selection counter selection for gene mutation replacement and fusion

... were boiled for the determined time, removed, and drained for 10 sec, placed in water at room temperature for 30 sec, drained for 10 sec, placed in chilled water for 30 sec, drained for 10 sec ... 2, and Noodle sheets were progressively reduced to a uniform final thickness of 1.30 ± 0.03 mm for thin WSN as in Konik (1993) Measurements for gloss and translucency were taken on sheets for ... for all 32 panelists were averaged to calculate the gloss and translucency score Panelists ranked noodle gloss and translucency on boiled noodle disks and strands from six WSN mixes of ASWN and...

Ngày tải lên: 16/12/2012, 15:25

... interactions (mutual testing and discussions) between assessors Bodin and Morris (1991) investigated the 67 68 Garth R Johnson and Anand D Pandyan inter-rater reliability of the scale for measuring wrist ... Johnson and Anand D Pandyan need for a technique that does not rely upon the measurement of damped oscillations but provides a soundly based physical measurement Duckworth and Jordan (1995) performed ... these scales have been reviewed in detail by Pandyan and colleagues (Pandyan et al., 1999) and the major points are outlined in Table 3.2 Ashworth and modified Ashworth scales – level of measurement...

Ngày tải lên: 01/11/2013, 10:20

... HelmholtzGemeinschaft Deutscher Forschungszentren, Germany; the General Secretariat for Research and Technology, Greece; the National Scientic Research Foundation, and National Ofce for Research and Technology, ... simulated signal and background events, including heavy-quark, tt, W+jets, and DY production, are processed and reconstructed in the same manner as collision data 4.1 Event and track selection The ... from t t and DY background processes is % and %, respectively The particle and energy densities differ between DY and DY (the signal process) by 20 % The particle (energy) density for the...

Ngày tải lên: 07/03/2014, 17:20

... of IPSyn, which searches for IPSyn structures using POS, morphology and GR information, and a comparison to the CP implementation, which uses only POS and morphology information, is presented ... differences between GR and HUMAN, and CP and HUMAN It is interesting to note that the average point differences between GR and HUMAN were similar on sets A and B (3.7 and 2.9, respectively) Despite ... for a CMOD where the dependent is to the right of the head; • Bitransitive predicate: search for a word that is a head of both OBJ and OBJ2 relations Although there is still room for under- and...

Ngày tải lên: 08/03/2014, 04:22

... is a standard SMF and is easily replaceable; hence special and tailor-made sensors, such as using photonics crystal [6] or microfibers [7] are not required The proposed scheme is simple and provides ... 1.4482 1.4682 Refractive Index Experiments and Discussion Figure shows the proposed experimental setup for detecting the RI of liquid organic chemicals For general use in optical communication network, ... for RI detection, as shown in inset of Figure The sensor head should be flat and is prepared by a typical fiber cleaver In this experiment, the cladding and core diameters of SMF are 125 μm and...

Ngày tải lên: 14/03/2014, 20:20

... the nanowire Fig Plasmon-loss images for (a) Si and (b) SiO2 for the SiNW shown in Fig 2; (c) and (d) are the intensity profiles of the boxed areas in (a) and (b), respectively H Suzuki et al ... appears for silicon crystal [16] The peak for the first plasmon-loss of SiO2 is 22.4 eV [16] Then, the plasmon-loss images were obtained by placing the slit at 16.7 ± 2.5 eV and 22.4 ± 2.5 eV for ... tungsten silicide could be formed at the interface between the fused silicon wire and the tungsten tip The silicon wire therefore firmly adhered to the tungsten probe and the contact resistivity...

Ngày tải lên: 16/03/2014, 15:05

... σAFM= 2.87 10 Figs and show the AFM images and the SEM images of AAO fabricated in this study, respectively For 30 50 Widening Time (min) Fig Measured pore sizes and their standard deviations ... (FE-SEM, JEOL JSM-6330F) was used and the specimens were coated with Pt In the AFM image, the vertical height between the pore entrance and the top surface for AAO before widening was found to be ... Pt was used as a cathode A constant voltage of 20 V was applied between the cathode and the anode for 60–90 s and the solution temperature was maintained at °C during electropolishing After electropolishing,...

Ngày tải lên: 20/03/2014, 13:04

... the market for a period before the measurement date to allow for marketing activities that are usual and customary for transactions involving such assets or liabilities; it is not a forced transaction ... else? IAS 39 generally requires the use of bid prices for financial assets and ask prices for financial liabilities when they are available However, it allows entities that have assets and liabilities ... often redeemable on demand and the fund is required by its prospectus to issue and redeem units to its investors at a unit price that reflects mid-market prices for its assets For the purposes of...

Ngày tải lên: 23/03/2014, 11:20

... throughfall and stemflow in a forest in highland Scotland and the comparison with other upland forests in the U.K.’ J Hydrology 118, 281–287 Johnson, D W., Richter, D D., Lovett, G M and Lindberg, ... relation to the characteristics of the stand Fewer collectors are required for homogeneous, even-aged stands than for mixed stands with trees of different diameter and canopy size classes The number ... sylvestris L.) and grand fir (Abies grandis (Dougl.) Lindl.) stands (Aussenac, 1970) These gradients seem to be steeper in young conifer stands, with homogeneous circular crowns, than in mature stands characterised...

Ngày tải lên: 23/03/2014, 23:20

... determine and present gains and losses on available -for- sale debt investments? The table below summarises the requirements on determination and presentation of income and expense on available -for- sale ... cost in foreign currency converted at spot rate of 1.7 (784,904) Foreign exchange gain (91,971) The accounting entries for the foreign exchange gain are as follows Foreign exchange gains and losses ... IFRS for Investment Funds How you determine and present gains and losses on available -for- sale equity instruments? The table below summarises the determination and presentation requirements for...

Ngày tải lên: 30/03/2014, 03:20

... Engineering, and the Institute of Medicine The members of the committee responsible for the report were chosen for their special competences and with regard for appropriate balance Support for this ... Social and Behavioral Sciences, Institute for Health and Aging, University of California at San Francisco MONROE BERKOWITZ, Professor of Economics, Emeritus, and Director, Disability and Health ... prepared papers for presentation, those who served as formal discussants, and the many others who contributed to the lively and informative discussions at the workshop Support for the study was...

Ngày tải lên: 30/03/2014, 12:20

... in any form to anyone is expressly forbidden Terms & Conditions of access and use can be found at http://www.tandfonline.com/page/termsand-conditions Nanoscale and Microscale Thermophysical Engineering, ... P Chen4 , and Xianfan Xu1 School of Mechanical Engineering and Birck Nanotechnology Center, Purdue University, West Lafayette, Indiana School of Electrical and Computer Engineering and Birck ... extensively studied for applications such as thermal management in electronic devices [1, 2] and thinfilm thermoelectrics [3–6] Thin-film boundaries and interfaces contain roughness and defects that...

Ngày tải lên: 06/05/2014, 08:54

... Fisher T S and Sands T D 2006 J Chem Phys B 110 10636 [35] de Pablo P J, E Graugnard E, Walsh B, Andres R P, Datta S and Reifenberger R 1999 Appl Phys Lett 74 323 [36] Zhang Y, Ichihashi T, Landree ... then the total resistance R will be given by For a particular CNT, if we assume the contacting electrodes form uniform contacts to both sides of the CNT, and if we ignore any variation in the outer ... figures in the inset show enlarged images of cuts 1, and Figure Resistance versus contact length for sample no 4b For this MWCNT, five cuts have been performed From FESEM micrographs, the original contact...

Ngày tải lên: 06/05/2014, 08:54

... acknowledge the help of Andrew C Tam of IBM Almaden Research Center and Hee K Park during the experimental work, and Xiang Zhang for sample preparation K A Jackson, in Crystal Growth and Characterization, ... Ueda and J B Mullin ͑North-Holland, Amsterdam, 1975͒, p 21 M O Thompson and G L Galvin, Proceedings of the Materials Research Society, edited by J Narayan, W L Brown, and R A Lemons ͑NorthHolland, ... Thermal and optical properties of bulk silicon10,11 and quartz10 were used in the calculation The measurement matched well with the numerical simulation for quantities such as melt depth and melt...

Ngày tải lên: 06/05/2014, 08:54

... chord and four lacing members of 168 and 219 mm (6’’ and 8’’) OD and mm thickness The parent material for this construction is carbon steel, the typical chemical composition of this material and ... the Australian standard for hardness assessment of weldments15, three impressions in the weld and then every 0.5 mm through the HAZ and the PM Result are shown in Figure 6b This information was ... before PWHT and in Table after PWHT A=− Equation Where σ max , σ are the principal stresses A,B are calibration constants; and a, b are material independent coefficients ε1 and ε3 are hoop and...

Ngày tải lên: 17/05/2014, 15:28

... compared, Idared and Granny Smith tended to brown less while Stayman browned more; Red Delicious, Cortland and McIntosh were intermediate in browning Slopes and A values for L and a both appearedto ... surfaces, Hunter L, a, b and CIE Y, X, Z values were measured for plugs taken from fruits for each of apple cultivars (Cortland, Granny Smith, Idared, McIntosh, Red Delicious and Stayman) over a hr ... mL 0.1% AA (20 ppm), and I O mL 0.1% AA (40 ppm) Reflectance L- and a-values for controls and treated juices were measured at intervals during 1% hr at 20°C To compensate for sedimentation in...

Ngày tải lên: 18/05/2014, 20:15

Ngày tải lên: 21/05/2014, 09:34

... instrument and the supporting software can be used for non-destructive measurement of applied and residual stresses in laboratory samples and real parts and structural elements in many applications for ... residual stresses determined by ultrasonic method and numerical simulation showed reasonable agreement both for standard welded specimens and for the large welded panel 5 The developed advanced ... measured before testing and after 1, and 10 cycles of constant amplitude loading (between 51[kN] and -21[kN]) After 10th cycle, 2000 cycles of variable amplitude spectrum was applied to the panel and...

Ngày tải lên: 24/05/2014, 20:32

... All data were normalized and corrected for attenuation, random coincidences, scatter radiation, dead time, and decay Reconstructions were performed using normalization and attenuation-weighted ... mismatch between derived VOI and tumor boundaries) for all methods applied to both Patlak and SUV images, specifying results for NSCLC and GI cancer separately In general, most tumor delineation ... from SUV and Patlak images are shown in Figure Exceptions were VOIA70 for both types of cancer and the two gradient-based methods for GI cancer (Tables and 3) Large differences (up to 58.7% and 28.1%...

Ngày tải lên: 18/06/2014, 18:20