provide methods for record store operations

... as possible To this end, operations research methods have received considerable importance for the operations management in port container terminals From the angle of operations research and management ... up with a good quayside operations planning is extremely critical for port operators due to the fact that the decision made for quayside operations lays the foundation for the subsequent phases ... each subproblem For Imai et al (2003), service priority issue in BAP was highlighted The authors provided a generic formulation for BAP with service priority by introducing weight for each incoming...

Ngày tải lên: 10/09/2015, 15:48

... Section presents the general formulation of the problem in the form of a stochastic integral equation, a formal analytical solution and a closure approximation for zero mean forcing function Section ... 10.Appendix: Mathematical Results and Formulae 10.1 MATHEMATICAL PROPERTIES OF VARIATIONAL BIE 10.1.1 Coupling on a Volume 10.2 PROPER NORM FOR RESIDUAL FORCES 10.3 MATRICES FOR THE REFLECTIONTRANSMISSION ... Abstract Introduction Wave Propagation in a Half-Space 2.1 INCIDENT WAVES BEM Formulation for SH Waves BEM Formulation for P, SV and Rayleigh Waves Observed Amplification in the Mexico City Valley...

Ngày tải lên: 17/08/2013, 11:30

... examined flocculating properties in an effort to develop an effective extraction method for bioflocculants from the microbial cell surface Materials and Methods Activated sludge samples Activated ... Obihiro-South local domestic sewage treatment plant, and stored at 4°C for subsequent experiments All samples were washed times with distilled water before extractions Extraction of microbial polymers ... measured for min, and the relative A660 against the control test was calculated every minute using the following formula: The relative A660 = A660 of flocculating test A660 of control test For the...

Ngày tải lên: 05/09/2013, 09:08

... or for that matter, one “best research design” approach for customer satisfaction measurement In the end, the cost versus the value of the information should dictate CSM form and function for ... ability to track performance over time; identify root causes of systemic problems (prevention); generate ideas for value-added continuous improvement; and, provide tactical information to foster ... Hybrid methods present some interesting alternatives Some companies use hybrid methods to accommodate different sales channels (in-person, phone and web) Hybrid methods may also be used to provide...

Ngày tải lên: 18/10/2013, 12:15

... 264 11 Analytical Methods for Monitoring Biodegradation Processes oriented, and not much attention was paid to the identification of environmental requirements for, and testing of, biodegradable ... appear in an oxidized or reduced form after biodegradation depending on whether the conditions are aerobic or anaerobic, respectively 265 266 11 Analytical Methods for Monitoring Biodegradation ... hydrolysis have been extensively reviewed not only for backbone hydrolysis but also for the hydrolysis of pendant groups [15–17] The necessary elements for a wide range of catalysis, such as acids...

Ngày tải lên: 25/10/2013, 08:20

... Weymouth, 1994] There are large variations in terms of the information stored for each arc Brooks [Brooks, 1985] argues persuasively for the use of topological maps as a means of dealing with uncertainty ... Specifications for the Trak-Star Ultrasonic Speed Sensor Page 13 Part I: Sensors for Mobile Robot Positioning Chapter 1: Sensors for Dead Reckoning the kinematic design closely before attempting ... extended axes for all wheels intersect in a common point (adapted from [Byrne et al, 1992]) Page 16 X Part I: Sensors for Mobile Robot Positioning Chapter 1: Sensors for Dead Reckoning For the sake...

Ngày tải lên: 12/12/2013, 21:16

... Weymouth, 1994] There are large variations in terms of the information stored for each arc Brooks [Brooks, 1985] argues persuasively for the use of topological maps as a means of dealing with uncertainty ... Specifications for the Trak-Star Ultrasonic Speed Sensor Page 13 Part I: Sensors for Mobile Robot Positioning Chapter 1: Sensors for Dead Reckoning the kinematic design closely before attempting ... extended axes for all wheels intersect in a common point (adapted from [Byrne et al, 1992]) Page 16 X Part I: Sensors for Mobile Robot Positioning Chapter 1: Sensors for Dead Reckoning For the sake...

Ngày tải lên: 16/12/2013, 14:15

... routinely provided in the form of declination tables printed directly on the maps or charts for any given locale Instruments which measure magnetic fields are known as magnetometers For application ... replacements for mechanical gyros for over three decades With little or no moving parts, such devices are virtually maintenance free and display no gravitational sensitivities, eliminating the need for ... factor linearity that far surpasses the best mechanical gyros Dithered biasing, unfortunately, is too slow for high-performance systems (i.e., flight control), resulting in oscillatory instabilities...

Ngày tải lên: 22/12/2013, 20:16

... player (provided one is installed on your platform) If you would like to check the video clips, click here for a list and instructions: If you would like to contribute your own material for next ... footprint As is implied by the concentric provide rather poor dead-reckoning circles, considerable slippage must occur in order for the vehicle to information For this reason, skid turn [Everett, ... Detection and Warning System 127 PART II SYSTEMS AND METHODS FOR MOBILE ROBOT POSITIONING Chapter Odometry and Other Dead-Reckoning Methods 130 5.1 Systematic and Non-Systematic...

Ngày tải lên: 22/12/2013, 20:16

... Weymouth, 1994] There are large variations in terms of the information stored for each arc Brooks [Brooks, 1985] argues persuasively for the use of topological maps as a means of dealing with uncertainty ... Specifications for the Trak-Star Ultrasonic Speed Sensor Page 13 Part I: Sensors for Mobile Robot Positioning Chapter 1: Sensors for Dead Reckoning the kinematic design closely before attempting ... extended axes for all wheels intersect in a common point (adapted from [Byrne et al, 1992]) Page 16 X Part I: Sensors for Mobile Robot Positioning Chapter 1: Sensors for Dead Reckoning For the sake...

Ngày tải lên: 19/01/2014, 19:20

... may be required for further development of ISRR technology for the next century References Armarego, E J A and Deshpande, N P., 1989, Computerized predictive cutting models for forces in end-milling ... divisions of the input and output spaces are shown in Figure 16.1, where N is for x1, and for x2 and y The width for each variable is the same µ( x1 ) S2 S1 MD L1 L2 x1− x1+ d µ( x2 ) S3 S2 S1 ... Base A defuzzification strategy is used to determine the output control y for any given input datum There are many methods for defuzzification In this study, the following centroid of area method...

Ngày tải lên: 23/01/2014, 01:20

... complete and put ξ1 := Fully parallel methods for linear PDAEs In this section we study the numerical solution of the following initial boundary value problems (IBVPs) for linear PDAEs: Aut + B∆u = f ... is assumed to be sufficiently smooth We propose two parallel methods for solving the IBVP (5)-(7) where the parallelism will be performed across both the problem and the method According to Proposition ... relation between the total (CPU) time spent on the performance of a program, the speedup and the efficiency of this performance The speedup of the performance is defined as S = Ts /Tp, where Ts (Tp)...

Ngày tải lên: 13/02/2014, 03:20

... player (provided one is installed on your platform) If you would like to check the video clips, click here for a list and instructions: If you would like to contribute your own material for next ... footprint As is implied by the concentric provide rather poor dead-reckoning circles, considerable slippage must occur in order for the vehicle to information For this reason, skid turn [Everett, ... Detection and Warning System 127 PART II SYSTEMS AND METHODS FOR MOBILE ROBOT POSITIONING Chapter Odometry and Other Dead-Reckoning Methods 130 5.1 Systematic and Non-Systematic...

Ngày tải lên: 13/02/2014, 09:20

... in detail the design of efficient explicit methods for non-stiff xiv NUMERICAL METHODS FOR ORDINARY DIFFERENTIAL EQUATIONS problems For implicit methods for stiff problems, inexpensive implementation ... Runge–Kutta methods as general linear methods 503 Linear multistep methods as general linear methods 504 Some known unconventional methods 505 Some recently discovered general linear methods ... 372 General Linear Methods 373 50 51 52 Representing Methods in General Linear Form 500 Multivalue–multistage methods 501 Transformations of methods ...

Ngày tải lên: 13/02/2014, 20:20

Ngày tải lên: 14/02/2014, 00:20

... Practices for Sampling Water,” American Society for Testing and Materials, Philadelphia Methods 330.4 (Titrimetric, DPD-FAS) and 330.5 (Spectrophotometric, DPD) for Chlorine, Total Residual,” Methods ... and may not be reported for regulatory compliance purposes 8.5 As part of the QC program for the laboratory, method accuracy for wastewater samples must be assessed and records must be maintained ... for each parameter using the four results 8.2.5 For each parameter compare s and with the corresponding acceptance criteria for precision and accuracy, respectively, found in Table If s and for...

Ngày tải lên: 14/02/2014, 03:20

... wastewaters for the parameters listed in the scope (Section 1.1), and was used to develop the method performance statements in Section 12 Guidelines for the use of alternate detectors are provided ... concentration for each compound and internal standard, and calculate response factors (RF) for each compound using Equation Equation where: As = Response for the parameter to be measured Ais = Response for ... or falls outside the range for accuracy, the system performance is unacceptable for that parameter Locate and correct the source of the problem and repeat the test for each compound of interest...

Ngày tải lên: 14/02/2014, 03:20

... Observe, listen Provide psychological “first-aid”: • Provide support • Keep families together • Provide information • Reduce arousal ongoing threat/toxins • Assess environment for Foster resilience: ... PhD, National Center for PTSD, VA Palo Alto Health Care System, Menlo Park, California; Department of Psychiatry, Stanford University School of Medicine, Palo Alto, California William E Schlenger, ... University of California, Irvine, Irvine, California Alan M Steinberg, PhD, National Center for Child Traumatic Stress, Department of Psychiatry and Biobehavioral Sciences, University of California, Los...

Ngày tải lên: 15/02/2014, 02:20

... (1963, 1965) for dependent A".- L r TO***"-":- ,,O" - a + A*, -**"c eo%,e"t h,,",,d nes- 16.3 METHODS 16.3.1 Graphical Graphical methods are very useful aids to formal tests for trends The ... Velleman and Hoaglin (1981) e provide a computer d e for this purpase, which is designed for interactive u an a computer terminal They also provide a computer code for "smwthing" time series to ... data in the pth group For example, in the sequence (23, 24, hace, 6, trace, 24, 24, trace, 23) we have g = 3, I, = for the tied value 23, I, = for the tied value 24, end t, = for the three trace...

Ngày tải lên: 18/02/2014, 04:20

... domain This approach provides methods for dealing with the interpersonal, stakeholder, and business process issues that arise in the rapidly changing ERP environment Agile methods provide the means ... current paradigm (high– ceremony methods) are resisted until a new paradigm emerges [53] Some questions are appropriate for these emerging agile methods: § Can these methods be evaluated using the ... “Strategies for Reengineering: Different ways of Initiating and Implementing Business Process Change,” Centre for Research in Information Management, London Business School, 1995 34 Earl, Michael, “Information...

Ngày tải lên: 18/02/2014, 07:20