finally outlines ... probabilistic properties and the basics of the simulation and emulation approaches to the modeling of BER effects 2.1 High- Speed Serial Communication The high- speed serial communication interfaces have...

Ngày tải lên: 09/04/2015, 17:22

... data of the iBRIDGE with other image sensors The first set of sensors are “application-specific” and not support random access of the image pixels The second sets of sensors are of general type and ... frequency of DCLK is half or quarter of the frequency of EXTCLK depending on the configuration of the image sensor The initialization and configuration of the image sensor is done by the 2-wire (SCL and ... number of random pixels that need to be accessed (in the worst case, Nmax = W × H, where W and H are image width and height, namely), BPP is the number of bytes per pixel, CPI is the number of clock...

Ngày tải lên: 21/06/2014, 07:20

... modeling of high- speed interconnects and multilayer circuits together with efficient simulation of mixed electromagnetic and circuit problems play an important role in modern circuit design and analysis ... focuses on developing accurate and efficient modeling and simulation methods to analyze high- speed interconnects and circuits and perform mixed electromagnetic and circuit simulation Specifically, ... and CEM techniques and providing me with invaluable guidance and great support I also feel gratitude to Prof Leong Mook-Seng and Prof Ooi Ban-Leong for being on my thesis advising committee and...

Ngày tải lên: 16/09/2015, 15:55

... baud rates of up to Mbps Reliably achieving high- speed baud rates requires some considerations in the hardware design Traditionally, PCs’ serial ports only operate at standard baud rates of up to ... Manufacturers of USBto -serial converters may claim higher baud rates, but some incorporate level translator circuits that limit performance to baud rates of 500 kbps or less More reliable, high- speed ... the host serial port At high speeds, USBto -serial converters may have limited steps between available baud rates As an example, some of the currently available baud rates for two USB-to-serial...

Ngày tải lên: 11/01/2016, 16:55

... arrangement of insulation and magnetic material in the rotor can result in high saliency ratio and not the amount of insulation and magnetic material It is worth mentioning that the amount of magnetic ... manufacturing point of view and reasonably high performance as a variable speed motor These machines are driven as variable speed drive systems Table summarises the experimental performance of flux-guided ... result in high saliency ratio and also high (Ld-Lq), a pre-requisite for improved performance The inductances and the performance of one such machine is also given when driven as a variable speed...

Ngày tải lên: 05/09/2013, 16:30

... Features of ATP III similar to those of ATP I and II Identification of population groups, besides middle-aged men, for detection of high LDL cholesterol (and other lipid risk factors) and for ... short-term risk High serum cholesterol itself is a major cause of the build-up of coronary atherosclerosis, and hence of the development of CHD in the long term For this I–3 I Background and Introduction ... as target of therapy Notwithstanding this diverse evidence, the ultimate proof of the benefits of lowering LDL cholesterol is through clinical trial A large number of clinical trials of cholesterol-lowering...

Ngày tải lên: 14/02/2014, 09:20

... images and EDS of SiOx nanowires deposited on the Si(111) substrate at the reaction temperature of 1000 °C for h (a) and (b), The lower magnification SEM images of the nanowires, (c) The higher ... the surface of Si(111) substrate, as illustrated in Fig 2(a) and (b) The lengths of these nanowires are in the range of several tens to hundreds of micrometers Fig 2(c) shows the higher magnification ... temperatures of 1100 and 1200 °C The composition analysis of the products was achieved using EDS Fig 2(d) shows EDS spectrum of the nanowires, indicating that the products only consist of silicon and...

Ngày tải lên: 16/03/2014, 15:11

... some of its long term effects THE COSTS AND BENEFITS OF A NEW HSR LINE 2.1 Total costs of building and operating a HSR line Total social costs of building and operating a HSR line consist of the ... project life and the cost savings in alternative modes; and the higher is the investment, maintenance and operating costs, and the social discount rate de Rus and Nombela (2007) and de Rus and Nash ... of highspeed trains: An introduction and review’, The Annals of Regional Science, 31: 57-76 INFRAS/IWW (2000): External costs of transport Zurich/Karslruhe Levine, M E (1969): ‘Landing fees and...

Ngày tải lên: 17/03/2014, 08:20

... images of the nanosheet TiO2 calcined at 600 and 700 °C showed almost nanoparticles with a mixture of anatase and rutile TiO2 structure (about 10–50 nm in diameter, at 600 °C, Fig 6(g–h)), and rutile ... the use of TEM apparatus and to Prof T Yoko, Institute for Chemical Research, Kyoto University for the use of XRD equipment This work was supported by grant-inaids from the Ministry of Education, ... pattern of the as-synthesized nanosheet TiO2, and nanosheet TiO2 calcined for h at 300–700 °C The nanosheet TiO2 calcined for h at 300–500 °C consisted of anatase TiO2 structure The peak intensity of...

Ngày tải lên: 20/03/2014, 13:06

Ngày tải lên: 31/03/2014, 05:21

... polished and cleaned with acetone The elemental distribution maps of ceramic specimens are recorded with EPMA before and after laser treatment High magnification photos of the surface topography and ... stress and strain, thus to obtain high precision of bending The relation between bending angles and laser operating parameters, such as laser power, laser scanning velocity, and number of scanning ... dependence of bending on optical and thermophysical properties of the target material is illustrated In order to understand the effects of laser irradiation, surface composition before and after...

Ngày tải lên: 06/05/2014, 08:55

... independent validation study to establish the psychometric properties of the QUALIOST® Internal consistency and test- retest reliability, as well as analysis of the hypothesised structure, concurrent and ... There was a high return rate of questionnaires (93.5% at baseline) and quality of completion was high for both questionnaires: 89.3% of baseline QUALIOST® and 76.1% of baseline SF-36 had no missing ... the length of follow-up (3 years), the high return rates of the QUALIOST® and low percentages of missing data, this study demonstrated good acceptability of the questionnaire Rates of questionnaires...

Ngày tải lên: 20/06/2014, 15:20

... get good speedup results using processors or less, and for GOF sizes of up to 16 frames The ideal speed- up is surpassed in many instances, overall up to 16 frames per GOF, and between and 16 processors ... a Full Professor of computer architecture and technology and Vice Rector of Research of the University of Castilla-La Mancha He has developed several courses on computer organization and computer ... presents the speed- up results corresponding to a frame size of 1024 × 1024 pixels Four GOF sizes have been considered: 4, 8, 16, and 32 frames per GOF A larger number of frames in a GOF allow us...

Ngày tải lên: 22/06/2014, 19:20

... capable of neutralizing high doses of SEB both in vitro and in vivo Our lead antibody HuMAb154 was selected for further characterization because of its high affinity and in vitro high potency and ... regulations and guidelines of the National Institutes of Health (NIH) and with the approval of the TPPS Animal Care and Use Committee Mice were challenged with various concentrations of SEB (Toxin ... that received molar ratios of antibody to toxin of 21:1 and 37:1 survived an aerosolized exposure of approximately LD50 of SEB Pooled human sera with titers against SEs and TSST-1 were reported...

Ngày tải lên: 11/08/2014, 08:21

... experiments and was involved in the design and coordination of the study and drafting the manuscript FH measured HMGB1 levels, and was involved in the design and coordination of the study and drafting ... SH, SY, MK and MT were involved in the design and coordination of the study HT and NM were involved in western blot analyses JF was involved in the design and coordination of the study and drafting ... ANOVA and SNK test as post hoc test (for comparison of more than three parameters) A significant difference was considered to be P < 0.05 Results Intracellular growth and cytotoxicity of L pneumophila...

Ngày tải lên: 12/08/2014, 15:21

... with dark and light shades of blue indicating the existence of many and few points, respectively (a) High quality array (b) Low quality array A brief summary of the pre-processing and genotyping ... (Nsp and Sty) from the Broad Institute and Affymetrix, respectively Again, the gold standard is HapMap calls (c) ADPs are plotted for the 32 and 16 high quality replicates hybridized on XBA and ... sophisticated version of the second step and demonstrate important practical implications Across datasets from multiple laboratories and by different methods of validation, CRLMM is just as, and in many...

Ngày tải lên: 14/08/2014, 08:21

... direction of change) between the Hughes et al swi4∆ profile and our new profile Expression changes were reproducible for 28 of 42 Msn4p-regulated genes, 11 of 29 Hap4p-regulated genes, and 64 of 119 ... details of the computation of expression coherence and the selection of the gene sets are described further in Materials and methods and [23] As shown in Figure 3a, the gene set downstream of MSN4 ... (ChIP-chip) [3]; the set of all 15,116 pairwise protein-protein interactions recorded in the Database of Interacting Proteins as of April 2004 [19]; and a panel of mRNA expression profiles for 273 individual...

Ngày tải lên: 14/08/2014, 14:21

... Planning for inspection and testing of highstrength concrete involves giving attention to personnel requirements, equipment needs, test methods, and the preparation and handling of test specimens Additional ... of the strength level, but because a higher degree of control is maintained in the production and testing of high- strength concrete Continual review of the field results and the maintenance of ... strength testing This is followed by discussions of sampling, amount of testing, and various details about test specimens 4.2—Background In a research program on compressive strength testing of high- strength...

Ngày tải lên: 24/10/2014, 21:59

... Boost 3-φ Buck 3×1-φ Boost Multipulse 0 3 (3 windings) High High High High Low Low bandwidth, bandwidth, bandwidth, bandwidth, bandwidth, bandwidth, linear linear linear linear non-linear non-linear ... half-cycle of the load current, S1 and S2 are switched off As the inductive impedance of the load circuit tends to maintain the load current, C1 and C3 now support the current of S1, and C2 and C4 ... where ρc and µc are the resistivity and permeability of the coil, and ρw and µw are those of the work piece, respectively To provide an efficient solution, the work coil is always made of copper,...

Ngày tải lên: 13/11/2014, 06:49