introduction to computers and logic systems

... 2 Chapter – Introduction to Computers and C++ Programming Outline 1.16 1.17 1.18 1.19 1.20 1.21 1.22 1.23 1.24 1.25 1.26 History of the Internet History of the World Wide Web World ... Operators Thinking About Objects: Introduction to Object Technology and the Unified Modeling Language © 2003 Prentice Hall, Inc All rights reserved 3 1.1 Introduction • Software – Instructions to ... programs – 1989: ANSI standard – 1990: ANSI and ISO standard published • ANSI/ISO 9899: 1990 © 2003 Prentice Hall, Inc All rights reserved 16 1.7 History of C and C++ • History of C++ – – – – Extension...

Ngày tải lên: 10/03/2014, 06:20

... four buttons to select predefined positions, and a mode button to toggle between speed and position control In position control mode, each of the four position buttons indexes the motor to specific ... resistor and capacitor in series The primary types of commercial capacitors are electrolytic capacitors, tantalum capacitors, ceramic disk capacitors, and mylar capacitors Electrolytic capacitors ... Components a b c tol Figure 2.9 Axial-lead resistor color bands Table 2.2 Resistor color band codes a, b, and c Bands Color Value Black Brown Red Orange Yellow Green Blue Violet Gray White tol Band Color...

Ngày tải lên: 08/04/2014, 11:14

... information (to screen, to printer, to control other devices) Memory unit • Rapid access, low capacity, stores input information Arithmetic and logic unit (ALU) • Performs arithmetic calculations and logic ... Chapter – Introduction to Computers and C++ Programming Outline 1.15 1.16 1.17 1.18 Hardware Trends History of the Internet History of the World Wide Web General Notes About C and this Book ... best to master C, then learn C++ – Starting in Chapter 15, we begin our introduction to C++ © 2000 Prentice Hall, Inc All rights reserved 14 1.11 Java and Java How to Program • Java is used to...

Ngày tải lên: 23/10/2014, 15:07

Ngày tải lên: 07/11/2013, 09:15

Ngày tải lên: 14/12/2013, 12:15

Ngày tải lên: 14/12/2013, 12:15

Ngày tải lên: 14/12/2013, 12:15

Ngày tải lên: 26/01/2014, 07:20

Ngày tải lên: 26/01/2014, 07:20

Ngày tải lên: 26/01/2014, 07:20

... Dynamic Routing Protocols: RIP and OSPF l RIP uses hop count Ÿ R1 to R3 Ÿ Fewer links but much slower l OSPF uses bandwidth Ÿ R1 to R2 to R3 Ÿ More routers but much faster links 31 To reach the 192.168.1.0/24 ... address as the data link destination address l How does Host X know to forward to packet to RTA and not directly to Host Y? Ÿ IP Source and IP Destination Addresses are on different networks l How does ... the following steps to connect a terminal to the console port on the router: l Connect the terminal using the RJ-45 to RJ-45 rollover cable and an RJ-45 to DB-9 or RJ-45 to DB-25 adapter l Configure...

Ngày tải lên: 09/03/2014, 13:20

... COMMUNICATION SYSTEMS An Introduction to Signals and Noise in Electrical Communication - - - FOURTH EDITION A Bruce Carlson Rensselaer ... Institute Paul B Crilly University of Tennessee Janet C Rutledge University of Maryland at Baltimore , Boston Burr Ridge, IL Dubuque, IA Madison, WI New York San Francisco St Louis Bangkok Bogota ... Lisbon London Madrid MexicoCity Milan Montreal New Delhi Santiago Seoul Singapore Sydney Taipei Toronto ...

Ngày tải lên: 03/07/2014, 21:09

... Introduction to Modeling and Control of Internal Combustion Engine Systems Lino Guzzella and Christopher H Onder Introduction to Modeling and Control of Internal Combustion Engine Systems ... introductory reference for students and engineers new to the topic of internal-combustion engines Acknowledgements We want to express our gratitude to the many colleagues and students who reported to ... encountered in spark ignition (Otto or gasoline) and compression ignition (Diesel) engine systems The intention is to show the general motivation for using control systems and to give the reader an idea...

Ngày tải lên: 04/07/2014, 00:20

... Inputs, states, and outputs of a receiver The inputs and outputs are the mass and energy flows,8 the reservoirs store mass and thermal energy,9 and the level variables are the pressure and temperature ... intake, γ to the engine outlet, and ε to the exhaust gas recirculation duct The three inputs are the fuel mass flow entering the cylinders mϕ , the command ˙ signal to the fresh air throttle uα , and ... speed; torque produced by the turbine; and For fluid dynamic and aerodynamic simulations, usually a high-bandwidth model of the rail dynamics is necessary, see [127] or [143] 2.2 Cause and Effect...

Ngày tải lên: 04/07/2014, 00:20

... beginning to the end (for now)    No backing up to read something again (OK to start over) Just as done from the keyboard Writing to a file  Sending output to a file  Done from beginning to end ...     Files allow you to store data permanently! Data output to a file lasts after the program ends An input file can be used over and over  No typing of data again and again for testing Create ... I/O Streams as an Introduction to Objects and Classes Copyright © 2007 Pearson Education, Inc Publishing as Pearson Addison-Wesley Overview 6.1 Streams and Basic File I/O 6.2 Tools for Stream...

Ngày tải lên: 12/09/2012, 22:49

... regulatory agencies and legislative actors in order to secure regulatory benefits, systems theorists might focus on the way in which the economic and political systems communicate (or fail to communicate) ... contributes to regulatory enforcement and compliance As we shall see, central to the study of regulatory enforcement is the width of discretion within regulatory systems (in the hands of both public and ... conceptualised as a set of mechanisms and processes that impose an obligation to reveal, to explain and to justify regulatory actions, and is therefore instrumental securing regulatory legitimacy Treating...

Ngày tải lên: 21/09/2012, 10:39

... written to the standard expression output b) The code will compile and run d) The code will compile and but nothing will be return on run and the word “Default” the standard output will be written to ... The constructor without parameters is called _ a) main constructor [0.5] c) default constructor b) zero valued constructor 64 [0.5] d) non-parameterized constructor Static constructor has ... compiles and "5, Sub" is printed on the standard output b) The code compiles and "5, d) The code compiles and "2, Super" is printed on the Super" is printed on the standard output standard output...

Ngày tải lên: 09/04/2013, 09:10

... services and add interfaces to them to work with the portal Portlets are the individual components displayed in the portal Prior to the introduction of the standardized portlet API, portlets had to ... portal is going to look, what it is going to do, and what problems it solves Start small, with a prototype or deployment to a limited number of users, and build out from there, to ensure that ... Content Management and Portlets In Chapter 15, we discuss two standards for communicating with content management systems: the Java Content Repository API and the WebDAV protocol We create a portlet...

Ngày tải lên: 05/10/2013, 04:20

Ngày tải lên: 17/10/2013, 19:15