Ngày tải lên: 28/08/2013, 08:31
... of thermal and mass transfer boundary conditions can be encoun- tered in practice. Standard thermal and mass transfer boundary condition types are often used in theoretical models and experiments, ... (m) l ent,ma Mass transfer entrance length (m) l ent,th Thermal (heat transfer) entrance length (m) l M Turbulence mixing length ( m) l M, ma Turbulence mixing length f or mass transfer (m) l heat Heated ... (m) l th Turbulence mixing length f or heat transfer (m) M Molar mass (kg/kmol) Ma Mach number m Mass fraction; dimensionless constant m Mass (kg); mass of a single molecule (kg) m Mass flux (kg/m 2 s) N Ratio...
Ngày tải lên: 30/03/2014, 19:20
Heat and Mass Transfer in Porous Media pdf
... components Heat output Fig. 9 Micro heat pipe [54] Two-Phase Flow and Heat Transfer in Micro-Channels 57 17. In, S., Jeong, S.: Flow boiling heat transfer characteristics of R123 and R134a in ... Two-Phase Flow Patterns Flow boiling heat transfer and two-phase pressure drop are closely related with the liquid and vapour phase distribution within the micro-channels. With the aid of high speed photography ... flow boiling and heat transfer in micro- Fig. 18 Heat transfer experimental results of FC-72 flow boiling in three high aspect ratio rectangular micro-channels and the comparisons with four selected...
Ngày tải lên: 31/03/2014, 16:20
heat and mass transfer
... corresponds to that of heat conduction, whilst mass transfer in a flowing fluid, known for short as convective mass transfer corresponds to convective mass transfer. Mass transfer by diffusion and convection ... only sorts of mass transfer. Radiative heat transfer has no corresponding mass transfer process. 1.4.1 Diffusion The calculation of mass transfer by diffusion requires several definitions and rela- tionships ... time. Further important investigations included heat transfer in film condensation, cross current heat transfer and the analogy between heat and mass transfer in evaporation. 76 1 Introduction. Technical...
Ngày tải lên: 02/04/2014, 15:27
fundamentals of heat and mass transfer
... Convection Heat and Mass Transfer 457 7.5 The Sphere 465 7.6 Flow Across Banks of Tubes 468 7.7 Impinging Jets 477 7.7.1 Hydrodynamic and Geometric Considerations 477 7.7.2 Convection Heat and Mass Transfer ... convection heat transfer will occur from the surface to the outer flow. The convection heat transfer mode is sustained both by random molecular motion and by the bulk motion of the fluid within the ... Introduction sets the stage for any course in heat transfer. It explains the linkage between heat transfer and thermodynamics, and it reveals the relevance and rich- ness of the subject. It should...
Ngày tải lên: 02/04/2014, 15:51
fundamentals of momentum, heat, and mass transfer 5th edition
... The symbols dQ and dW represent differential heat transfer and work done, respectively. The differential operator, d, is used as both heat transfer and work are path functions and the evaluation ... Molecular Mass Transfer 399 24.2 The Diffusion Coefficient 407 24.3 Convective Mass Transfer 428 24.4 Closure 429 25. Differential Equations of Mass Transfer 433 25.1 The Differential Equation for Mass ... 380 23.10 Radiant Heat Transfer Between Gray Surfaces 381 23.11 Radiation from Gases 388 23.12 The Radiation Heat- Transfer Coefficient 392 23.13 Closure 393 24. Fundamentals of Mass Transfer 398 24.1...
Ngày tải lên: 02/04/2014, 15:51
incropera fundamentals of heat and mass transfer
... Electrical heater is perfectly insulated from dryer wall, (3) Heater and switch are isothermal at T set , (4) Negligible heat transfer from sides of heater or switch, (5) Switch surface, A s , loses heat ... second graph with cv tot q/q ′′ vs. T, note that the convection heat transfer rate is always a small fraction of the total heat transfer. That is, radiation is the dominant mode of heat transfer. ... Inner and outer surface temperatures. FIND: Heat flux through container wall and total heat load. SCHEMATIC: ASSUMPTIONS: (1) Steady-state conditions, (2) Negligible heat transfer...
Ngày tải lên: 02/04/2014, 15:52
momentum, heat, and mass transfer fundamentals
... THE MASS BALANCES 2.1 The Macroscopic Mass Balances Figure 2.1 - 1 System for mass balances 2.1.1 The macroscopic total mass balance Accumulation of mass Input and output of mass ... species mass balance Generation of mass of a species Accumulation of mass of a species Input and output of mass of a species Example 2.1.2-1 Macroscopic species mass balance with ... theory and penetration-renewal theory 8.4 The Mass Transfer Coefficient for a Single Phase Example 8.4-1 Calculation offluxfrom a mass transfer coefficient Exutizple 8.4-2 Mass transfer...
Ngày tải lên: 02/04/2014, 15:53
Fundementals of heat and mass transfer kotandaraman
... directions) with constant or variable properties, without heat generation. 2. Same as above but with heat generation 3. Two dimensional steady flow (with constant properties, without heat generation) and 4. ... increases rapidly with temperature. 1.3 COMBINED MODES OF HEAT TRANSFER Previous sections treated each mode of heat transfer separately. But in practice all the three modes of heat transfer can occur ... model. VED c-4\n-demo\demo1-1.pm5 12 FUNDAMENTALS OF HEAT AND MASS TRANSFER Solution: Refer equation 1.10 Heat convected + heat radiated = heat conducted considering 1m 2 , h(T 1 – T 2 ) + σ(T 1 4 ...
Ngày tải lên: 08/04/2014, 10:55
Heat and Mass Transfer Modeling and Simulation Part 1 pptx
... Rodrigo and José J. Linares Chapter 3 Numerical Analysis of Heat and Mass Transfer in a Fin -and- Tube Air Heat Exchanger under Full and Partial Dehumidification Conditions 41 Riad Benelmir and ... polymerization. Chapter 3 is concerned with the description and analysis of heat and mass transfer processes in a fin -and- tube air heater. Hydrogen production by steam reforming and the process intensification ... calculations and the experimental data from Silva (2000), respectively. Fig. 11. Adsorption and desorption steps from simulation results (a) and experiments (b) HEAT AND MASS TRANSFER...
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 2 ppt
... resistance (R Ω ) Charge transfer CPE Charge transfer resistance (R ct ) Mass transfer resistance (R mt ) CHARGE TRANSFER CONTRIBUTION MASS TRANSFER CONTRIBUTION Mass transfer CPE (a) 0.0 ... Heat and Mass Transfer – Modeling and Simulation 26 circuit constant phase element and resistance, related to the charge transfer processes (kinetic), and another parallel ... hydrogen mass transfer. Heat and Mass Transfer – Modeling and Simulation 28 3.2.1 Influence of the Teflon percentage in the microporous layer For this study, microporous layers with a carbon...
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 3 pot
... simultaneous heat and mass transfer on the cooling surface. Many experimental, and few numerical, studies have been carried out to study the heat and mass transfer characteristics of the fin -and- tube heat ... and the fin. This work will consider the heat and mass transfer for a representative tube and fin elementary unit. Heat and Mass Transfer – Modeling and Simulation 40 Prasanna, M.; Ha, H.Y. ... 0013-4651. Heat and Mass Transfer – Modeling and Simulation 44 Fig. 2. Schematic of fins arranged around tubes lined up or ranked in staggered rows The investigation of heat and mass transfer...
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 4 docx
... straight fin with combined heat and mass transfer, ASHRAE transactions, Part 1, 100, 367-374. Numerical Analysis of Heat and Mass Transfer in a Fin -and- Tube Air Heat Exchanger under Full and Partial ... fin -and- tube heat exchanger in presence of non condensable gas, Heat and Mass Transfer Journal, 45, 1561–1573. Chen, L.T. (1991). Two-dimensional fin efficiency with combined heat and mass transfer ... going up the inlet and outlet or the upper and lower fin edges, and is also minimal near the tube surface. 2.4.2 Solving heat and mass transfer equations The heat and mass transfer problem has...
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 5 pdf
... driving gas and carrying gas with an inlet pressure of 1.4 and 1.6 MPa for the heating gas and powder carrying gas separately. Heating gas temperature range is 573 K to 773 K. Stand-off distance ... WHSV and is about 250℃ in this experiment. Fig. 3. Effects of temperature on methanol conversion, hydrogen yield, H 2 and CO in the products. Heat and Mass Transfer – Modeling and Simulation ... reformer integration design and the catalytic layer plate. Heat and Mass Transfer – Modeling and Simulation 90 The conversion of oxygen X O2 was not the same with methanol; at water, methanol,...
Ngày tải lên: 19/06/2014, 10:20