low power clustering with minimum logic replication

... in CGD/Cox for various TFET structures with metal gate: (1) TFET with gradual drain doping profile, (2) TFET with abrupt drain doping profile; (3) TFET with offset drain having a gradual doping ... and GeSn after 400 ° activation Lower RSh is achieved in GeSn as C compared with that in Ge Better phosphorus activation is achieved in GeSn as compared with Ge at low temperature, i e 400 ° ... ITRS 10 10 Static Power 0.1 1995 2000 Year (a) 2005 2010 Year (b) 2015 -1 10 Dynamic Power -3 10 2015 Normalized Power (W/m) 0.35 m Technology Node Physical Gate Length Power Supply Voltage...

Ngày tải lên: 10/09/2015, 09:24

... implemented with CMOS logic due to its low power consumption These two design features of the functional circuits thereby result in switching activities with low power consumption More on CMOS logic ... units: one with fast performance and high power consumption and another with slow performance and low power consumption Both CHAPTER INTRODUCTION are used to execute instructions, but slow functional ... and another with slow performance and low power consumption Both are used to execute instructions, but slow functional units are used whenever possible, for the reason of reducing power consumption...

Ngày tải lên: 16/09/2015, 14:04

... a high speed low power flash ADC with fully dynamic comparators For flash ADC design, fully dynamic comparator offers several very desirable attributes, like high speed and low power consumption ... source follower 50 Figure 4.9 Replica biasing for the source follower 52 Figure 4.10 Source follower with sampling switch and capacitor 53 VIII Figure 4.11Simulated output power ... DACs) that can keep up with the digital world yet still maintains other desirable attributes like low power consumption and small chip area With shrinking of available power Chapter Introduction...

Ngày tải lên: 04/10/2015, 10:26

... complementary differential pairs with source degeneration, a current gain stage with programmable current mirror, and resistor loads is designed for high frequency and low power communication applications, ... pair with source degeneration and the low impedance internal nodes in the current gain stages In addition, common-mode feedback is not required because of these low impedance nodes Due to the power ... receiver consists of a VGA between the low pass filter and the ADC (VGA2 as shown in Fig 1.1) This VGA must attain a wide bandwidth (250MHz) with minimum noise and power consumption In addition, due...

Ngày tải lên: 06/11/2012, 10:26

... with blades; (c) tubular propeller with blades; (d) propeller with volute; (e) PAT The flow inside each engine is described in Figure For the positive displacement rotational turbine (PD), flow ... displacement (PD); (b) tubular propeller with blades; (c) tubular propeller with blades; (d) propeller with volute; (e) PAT For the PAT and remaining propellers, flow enters without large constraints, from ... interesting solution with less variation of discharge, when installed in water supply systems, as the liquid is an almost incompressible fluid with steady flow conditions most of the times (with a constant...

Ngày tải lên: 05/09/2013, 15:28

... through the module [4] When the input power is too low, the Peltier effect is weak, resulting in a low dehumidifying rate On the contrary, when the input power is too high, the Joule effect is ... experiment, when the input power was 6.0 W, the dehumidifying period reached the minimum of 120 In contrast, for the input powers lower or higher than 6.0 W, the dehumidifying period showed an increasing ... different input powers of the thermoelectric module It can be seen the dehumidifying period depends strongly on the input power of the thermoelectric module In this experiment, when the input power was...

Ngày tải lên: 05/09/2013, 16:10

... MAX485/MAX490/MAX491/MAX1487 Transmitting a 150kHz Signal Low- Power Shutdown Mode (MAX481/MAX483/MAX487) A low- power shutdown mode is initiated by bringing both RE high and DE low The devices will not shut down unless ... vs TEMPERATURE 400 OUTPUT HIGH VOLTAGE (V) OUTPUT LOW VOLTAGE (V) MAX481-13 SUPPLY CURRENT (µA) MAX481/MAX483/MAX485/MAX487–MAX491/MAX1487 Low- Power, Slew-Rate-Limited RS-485/RS-422 Transceivers ... when DE is low If the driver outputs are enabled, the parts function as line drivers While they are high impedance, they function as line receivers if RE is low 5 DI Driver Input A low on DI forces...

Ngày tải lên: 22/12/2013, 14:15

... publication has been drafted in accordance with the ISO/IEC Directives, Part IEC 60502 consists of the following parts, under the general title Power cables with extruded insulation and their accessories ... contact with earth or an earth conductor is disconnected from the system within min; Category B: this category comprises those systems which, under fault conditions, are operated for a short time with ... an inner covering is applied, its thickness need not comply with 7.1.3 or 7.1.4 7.3 Cables with rated voltage 1,8/3 (3,6) kV Cables with rated voltage 1,8/3 (3,6) kV shall have a metallic layer...

Ngày tải lên: 25/12/2013, 11:08

... useful to escape from a bad local minimum and reach a better one As a rule, however, large distortion kills clustering performance as shown in the figure Although clustering is heavily case-dependent, ... ≥ γ −1 Ψ −2 where < γ

Ngày tải lên: 20/02/2014, 05:20

... 0.05) Compared with the EM model with the manually designed first-order feature (the second line), the ILP-based EM solution also yields better performance in precision (with a slightly lower recall) ... a lower recall (2.9%), than MP As a result, we only see ±0.4% difference between the F-measure The results are consistent with the reports by Luo et al (2004) that the entity-mention model with ... the table summarizes the performance of the systems with ILP We were first concerned with how well ILP works for the mentionpair model, compared with the normally used algorithm C4.5 From the results...

Ngày tải lên: 20/02/2014, 09:20

... in AI is Markov Logic (Richardson and Domingos, 2006), a combination of firstorder logic and Markov Networks It can be understood as a formalism that extends first-order logic to allow formulae that ... paper is organized as follows: Section describes temporal relation identification including TempEval; Section introduces Markov Logic; Section explains our proposed Markov Logic Network; Section ... through the addition of weighted first order logic formulae Using Markov Logic instead of an ILP-based approach has at least two advantages First, it allows us to easily capture non-deterministic...

Ngày tải lên: 08/03/2014, 00:20

... (k) − hj (k))2 hi (k) + hj (k) (1) Spectral Clustering Spectral clustering is a powerful way to separate non-convex groups of data Spectral methods for clustering are a family of algorithms that ... the data, embedding the data into this lowdimensional manifold, and finally applying traditional clustering techniques (i.e k-means) to it Consider a graph with a set of n vertices each one representing ... meta senses, without a clear trend clusters (Sch¨ tze, 1998), but may be due to the u spectral clustering Inspection showed that clusters were dominated by core senses, whereas with 40 clusters...

Ngày tải lên: 08/03/2014, 02:21

... small ruled to a verb lowering where verbs are lowered onto VPs, whence lower again out by to form compound verbs requiring that a lowered have a target verb to compound with III APPLICATION TO ... Church, ~f(1)(r)] the Lisp With is still used adjacent node: a is the P(~x~x[x]) marginal extension calculus notated with a grammar a3b 5, record the task, approach Following following actual lambda ... also expand VPs with verbs lowered onto them, Rather (2) rules and one ordinary one will are not structures have the same have from the highest lowest possible noted the VP, With that as those...

Ngày tải lên: 24/03/2014, 01:21

... that at low microwave power the variance of the EPR signal would be minimum over the whole eld scan at the out-of-phase setting, the correct phase angle can be calculated from two high -power spectra ... proteins with low concentration of spin labels should be detected At low concentration of spin labels where high receiver gain is required to obtain a spectrum of good quality, it is difcult to follow ... distribution with respect to the longer axis of the bers, with a mean angle of 82 and an angular spread of With TCSL probes, the EPR spectra also reported a high dependence of orientation [26], but with...

Ngày tải lên: 24/03/2014, 03:21

... into easily disposable biological sludge Two methods can be considered: aerobic biological treatment or anaerobic biological treatment The commonly used and well-known biological treatment in the ... located in regions with difficult boundary conditions, should be able to work with minimum fresh water consumption by applying the combination of the guidelines described below It is important ... should be made with clean fresh water Some chemicals need dilution just before sending them to pulp flow The contact between the water of dilution and the chemicals before their contact with the pulp...

Ngày tải lên: 01/04/2014, 00:20

... Arguments Function Examples Functions with no argument A function with one argument A function with two arguments A function with an array argument A function with optional arguments A function ... suffice, but you'll be much better off with a fast machine with plenty of memory Excel is a large program, and using it on a slower system or a system with minimal memory can be extremely frustrating ... or below the icon The icons are arranged in groups, and the group name appears below the icons The convention I use in this book is to indicate the tab name, followed by the group name, followed...

Ngày tải lên: 07/04/2014, 15:14

... Time from Power- down and Power- save Additional Delay from Reset (VCC = 5.0V) 00 18 CK – 01 18 CK 4.1 ms Fast rising power 10 18 CK 65 ms Slowly rising power 11 CK(1) 4.1 ms Fast rising power or ... resonator, slowly rising power 01 16K CK – Crystal Oscillator, BOD enabled 10 16K CK 4.1 ms Crystal Oscillator, fast rising power 11 16K CK 65 ms Crystal Oscillator, slowly rising power Notes: ... heavily filtered power supplies, VCC is likely to rise or fall slowly on Power- up/down This causes the device for some period of time to run at a voltage lower than specified as minimum for the...

Ngày tải lên: 15/04/2014, 14:32

... INTRODUCTION……………………………………………………………………XIII ULTRA -LOW- POWER DESIGN: DEVICE AND LOGIC DESIGN APPROACHES……………………………………….………………………………….1 ON-CHIP OPTICAL INTERCONNECT FOR LOW- POWER …………………21 NANOTECHNOLOGIES FOR LOW POWER …………….…………………….40 ... (R,Cd,Idark ) minimum optical power at receiver transimpedance amplifier losses in passive waveguide network minimum optical power at source source efficiency emitter power receiver power electrical power ... to proposals on other levels in the design flow and to future work Keywords: Low- power design, dynamic power reduction, leakage power reduction, ultralow-Vth devices, multi-Vdd, multi-Vth, CVS...

Ngày tải lên: 01/06/2014, 11:43

... MA, Mayayo E: Bone fracture consolidate faster with low power laser Lasers Surgical Medicine 1987, 7(1):36-45 19 Yamada K: Biological effects of low power laser irradiation on clonal osteoblastic ... M: New biological phenomena associated with laser radiation Health Physics 1989, 56:687-690 Karu T: Photobiology of low power laser effects Health Physics 1989, 56:691-704 Baxter D: Low intensity ... surgery or fracture allowing us to perform data synthesis on a common metric David et al [25] measured the force maximum variable changes with two different doses of low power HeNe laser irradiation...

Ngày tải lên: 20/06/2014, 04:20

... design in [13] is the slowest full adder Proposed low power dynamic carbon nanotube full adder is 46% slower than the design in [15], 12% slower than the design in [6], 39% slower than the design ... 91% lower than the design in [6], 84% lower than the design in [13],85% lower than the design in [14], and 15% lower than the design in [15] Conclusion In this paper, we proposed two novel low- power ... 90% lower than the design in [6], 81% lower than the design in [13], 82% lower than the design in [14], and 3% lower than the design in [15] Proposed multi-output dynamic full adder is 7% slower...

Ngày tải lên: 21/06/2014, 00:20