software design for low power architecture

Ngày tải lên: 01/07/2014, 11:20

Ngày tải lên: 22/06/2014, 19:20

... INTRODUCTION TO SOFTWARE DESIGN FOR SIX SIGMA (DFSS) 171 8.1 Introduction / 171 8.2 Why Software Design for Six Sigma? / 173 8.3 What is Software Design For Six Sigma? / 175 8.4 Software DFSS: ... 379 14.4 Software Design for Testability / 380 14.5 Design for Reusability / 381 14.6 Design for Maintainability / 382 References / 386 Appendix References / 387 Bibliography / 387 15 SOFTWARE DESIGN ... Axiom 2 in Software DFSS / 352 References / 354 Bibliography / 355 14 SOFTWARE DESIGN FOR X 356 14.1 Introduction / 356 14.2 Software Reliability and Design For Reliability / 357 14.3 Software...

Ngày tải lên: 17/03/2014, 19:20

... 75 4 SOFTWARE DESIGN METHODS AND REPRESENTATIONS 77 4.1 Introduction / 77 4.2 History of Software Design Methods / 77 4.3 Software Design Methods / 79 4.4 Analysis / 85 4.5 System-Level Design ... Platform-Based Design / 96 4.7 Component-Based Design / 98 4.8 Conclusions / 99 References / 100 5 DESIGN FOR SIX SIGMA (DFSS) SOFTWARE MEASUREMENT AND METRICS 103 5.1 Introduction / 103 5.2 Software ... Standard for a Software Quality Metrics Methodology IEEE Std 1228-1994 Standard for Software Safety Plans IEEE Std 1233–1996 Guide for Developing System Requirements Specifications IEEE Std 16085 Software...

Ngày tải lên: 30/03/2014, 03:20

... software Design for Six Sigma. After reading this book, the reader could gain the entire body knowledge for software DFSS. So this book also can be used as a reference book for all software Design ... Software Design For Six Sigma: A Roadmap for Excellence, constitutes an algorithm of software design 3 using the design for Six Sigma thinking, tools, and philosophy to software design. The algorithm ... 75 4 SOFTWARE DESIGN METHODS AND REPRESENTATIONS 77 4.1 Introduction / 77 4.2 History of Software Design Methods / 77 4.3 Software Design Methods / 79 4.4 Analysis / 85 4.5 System-Level Design...

Ngày tải lên: 24/04/2014, 16:06

Ngày tải lên: 22/06/2014, 19:20

Ngày tải lên: 22/06/2014, 22:20

... Computational Paradigm for MT Software The computational paradigm we have chosen for the systems to be generated is the one of expert systems because the design of software for an MT system of ... requirements we have taken the following design decisions : 1. On the one hand, the software to be designed will be oriented towards a class of abstract systems (see below) rather than one specific ... the formulation of judgements of relative semantic or pragmatic acceptability. The organisational complexity of Eurotra also poses problems for software design. Quite separate strategies for...

Ngày tải lên: 08/03/2014, 18:20

Ngày tải lên: 23/06/2014, 01:20

... limitation In this VGA design, the output signal is fixed to be 1V pp with 2.5V power supply, to meet the full scale of the ADC. Thus, the suitable VGA topology for this design has to provide ... suitable for low power applications. (3) Summary of analog-multiplier-based VGA In summary, the multiplier-based VGA has good linearity and large gain tuning range, but it is not power efficient ... generated by the subtraction between g mp1 and g mp2 . And hence, it is not suitable for low- power VGA design. II.1.3 Differential pair with source degeneration Another commonly used VGA...

Ngày tải lên: 06/11/2012, 10:26

... development Shutdown & disposal Design, Development, Production & testing Software Design Software Design Day 2 - Software Design Analyze requirements Create design Analyze and review Correct and ... Overview Day 2 - Software Design Software Development Day 2 - Software Design Reviewing the design - objective  The objective is to increase the likelihood that the design is the best ... Overview Software design - 3 parts Conceptual Logical Physical Scenarios Services & Objects, UI logical DB Components, UI & Physical DB Software Design & Development Software Design...

Ngày tải lên: 15/10/2013, 23:13

Ngày tải lên: 25/12/2013, 10:38

... to proposals on other levels in the design flow and to future work. Keywords: Low- power design, dynamic power reduction, leakage power reduction, ultra- low- V th devices, multi-V dd , multi-V th , ... search for optimization of power consumption. For leading-edge products which need to optimize both power consumption and system performance, optimization techniques on architecture and design ... threshold voltages for further power reduction. Especially for designs where minimization of total power consumption is key (as compared to e.g. minimization of standby power for mobile products),...

Ngày tải lên: 01/06/2014, 11:43

Ngày tải lên: 03/06/2014, 18:15

... Open Access Novel low- PAPR parallel FSOK transceiver design for MC-CDMA system over multipath fading channels Juinn-Horng Deng * and Jeng-Kuang Hwang Abstract A low peak-to-average power ratio (PAPR) ... performance and outperform the con- ventional STBC MISO and MIMO systems. The rest of this article is organized as follows. In Sec- tion 2, we pre sent the SISO system block d iagram and formulate ... 2011:144 http://jwcn.eurasipjournals.com/content/2011/1/144 Page 2 of 14 to signal power. For performance comparisons, BER simulations are conducted for the proposed QPS K-FSOK MC-CDMA, conventional MC-CDMA [8],...

Ngày tải lên: 20/06/2014, 22:20

... ultra -low- power image compressor for capsule endoscope,” BioMedical Engineering Online, vol. 5, article 14, 2006. [15] X. Xie, G. Li, X. Chen, X. Li, and Z. Wang, “A low- power digital IC design ... converting into one dimension for B component. Raw image R G1 G2 B Compression image for G1 Compression image for G2 Noncompression image for B Compression image for R Entropy coding Entropy coding Entropy coding 4-by-4 zigzag scan 4-by-4 zigzag scan 8-by-8 zigzag scan Quantization R-table 4-by-4 quantization G-table 4-by-4 quantization G-table 2D 8-by-8 DCT 2D 4-by-4 DCT 2D 4-by-4 DCT 2 ... another research department for the GICam-II capsule endocopy. Therefore, the format of the GI image used in the simulation belongs to a raw image from the 512-by- 512 sensor designed by Chung-Shan...

Ngày tải lên: 21/06/2014, 07:20

... exact method makes it infeasible for practical applications. Therefore, it is needed to derive an approximate solution for the success probability giving acceptable performance with minimal computational ... f t +1 . (11) Following the above formulation, the history of trans- mission outcomes for each channel can be written as x(t) = (i t , b t , s t , f t ) which we call the informational state ... the trafficpattern of interfering network in each channel. For the reasons that will follow, we assume that the duration of idle intervals, for channel i, is modeled as a geometric random variable...

Ngày tải lên: 21/06/2014, 22:20

... per node of LPL and DW-LPL for varying sleep intervals, T p for LPL and T b for DW-LPL. In Figure 8(a), T p = 100 ms is best for data generation interval T d = 10 s. For T d = 30 s, the optimal ... analysis. Symbol Meaning CC2420 P l Power in listening 56.4 mW P t Power in transmitting 52.2 mW P r Power in receiving 56.4 mW P a Power in awaking 670 uW P s Power in sleeping 3 uW t a Time to ... sporadic traffic and describe adaptive schemes for DW-LPL. 3.2. Low power listening for sporadic traffic Many sensor applications periodically generate trafficfor data collection. At every collection...

Ngày tải lên: 21/06/2014, 23:20

... the total power consumption and the final throughput. In this paper, we propose a dataflow oriented design ap- proach for low- power block based video processing and ap- ply it to the design of ... Bor- mans, “Algorithmic and architectural co -design of a motion- estimation engine for low- power video devices,” IEEE Trans- actions on Circuits and Systems for Video Technology, vol. 12, no. 12, pp. ... [9]. The techniques for power aware system design [10] are grouped according to their impact on the en- ergy delay product in [4]. Our proposed design flow assigns them to a design step and identifies...

Ngày tải lên: 22/06/2014, 19:20

... to be adopted for any given workload to achieve power savings. The effectiveness of this approach is also demonstrated by an event-driven simulator, which is designed using JAVA for power- manageable ... characterized by the level of power consumption and performance. In addition, state transitions have power and delay cost. When a compo- nent is placed into low- power state, it becomes unavailable till ... cost function for system-level policies to evaluate the energy for the current idle period. The cost (energy) computation for different policies is in- dicated in Table 1. 5. HARDWARE ARCHITECTURE The...

Ngày tải lên: 22/06/2014, 19:20