low power design through voltage scaling

... to proposals on other levels in the design flow and to future work. Keywords: Low- power design, dynamic power reduction, leakage power reduction, ultra- low- V th devices, multi-V dd , multi-V th , ... Pacific Design Automation Conference 2003, pp. 400-403. [20] K. Usami, M. Horowitz, Clustered Voltage Scaling Technique for Low- Power Design, Proceedings of the International Symposium on Low Power ... had to be chosen. An ultra -low V th device with about 150mV threshold voltage proved to be the best 6 TLFeBOOK Chapter 1 ULTRA -LOW- POWER DESIGN: DEVICE AND LOGIC DESIGN APPROACHES Christoph...

Ngày tải lên: 01/06/2014, 11:43

Ngày tải lên: 22/06/2014, 19:20

Ngày tải lên: 22/06/2014, 22:20

Ngày tải lên: 23/06/2014, 01:20

Ngày tải lên: 01/07/2014, 11:20

... Click OK để thực hiện 13 Power Designer Tạ Thúc Nhu 26 Power Designer Tạ Thúc Nhu GIỚI THIỆU POWER DESIGNER : Power Designer là 1 công cụ thiết kế CSDL. Với Power Designer bạn có thể : • Thiết ... nghiã các thuộc tính mở rộng có các đối tượng PDM. Khởi động Power Designer: Start/All Programes/SyBase/ Power Designer Trial 11/ Power Designer Trial  Object Browser Window: hiện nội dung của ... Workspace là tên của PowerDesigner session hiện hành. CDM mới sẽ được mở và lưu trong workspace.  Output Window: hiển thị progression của các process mà bạn chạy từ PowerDesigner, Ví dụ tiến...

Ngày tải lên: 14/09/2012, 09:17

... obtain large variable gain ranges under low supply voltage. II.2 Comparison of the commonly used VGA structures The design requirements impose challenges on low power consumption, very large bandwidth, ... the voltage headroom occupied by the gate source voltage of M 2 , the saturation voltage of the NMOS transistor to generate the tail current for the differential pair, and the saturation voltage ... saturation voltage of the PMOS bias transistor to generate 2I D1 current; V DSAT2 is the saturation voltage of M 2 ; V thn is the threshold voltage of M 2 ; V DSATbn is the saturation voltage...

Ngày tải lên: 06/11/2012, 10:26

Ngày tải lên: 05/09/2013, 15:28

Ngày tải lên: 05/09/2013, 16:10

... LOW VOLTAGE 20 100 MAX481-07 OUTPUT LOW VOLTAGE (V) OUTPUT CURRENT (mA) 6 60 40 24 80 10 12 140 -120 0 -7 -5 -1 5 OUTPUT CURRENT vs. DRIVER OUTPUT HIGH VOLTAGE -20 -80 MAX481-08 OUTPUT HIGH VOLTAGE ... CURRENT vs. RECEIVER OUTPUT LOW VOLTAGE 5 25 MAX481-01 OUTPUT LOW VOLTAGE (V) OUTPUT CURRENT (mA) 1.5 15 10 0.5 1.0 2.0 20 35 40 45 0.9 0.1 -50 -25 25 75 RECEIVER OUTPUT LOW VOLTAGE vs. TEMPERATURE 0.3 0.7 TEMPERATURE ... MAX481/MAX483/MAX485/MAX487/MAX1487 Typical Half-Duplex RS-485 Network Low- Power Shutdown Mode (MAX481/MAX483/MAX487) A low- power shutdown mode is initiated by bringing both RE high and DE low. The devices will not shut down unless...

Ngày tải lên: 22/12/2013, 14:15

... This page was exported from - Retail Design Blog Export date: Fri Feb 8 11:01:51 2013 / +0000 GMT Output as PDF file has been powered by [ Universal Post Manager ] plugin from ... Page 8/18 | This page was exported from - Retail Design Blog Export date: Fri Feb 8 11:01:51 2013 / +0000 GMT Output as PDF file has been powered by [ Universal Post Manager ] plugin from ... exported from - Retail Design Blog Export date: Fri Feb 8 11:01:51 2013 / +0000 GMT JaguarShoes Collective is an arts organization that collaborates with illustrators, designers and brands...

Ngày tải lên: 23/03/2014, 04:20

... each VP rule which introduces a VP complement, allowing the verb to be lowered onto the complement. As this rule must also expand VPs with verbs lowered onto them, we want e.g. cii) vPlz -> ... (I) will apply to all three of (B) - (D), allowing compound verbs to be discharged at any point. (II) will apply to (B) and (C), allowing the lowering (with compounding if needed) of verbs ... Even in the weakest augmentation, allowing only one occurence of one variable over sequences in any constituent of any rule, the apparent similarity of their power remains to be formally established,...

Ngày tải lên: 24/03/2014, 01:21

... with low concentration of spin labels should be detected. At low concentration of spin labels where high receiver gain is required to obtain a spectrum of good quality, it is difficult to follow ... that at low microwave power the variance of the EPR signal would be minimum over the whole field scan at the out-of-phase setting, the correct phase angle can be calculated from two high -power spectra ... nucleotide reported disorder. The low- angle X-ray diffraction patterns were modified by AdoPP[CH 2 ]P in insect flight muscle; the ratio of the two inner equatorial peaks was lowered when the concentration...

Ngày tải lên: 24/03/2014, 03:21

... simulation module. ASIC DESIGN FLOW 5 Idea SynthesisSimulation Design description Physical design Figure 1.4 Major activities in ASIC design. The design is tested through a simulation process; ... 8 INTRODUCTION TO VLSI DESIGN 1.4.5 Physical Design A fully tested and error-free design at the switch level can be the starting point for a physical design [Baker & Boyce, Wolf]. ... circuit, one goes through the physical design process. The same constitutes a set of activities closely linked to the manufacturer and the target technology 1.4.1 Design Description The design is...

Ngày tải lên: 01/04/2014, 17:37

... 15. Reset Logic Notes: 1. The Power- on Reset will not work unless the supply voltage has been below V POT (falling). 2. V BOT may be below nominal minimum operating voltage for some devices. For ... Condition Min Typ Max Units V POT Power- on Reset Threshold Voltage (rising) 1.4 2.3 V Power- on Reset Threshold Voltage (falling) (1) 1.3 2.3 V RST RESET Pin Threshold Voltage 0.1V CC 0.9V CC t RST Minimum ... Time from Power- down and Power- save Additional Delay from Reset (V CC = 5.0V) Recommended Usage 00 18 CK – BOD enabled 01 18 CK 4.1 ms Fast rising power 10 18 CK 65 ms Slowly rising power 11...

Ngày tải lên: 15/04/2014, 14:32

... potential role for low- power laser across differ- ent constructs. However, this study d id define the need for additional biomechanical research to identify the role for low- power laser across ... Mayayo E: Bone fracture consolidate faster with low power laser. Lasers Surgical Medicine 1987, 7(1):36-45. 19. Yamada K: Biological effects of low power laser irradiation on clonal osteoblastic ... indicate that low power laser irradiation can enhance biomechanical properties of bone during fracture healing in animal models. Maximum bone tolerance was statistically improved following low level...

Ngày tải lên: 20/06/2014, 04:20

... and the design in [13] is the slowest full a dder. Proposed low power dynamic carbon nanotube full adder is 46% slower than the design in [15], 1 2% slower tha n the design in [6], 39% slower than ... in [6], 81% lower than the design in [13], 82% lower than the design in [14], and 3% lower than the design in [15]. Proposed multi-output dynamic full adder is 7% slower than the design in [6], ... the design in [13], 36% slower than the design in [14], and 43% slower than the design in [15]. This proposed full adder consumes 91% less power than the design in [6], 78% less than the design in...

Ngày tải lên: 21/06/2014, 00:20

... ultra -low- power image compressor for capsule endoscope,” BioMedical Engineering Online, vol. 5, article 14, 2006. [15] X. Xie, G. Li, X. Chen, X. Li, and Z. Wang, “A low- power digital IC design ... compressor has lower area and lower operation frequency. It can fit into the existing designs. Table 7: The comparison results with existing works. Area Frequency (MHz) Power (mW) Supply voltage (V) GICam ... pages doi:10.1155/2011/257095 Research Ar ticle A Subsample-Based Low- Power Image Compressor for Capsule Gastrointestinal Endoscopy Meng-Chun Lin 1 and Lan-Rong Dung 2 1 Department of IC Design, Avisonic Technology Corporation,...

Ngày tải lên: 21/06/2014, 07:20

... will follow, we assume that the duration of idle intervals, for channel i, is modeled as a geometric random variable with parameter q i : Pr  idle i = K  =  1 − q i  K−1 q i . (2) Following ... algorithm. with the highest Gittins index will be selected in the following transmission attempt. Since the traffic parameters typically slowly change over time, the channel selection algorithm should ... recorded, and the SA node tries to use another channel. Otherwise, the node transmits its packet. Following the traffic model, the probability that the transmitted packet of size L is not corrupted by...

Ngày tải lên: 21/06/2014, 22:20