motor speed control arduino

Ngày tải lên: 18/12/2013, 22:06

... root-locus domain. Mechatronics Kevin Craig DC Motor / Tachometer Closed-Loop Speed Control System 24 Mechatronics DC Motor / Tachometer Closed-Loop Speed Control System 1. Introduction This ... well-behaved speed- torque characteristics, and adaptability to various types of control methods. DC motors are classified as either integral-horsepower motors (≥ 1 hp) or fractional-horsepower motors ... power amplifier. Motor speed is measured using an analog tachometer. Figure 2. Physical System Mechatronics Kevin Craig DC Motor / Tachometer Closed-Loop Speed Control System 5 Most...

Ngày tải lên: 25/01/2014, 13:20

Ngày tải lên: 17/12/2013, 14:15

Ngày tải lên: 28/12/2013, 22:07

...  Overview of Gas Springs 2 . 21369 . 2007 . 1  Speed Control TM « SPC Gas Springs, cushioned 2486.12. FIBRO SPC Gas Springs Speed Control TM « are designed to reduce or eliminate the ... caused by the increased return travel speed in high speed presses (link drive presses). SPC Gas Springs feature an integral return travel delay which reduces the speed of the gas spring to 0.4 m/s ... 2 . 21370 . 2007 . 1  3 Speed Control TM « SPC Gas Springs, 2486.12. cushioned subject to alterations Force in daN at Piston...

Ngày tải lên: 22/01/2014, 02:20

Ngày tải lên: 16/03/2014, 12:20

Ngày tải lên: 21/06/2014, 17:20

Ngày tải lên: 29/06/2014, 09:20

... 3.1. The basic control format In essence, we are endeavoring to design a controller that can vary the torque induced in the rotor of the motor. To do this, the induction motor controller will ... for an induction motor An induction motor is an asynchronous AC (alternating current) motor. The least expensive and most widely used induction motor is the squirrel cage motor. The major ... 6.10. The speed response of the control system where the proportional gain of the speed controller is increased As you can see, the transient response is faster as it follows the speed command...

Ngày tải lên: 27/10/2013, 23:15

Ngày tải lên: 13/12/2013, 00:56

Ngày tải lên: 13/12/2013, 03:40

Ngày tải lên: 25/12/2013, 05:17

... Inc. BACK EMF CONTROL METHOD The back electro-magnetic-force (EMF) or sensorless motor control method obtains the speed and position of the motor directly from the voltage at the motor windings. ... stable, reliable and cost-effective control system. Further details on motor control circuits and sensors are provided in several books, including Motor Control Electronics” (10). In addition, ... Parekh, Rakesh, “AN889 - VF Control of 3- Phase Induction Motors using PIC16F7X7 Microcontrollers”, Microchip Technology Inc., 2003. 10. Valentine, Richard, editor, Motor Control Elec- tronics Handbook”,...

Ngày tải lên: 03/01/2014, 18:55

... Operation modes of buck boost converter 2 Unlike constant -speed control, a variable -speed control can adjust the speed of the turbine as the wind speed changes, so as to operate at the peak of the ... proposed MPPT control method. Fig.7: Wind turbine output power without MPPT control method for low wind speed. Fig.8: Wind turbine output power with MPPT control method for low wind speed. ... low wind speeds. Fig.9 : Wind turbine output power without MPPT control method for high wind speed. Fig.10 : Wind turbine output power with MPPT control method for high wind speed. ...

Ngày tải lên: 03/01/2014, 19:15

... converter LOAD P electSpeed Duty ratio VSWT Aero dynamical / Mechanical unit MPPT LPPT Operator Controller speed d Control strategy VSWT Control unit VSWT Electrical unit Fig. 1. Control concept ... power in above rated wind speeds. This control acts directly upon an additional hydraulic system and is very important to protect the blades from breaking. The speed control algorithm serves ... two optimum wind turbines power/torque versus speed characteristics. Two control loops: inner feed forward current control loop and outer voltage control closed loop are applied for the non-inverting...

Ngày tải lên: 03/01/2014, 19:15

Ngày tải lên: 03/01/2014, 19:44

Ngày tải lên: 03/01/2014, 19:44

... Block Indirect torque control method of BLDC motor explained in [9] was extended to a direct torque and indirect flux control technique for six-switch inverter BLDC motor in [7] which is suitable ... equation (6) eliminates the speed term in the denominator which causes problem at zero and near zero speeds. 2.3 Control of Stator Flux Linkage Amplitude Since BLDC motor does not have sinusoidal ... conduction DTC of BLDC motor drive with six-switch inverter scheme. Keywords: Brushless dc (BLDC) motor, sliding mode observer, direct torque control (DTC), stator flux control, fast torque...

Ngày tải lên: 03/01/2014, 19:45

... programming-based control of brushless motors,” IEEE Trans. Control Syst. Technol., vol. 11, no. 1, pp. 139–146, Jan. 2003. [19] S. J. Kang and S. K. Sul, “Direct torque control of brushless dc motor with nonideal ... force (EMF), position-sensorless control, stator flux control, torque pulsation. I. I NTRODUCTION T HE permanent-magnet synchronous motor (PMSM) and brushless dc (BLDC) motor drives are used extensively ... instantaneously controlled by the torque controller using the integral variable structure control (IVSC) and the space-vector PWM (SVPWM). However, this technique increases the complexity of the control system. The...

Ngày tải lên: 03/01/2014, 19:46

... only the torque is controlled without speed control, the time range of control system under transient state is selected short. The motor speeds up to a very large value if the motor is run longer ... voltage, hysteresis bandwidth, motor parameters especially the winding inductance, motor speed, snubber circuit, and the amount of load torque The best way to control the stator flux linkage ... required for the proposed control scheme. Specifically, it is shown that rather than attempting to control the stator flux amplitude in two-phase conduction DTC of BLDC motor drive, only the electromagnetic...

Ngày tải lên: 03/01/2014, 19:46