memetic method for passive filters design

... change wheel: A new method for characterising and designing behaviour change interventions Susan Michie1*, Maartje M van Stralen2 and Robert West3 Abstract Background: Improving the design and implementation ... constitute a starting point for Page of 11 assessing in what circumstances different types of intervention are likely to be effective which can then form the basis for intervention design There exists ... intervention designers not use existing frameworks as a basis for developing new interventions or for analysing why some interventions have failed while others have succeeded One reason for this...

Ngày tải lên: 10/08/2014, 10:23

... performance may be even better For example, if the allpass VFD filter is designed again with p ∈ [−0.65, 0.35] for both LS design and minimax design, the absolute errors of group-delay for LS design ... in (29) Method Deng’s method in Section 2, W(ω) = 1, p ∈ [−0.5, 0.5] Lee, Caccetta, and Rehbock’s method [23], LS design, p ∈ [−0.5, 0.5] Proposed LS design, p ∈ [−0.5, 0.5] Proposed LS design, ... Rehbock’s method [23], WLS design, p ∈ [−0.5, 0.5] Proposed minimax design, p ∈ [−0.5, 0.5] Proposed minimax design, p ∈ [−0.65, 0.35] ετ2 (%) 0.242 ετ 0.03145 εθ2 (%) 0.001205 εθ 0.0001788 Design...

Ngày tải lên: 21/06/2014, 07:20

Ngày tải lên: 24/12/2013, 12:16

... Fahrenheit for liquid and vapor/steam -PRESSURE degrees Rankine = °F + 460 for gas PSIA for gas and vapor LIQUID SPECIFIC GRAVITY VAPOR/STEAM SPECIFIC GRAVITY Gb at 60 F (Gb for water ... NORMAL: For square-edge and ASME small-bore this should be the mid-range dp value, which equals 707 × (full-scale flow rate) 1/3 FS: For liquid use BPD, BPH, GPM, or GPH For vapor use lbs/hour; for ... radius, corner or pipe for square-edge Flange or corner only for ASME small-bore Flange for quadrant-edge PIPE INSIDE DIAMETER Use decimal places ORIFICE DIAMETER Entered for orifice re-ranging...

Ngày tải lên: 12/03/2014, 16:43

... ) = for k ≠ ⎩ Digital Filters Design for Signal and Image Processing ⎧ u ( k ) = for k ≥ ⎪ Unit step signal: ⎨ ⎪u ( k ) = for k < ⎩ ⎧ r ( k ) = k for k ≥ ⎪ Unit ramp signal: ⎨ ⎪r ( k ) = for ... Digital Filters Design for Signal and Image Processing This page intentionally left blank Digital Filters Design for Signal and Image Processing Edited by Mohamed ... of the ROC of its z-transform Xz (z) 10 27 28 Digital Filters Design for Signal and Image Processing 2.2.2 Properties of the z-transform 2.2.2.1 Linearity The z-transform is linear Actually,...

Ngày tải lên: 05/06/2014, 12:05

... limited risks may not require a collapse control design method; only a conventional design method will be selected in these cases Further at this stage of design, the potential scale of column member ... fire-resistant design methods 3.2.2 Basic Design The basic design work takes into account the scale of the members to be lost At this stage, it is important to proceed with the design work in ... selection of fire protection, the present design method requires that the design work be carried forward by accepting suggestions offered by fire-resistant design engineers In order to enhance the...

Ngày tải lên: 28/06/2014, 13:49

... Analytical Methods Numerical Methods Moving Element Methods Disk Model 1.3 Objectives and Scope 1.4 Layout of Thesis METHODOLOGY AND FORMULATION 2.1 Formulation of Plate in the Polar Coordinates 2.2 Formulation ... latter case is different from the former not only in the addition of centrifugal force but also Coriolis effect Therefore, it is only a good approximation for former case of disk rotating at very ... Recommendations for Future studies 97 97 99 REFERENCES 100 APPENDIX 103 iii Summary Moving Element Method (MEM), a new method that incorporates moving co-ordinates into the well-known Finite Element Method...

Ngày tải lên: 16/09/2015, 15:43

... Review Robotic design 2.1.1 Guideline for robotic design 2.1.2 Workspace specification 2.1.3 Computer-aided design for robotics design 2.2 Surgical ... the design centric approach for medical device design vii List of Tables List of Tables TABLE I DENAVIT-HARTENBERG TABLE FOR FICTITIOUS LINKS 28 TABLE II DENAVIT-HARTENBERG TABLE FOR ... exists for a given task Workspace analysis specific to the needle insertion manipulator will be discussed in Section 4.1 2.1.3 Computer-aided design for robotics design Computer-aided design...

Ngày tải lên: 04/10/2015, 15:46

... [run_before] = TotalZeros), it is not necessary to encode any more run_before values (b) It is not necessary to encode run_before for the final (lowest frequency) non-zero coefficient The VLC for ... performance analyzer or PAPI, a tool that allows access to the performance hardware counters of the processor for measuring clock cycle [18] Function-level information can also be collected for ... these tools, a complexity evaluation methodology for video applications that is platform 22 independent is also proposed in [25] In its methodology, the platform-independent complexity metric used...

Ngày tải lên: 16/10/2015, 15:36

... Learning Vector Quantization 6.4 SelfOrganized Maps Conclusions and Further Research Performance of modern techniques for rating model design Introduction Credit risk forecasting is one of the leading ... results Some recent studies (see[4] for a review of all methods applied in rating methodologies) use both methods and choose the one with the best out-of-sample performance, to avoid problems of sample-specific ... Statistical Methods Interaction Performance of modern techniques for rating model design 14 6.1 Multilayer Perceptron Multilayer Perceptron is the most popular static network and the starting point for...

Ngày tải lên: 16/04/2013, 20:00

... technique for pilot estimation combined with wavelet denoising 5.8 MSE performance for channel estimation based different interpolation 114 technique using MMSE for pilot estimation 5.9 MSE performance ... the study and methodology were formed for this research, as follows: Review of previous literature pertaining to available techniques of channel estimation for the OFDM system for solving the ... performance based on QPSK Modulation 83 4.4 The OFDM systems performance based on DBPSK Modulation 85 4.5 The OFDM systems performance based on DQPSK Modulation 87 4.6 The OFDM systems performance...

Ngày tải lên: 26/05/2013, 21:28

... mention at this point that all music presented for study on these pages is original and has been created especially for the guitar EACH composition has been designed to advance the student's musical ... explained If further information is desired, some very excellent music dictionaries in soft cover editions can be obtained at a small cost.) I feel, however, that with this method, (as with all ... Do not skip or "slight" anything, and also not attempt to "completely perfect" any one lesson before going on Playing technique is an accumulative process and you will find each time you review...

Ngày tải lên: 16/08/2013, 08:28

... SECTION MOST IMPORTANT FOR NOW IS THE PHYSICAL ABILITY TO PERFORM THEM AND EVENTUAL MEMORIZATION OF ALL FORMS, CHORD TYPES AND ROOT LOCATIONS NOTE THAT THESE ARE THE SAME FORMS AS THOSE SHOWN ... This book is a continuation of Volume I, Modern Method for Guitar Most of the terms and techniques are directly evolved from material presented there For example, the entire fingerboard is covered ... inquisitive student and maybe shed some light into the mysterious workings of music for guitar players in general As before, good luck and have fun William G Leavitt ALL SCALES (MAJ and MIN etc )...

Ngày tải lên: 16/08/2013, 08:28

... sludge Nevertheless, quantitative PCR method for Candidatus ‘Accumulibacter phosphatis’ has not been developed yet In this study, quantitative PCR method for Candidatus ‘Accumulibacter phosphatis’ ... quantitative PCR was 1.0 % for Ct value and 11 % for the calculated copy numbers, respectively (n=6) Variation in quantitative PCR only was 0.78 % for Ct value and 7.5 % for the calculated copy ... primers were designed for quantitative PCR as shown in Table Sequence of PAO651f is the reverse complement sequence of PAO651 probe Sequence of PAO846r is the same sequence of PAO846 probe For the...

Ngày tải lên: 05/09/2013, 09:38

... checklist for noise inspection can be used with a high reliance before of noise measuring without necessity to use the instrument in workplaces Therefore, this method is a proper rapid method for exploiting ... screening is a common method for early investigations for separation of study popular (8-12) The Propose of this study was to submit a simply scientifically screening method for inspection of noise ... investigation was compared The suggested method can be used for recognition step of noise assessment in large scale investigations This method is a proper way for exploiting and reducing the expenses...

Ngày tải lên: 05/09/2013, 13:23

... 4.4 Design criteria Some criteria must be considered when designing this kind of cooling systems 4.4.1 Design of direct evaporative coolers The main parameter considered when evaluating the performance ... similar conditions to the ones established for the semi-indirect evaporative recover made of ceramic pipes introduced before This test has been performed for outside air temperature of 40 C, 18 ... of the adiabatic tunnel described before To clarify what has been exposed before, the evolution of an air stream originally at 25ºC and 30% of RH is described for different cases of water temperature...

Ngày tải lên: 05/09/2013, 16:10

... In addition, the beam can be concentrated for accelerated testing Obviously, there are different standards describing the method of solar simulators design However they are similar, these standards ... points for maximum electrical output for an area of inch in diameter were determined However most researchers have focused on relatively small scale solar simulators in order to achieve a uniform ... 2011 [4] Standards For Simulators Can Vary Widely Solar industry, http://www.solarindustrymag.com Accessed on February 27, 2011 [5] Kohraku S and Kurokawa K., "New methods for solar cells measurement...

Ngày tải lên: 05/09/2013, 16:10

... note that for the overall system, the first choice should be to reinforce two tie lines instead of increasing the generating capacity of the multi-area system coNcLusIoNs A new method for multi-area ... One 800 MW generator with FOR= O.18 is added and the annual peak load is increased to 3575 Mw Area 4: One 800 MW generator with FOR= O.18 and one 600 MW generator with FOR= 0.15 are added and the ... perceived load forecast UnU1 Pnl unu2 Pn2 * * - * * * ' n'n n *U I (6) where U is the standard deviation for the ith area load dertainty usually, the same standard deviation is assumed for all...

Ngày tải lên: 03/01/2014, 19:35

... Choice of a Transformation Matrix Parallelepiped method H = C, [r] = (H −1 C)[0, 1]n + H −1 [e] = [0, 1]n + C −1 [e] This method breaks down when C is close to singular QR-factorization method C = ... series + remainder term • The method does not impose restrictions on the size of the initial box • An automatic differentiation package for computing Taylor coefficients for the solution to Y = A(t)Y ... − 1)[e0 ] [e] = j=1 For all yi ∈ { b0 + Bα | α ∈ [0, 1]n }, n y(ti+1 ; ti , yi ) ∈ w0 + αj (wj − w0 ) | αj ∈ [0, 1], wj ∈ [wj ] j=1 ⊆ c0 + Cα + [e] | α ∈ [0, 1]n , 12 since for α ∈ [0, 1]n , wj...

Ngày tải lên: 12/01/2014, 22:02

... scenarios demonstrate the necessity for study and development of validated methods for both verification and design of modern control strategies 4 C Validated Techniques for the Solution of Initial Value ... yapp,2,1 = The iteration formula (7) is now evaluated for m xapp (t) = ∑ j=0 yapp,1, j (t) yapp,2, j (t) , (22) where m = for Case and m = for Case The interval enclosures for all state variables ... nonlinear terms — for the initial conditions y0 app,0 = xapp and yapp, j = 0, ∀ j ≥ Now, the iteration (7) is performed with the improved approximation xapp (t) for ε = which is demonstrated for the simple...

Ngày tải lên: 12/01/2014, 22:04