preparation of cells for lambda red mediated recombination

... sheets were progressively reduced to a uniform final thickness of 1.30 ± 0.03 mm for thin WSN as in Konik (1993) Measurements for gloss and translucency were taken on sheets for raw noodle color and ... cutter) for cooked noodles 146 CEREAL CHEMISTRY Experiment Noodle sheets were progressively reduced to a uniform final thickness of 2.20 ± 0.01 mm for thick WSN as in Crosbie (1992) before cutting ... (VAS) for each of the six samples was measured, the results of the 32 panelists were combined, and the mean scores were compared with instrumental gloss and translucency values Twenty-one of the...

Ngày tải lên: 16/12/2012, 15:25

... appropriate method of statistical analysis The key aspects of measurement scales are considered before going on to examine the attributes of instruments for the measurement of spasticity Level of measurement ... measures of spasticity if the velocity of passive joint movement is consistent, the joint range of movement is not compromised and in the absence of pathologies which may cause other forms of increased ... information related to passive range of movement, few provide a measure of the starting position of the limb or an indication of whether the subject experienced pain during the assessment of...

Ngày tải lên: 01/11/2013, 10:20

... spectrum is softer when pT < GeV/c is required, because of the reduced contribution of ISR Figure (right) shows the comparison of the normalized distributions with the predictions of various simulations ... Italy 28: Also at Faculty of Physics of University of Belgrade, Belgrade, Serbia 29: Also at University of California, Los Angeles, Los Angeles, USA 30: Also at University of Florida, Gainesville, ... also compared to predictions of the HERWIG++ [23] angular-ordered parton shower and cluster hadronization model [24, 25] The UE contributions from MPIs rely on modeling and tuning of the parameters...

Ngày tải lên: 07/03/2014, 17:20

... in GR of types [XC]SUBJ, [XC]PRED, [XC]JCT, [XC]MOD, COMP or XCOMP; • Relative clauses: search for a CMOD where the dependent is to the right of the head; • Bitransitive predicate: search for a ... 18 transcripts with a total of 11,704 words and a mean length of utterance of 2.9, and (B) 23 transcripts with a total of 40,819 words and a mean length of utterance of 7.0 5.2 Results Scores computed ... (precision of 0.6 and recall of 0.5, see table 1) As described in section 2, IPSyn requires that we credit zero points to item S11 for no occurrences of propositional complements, one point for a...

Ngày tải lên: 08/03/2014, 04:22

... widths of 5, 10, 30 and 100 ns, respectively Hence, we can observe that shorter pulse-width would result in the better measured resolution for sensing For a specific RI is estimated by the measured ... pair of scissors According the measured results in Figure 6, when the terminal facet of fiber sensor head has a non-flattened facet, we cannot measure the RI of the chemical sample Therefore, ... the OTDR measured power level with the material RI we are interested in Figure shows the curve for the normalized OTDR measured power level versus material RI Figure Simulation for the normalized...

Ngày tải lên: 14/03/2014, 20:20

... nm of the lattice parameter for the (1 0) plane of quartz [21], q = 3.2 Â 10À19 C for the oxygen ion, and the average thickness of oxide of 12.5 nm as a result of the observation of the fractured ... value of SiO2 is 3.5 nm wider than that of Si Consequently, the SiNW of around 22 nm in diameter in Fig was estimated to consist of the core silicon crystal of 19 nm covered with silicon oxide of ... at the measured temperature Fig is a schematic drawing of the electrical measurement of the SiNW covered with the silicon oxide layer The total resistance, R, is the sum of those of SiNW and...

Ngày tải lên: 16/03/2014, 15:05

... acid Because the etching rate of the top surface of AAO is much slower compared with the etching rate of the side wall of AAO, it is assumed that the top surface of AAO is not etched much To verify ... etching rate of the top surface is much slower compared with the etching rate of the pore of AAO in the pore widening process Fig (a) SEM image of AAO in side view and (b) schematic diagram of the ... etching rate of the top surface of AAO could not be obtained because the surface of the porous-type AAO was very irregular Fig shows the top view and the cross section of AAO measured by AFM The...

Ngày tải lên: 20/03/2014, 13:04

... quality of the financial instrument For example, valuation techniques for derivative instruments reflect the credit risk of the counterparty and the credit risk of the reporting entity (own credit ... consideration of collateral and margining requirements, and the effect of master netting arrangements See Question 10 for a discussion of the inclusion of credit risk in the valuation of financial ... basis for establishing fair value for the offsetting risk positions; and •• apply the bid or ask price to the open net position as appropriate Problems are often encountered by funds as they offer...

Ngày tải lên: 23/03/2014, 11:20

... consists of calculating the range of variation of the estimates for the investigated parameter for increasing numbers of collectors Estimates are computed from repeated combinations of randomly ... estimates of the mean deposition for the sampling month MEASUREMENT OF ATMOSPHERIC DEPOSITION UNDER FOREST CANOPIES 369 with median variation The number of collectors required to achieve convergence of ... pattern of variation of the coefficient of variation for the concentrations of elements with throughfall volumes was observed (Kimmins, 1973; Duijsings et al., 1986); the number of gauges required...

Ngày tải lên: 23/03/2014, 23:20

... rights reserved IFRS for Investment Funds | The effective interest of 19,708 for the irst six months is calculated as: Amortised cost at the beginning of the period of 450,000 EIR of 4.3796% The amortised ... end of the reporting period measured in the functional currency See 6.760 in the 8th Edition 2011/12 of our publication Insights into IFRS for more detail on recognition of dividend income Foreign ... interest income for the period Current rate for the period Principal receivable on maturity Amortisation of a discount Amortisation of transaction costs Interest income The treatment of an acquisition...

Ngày tải lên: 30/03/2014, 03:20

... Leadership Professor of Nursing and Professor of Sociology, and Director of the Center for Health Outcomes and Policy Research, University of Pennsylvania STUART H ALTMAN, Sol C Chaikin Professor of National ... Madison Professor of Political Economy and Professor of Economics and Public Affairs, Princeton University SHOSHANNA SOFAER, Robert P Luciano Professor of Health Care Policy, School of Public ... standardized system for translating the extent of an injury of a body part into a percentage of disability of the whole person This type of system has been used for the assessment of compensation...

Ngày tải lên: 30/03/2014, 12:20

... attributed to the uncertainty of the slope of Raman-measured temperature vs laser power (dT Raman /dP), which accounts for 50–70% of the total uncertainty in thermal conductivity; for those very thin films, ... increase for the ∼20-nm films may provide an insight into the roles of surface scattering and grain boundary scattering for reducing the inplane thermal conductivity of Bi films The measured in-plane ... conductivity of Bi films The inset plots the measured temperature vs absorbed laser power for the 85-nm film, and the black solid line is a linear fit The inset pictures are atomic force microscope images of...

Ngày tải lên: 06/05/2014, 08:54

... contact resistance Since the formation of low resistance contacts is required for the continued development of nanoelectronics, additional innovative techniques capable of systematically measuring ... Estimates of contact resistance have also been derived from a variety of atomic force microscope (AFM) techniques [7, 23–29] In spite of the published work on CNTs, a clear understanding of the ... uniform along the length of the MWCNT We also assume that rCNT is not altered by the deposition of metal atoms These assumptions suggest that our contact resistance model is more appropriate for...

Ngày tải lên: 06/05/2014, 08:54

... effect of the laser energy instability, the fluence of each laser shot is measured The experimental data are accepted when the measured laser fluence has the desired value To eliminate the effect of ... energy instability The surface of the sample shows little change from shot to shot for the range of laser fluences used in this experiment Planck’s distribution of blackbody radiation intensity ... equation, W is the impedance of the oscilloscope ͑50 ⍀͒, ␶͑␭͒ the spectral transmission of the lenses and filters, D(␭) the responsivity of the germanium diode ͑in units of A/W͒, ⑀Ј͑␭,␪,␾,T͒ the directional...

Ngày tải lên: 06/05/2014, 08:54

... the centre of the hole 10 mm from the toe end of the weld -76 108 -25 4’ the centre of the hole 12 mm from the toe of the weld -23 33 5’ the centre of the hole 12 mm from the toe end of the weld ... through the centre of the rosette The production of the hole in the stressed component causes a redistribution of strains to occur near the hole, which can be detected and measured by the surface ... holding for a period of hour and cooling back to room temperature Measurements of the movement of the lacing members using dial gauges during the procedure showed a maximum variation of 0.6-0.7...

Ngày tải lên: 17/05/2014, 15:28

... degrees of browning inhibition obtained in plugs treated with different levels of sulfite or ascorbic acid and then stored for different periods of time (Table 3) Inhibition data for Red Delicious ... effectiveness of SO2 in Table l-Reflectance characteristics of cut surfaces of plugs from opposite sides of Red Delicious and Siayman apples undergoing browning at 20°C L Cultivar Red Delicious ... Hunter L, a, b and CIE Y, X, Z values were measured for plugs taken from fruits for each of apple cultivars (Cortland, Granny Smith, Idared, McIntosh, Red Delicious and Stayman) over a hr period...

Ngày tải lên: 18/05/2014, 20:15

Ngày tải lên: 21/05/2014, 09:34

... point of view, zones of ship structure The residual stresses were measured after welding and in the process of fatigue loading of welded elements using the UltraMARS system [9] The RS were measured ... a total of 303 points with 21 residual stress profiles studied Specimens and Welded Panel for Residual Stress Measurements The measurements of welding residual stress were performed for and 15 ... transducer is used for excitation and receiving of ultrasonic waves is often called pulse-echo method (Fig 4a) This method is effective for analysis of residual stresses in the interior of material...

Ngày tải lên: 24/05/2014, 20:32

... filtered influx-constant images J Nucl Med 1996, 37:371-374 Figure Coronal images of the measured tumor volumes Coronal images of the measured tumor volumes derived from SUV and Patlak images of ... feedback for further research during the study, and approved the final submitted version of this manuscript Acknowledgments This study was performed within the framework of the Center for Translational ... Example images of the measured tumor volumes derived from SUV and Patlak images are shown in Figure Exceptions were VOIA70 for both types of cancer and the two gradient-based methods for GI cancer...

Ngày tải lên: 18/06/2014, 18:20