Ngày tải lên: 28/08/2013, 08:31
... of thermal and mass transfer boundary conditions can be encoun- tered in practice. Standard thermal and mass transfer boundary condition types are often used in theoretical models and experiments, ... (m) l ent,ma Mass transfer entrance length (m) l ent,th Thermal (heat transfer) entrance length (m) l M Turbulence mixing length ( m) l M, ma Turbulence mixing length f or mass transfer (m) l heat Heated ... (m) l th Turbulence mixing length f or heat transfer (m) M Molar mass (kg/kmol) Ma Mach number m Mass fraction; dimensionless constant m Mass (kg); mass of a single molecule (kg) m Mass flux (kg/m 2 s) N Ratio...
Ngày tải lên: 30/03/2014, 19:20
Heat and Mass Transfer in Porous Media pdf
... 9 Micro heat pipe [54] Two-Phase Flow and Heat Transfer in Micro-Channels 57 17. In, S., Jeong, S.: Flow boiling heat transfer characteristics of R123 and R134a in a micro- channel. Int. J. ... pressure drop and flow visualization of FC-72 in a silicon microchannel heat sink. Int. J. Heat Fluid Flow 30(6), 1171–1182 (2009) 21. Huh, C., Kim, M.H.: Pressure drop, boiling heat transfer and flow ... to enhance the thermal performance of the micro heat pipe, it is necessary to identify Three heat pipes D ouble heat with t hin heat sink Two heat pipes Fig. 8 Heat pipe for electronic components cooling...
Ngày tải lên: 31/03/2014, 16:20
heat and mass transfer
... corresponds to that of heat conduction, whilst mass transfer in a flowing fluid, known for short as convective mass transfer corresponds to convective mass transfer. Mass transfer by diffusion and convection ... only sorts of mass transfer. Radiative heat transfer has no corresponding mass transfer process. 1.4.1 Diffusion The calculation of mass transfer by diffusion requires several definitions and rela- tionships ... time. Further important investigations included heat transfer in film condensation, cross current heat transfer and the analogy between heat and mass transfer in evaporation. 76 1 Introduction....
Ngày tải lên: 02/04/2014, 15:27
fundamentals of heat and mass transfer
... Convection Heat and Mass Transfer 457 7.5 The Sphere 465 7.6 Flow Across Banks of Tubes 468 7.7 Impinging Jets 477 7.7.1 Hydrodynamic and Geometric Considerations 477 7.7.2 Convection Heat and Mass Transfer ... any case, if convection heat transfer will occur from the surface to the outer flow. The convection heat transfer mode is sustained both by random molecular motion and by the bulk motion of the ... the text and by practicing engineers. However, Section 8.7 Heat Transfer Enhance- ment, and Section 8.8 Flow in Small Channels may be viewed as optional. Buoyancy-induced flow and heat transfer...
Ngày tải lên: 02/04/2014, 15:51
fundamentals of momentum, heat, and mass transfer 5th edition
... The symbols dQ and dW represent differential heat transfer and work done, respectively. The differential operator, d, is used as both heat transfer and work are path functions and the evaluation ... Molecular Mass Transfer 399 24.2 The Diffusion Coefficient 407 24.3 Convective Mass Transfer 428 24.4 Closure 429 25. Differential Equations of Mass Transfer 433 25.1 The Differential Equation for Mass ... 380 23.10 Radiant Heat Transfer Between Gray Surfaces 381 23.11 Radiation from Gases 388 23.12 The Radiation Heat- Transfer Coefficient 392 23.13 Closure 393 24. Fundamentals of Mass Transfer 398 24.1...
Ngày tải lên: 02/04/2014, 15:51
incropera fundamentals of heat and mass transfer
... concurrent heat transfer by radiation and/ or conduction must often be considered. However, jet impingement is one of the more effective means of transferring heat by convection and convection ... Electrical heater is perfectly insulated from dryer wall, (3) Heater and switch are isothermal at T set , (4) Negligible heat transfer from sides of heater or switch, (5) Switch surface, A s , loses heat ... Negligible heat transfer through base of transistor, (3) Negligible heat transfer by radiation from surface of transistor. ANALYSIS: Subject to the foregoing assumptions, the power dissipated by...
Ngày tải lên: 02/04/2014, 15:52
momentum, heat, and mass transfer fundamentals
... THE MASS BALANCES 2.1 The Macroscopic Mass Balances Figure 2.1 - 1 System for mass balances 2.1.1 The macroscopic total mass balance Accumulation of mass Input and output of mass ... overall heat transfer coefficients (denoted by U with a subscript indicating the particular area on which they are based) and overall mass transfer coefficients (denoted by K with ... theory and penetration-renewal theory 8.4 The Mass Transfer Coefficient for a Single Phase Example 8.4-1 Calculation offluxfrom a mass transfer coefficient Exutizple 8.4-2 Mass transfer...
Ngày tải lên: 02/04/2014, 15:53
Fundementals of heat and mass transfer kotandaraman
... COMBINED MODES OF HEAT TRANSFER Previous sections treated each mode of heat transfer separately. But in practice all the three modes of heat transfer can occur simultaneously. Additionally heat generation ... Combined modes of heat transfer. The heat flow is given by equation 1.6. Q A TT hh L kh h rr = − + ++ + ∞∞ 12 11 12 12 (1.6) where h r 1 and h r 2 are radiation coefficients and h 1 and h 2 are ... model. VED c-4\n-demo\demo1-1.pm5 12 FUNDAMENTALS OF HEAT AND MASS TRANSFER Solution: Refer equation 1.10 Heat convected + heat radiated = heat conducted considering 1m 2 , h(T 1 – T 2 ) + σ(T 1 4 ...
Ngày tải lên: 08/04/2014, 10:55
Heat and Mass Transfer Modeling and Simulation Part 1 pptx
... Rodrigo and José J. Linares Chapter 3 Numerical Analysis of Heat and Mass Transfer in a Fin -and- Tube Air Heat Exchanger under Full and Partial Dehumidification Conditions 41 Riad Benelmir and ... 3 is concerned with the description and analysis of heat and mass transfer processes in a fin -and- tube air heater. Hydrogen production by steam reforming and the process intensification strategies ... least in the aspects of heat and/ or mass transfer, analytical/numerical solutions and optimization of the processes. The first chapter deals with the description and mass transfer analysis of...
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 2 ppt
... resistance (R Ω ) Charge transfer CPE Charge transfer resistance (R ct ) Mass transfer resistance (R mt ) CHARGE TRANSFER CONTRIBUTION MASS TRANSFER CONTRIBUTION Mass transfer CPE (a) 0.0 ... Heat and Mass Transfer – Modeling and Simulation 26 circuit constant phase element and resistance, related to the charge transfer processes (kinetic), and another parallel ... as it was also observed by Pan et al. (Pan et al., 2007). Table 3 collects the corresponding values for the hydrogen mass transfer. Heat and Mass Transfer – Modeling and Simulation 28 3.2.1...
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 3 pot
... simultaneous heat and mass transfer on the cooling surface. Many experimental, and few numerical, studies have been carried out to study the heat and mass transfer characteristics of the fin -and- tube heat ... and the fin. This work will consider the heat and mass transfer for a representative tube and fin elementary unit. Heat and Mass Transfer – Modeling and Simulation 40 Prasanna, M.; Ha, ... 0013-4651. Heat and Mass Transfer – Modeling and Simulation 44 Fig. 2. Schematic of fins arranged around tubes lined up or ranked in staggered rows The investigation of heat and mass transfer...
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 4 docx
... with combined heat and mass transfer, ASHRAE transactions, Part 1, 100, 367-374. Numerical Analysis of Heat and Mass Transfer in a Fin -and- Tube Air Heat Exchanger under Full and Partial Dehumidification ... going up the inlet and outlet or the upper and lower fin edges, and is also minimal near the tube surface. 2.4.2 Solving heat and mass transfer equations The heat and mass transfer problem has ... fin -and- tube heat exchanger. Ones the airflow profile was determined, the water vapor, air stream and fin heat and mass balance equations were solved simultaneously. It Heat and Mass Transfer...
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 5 pdf
... WHSV and is about 250℃ in this experiment. Fig. 3. Effects of temperature on methanol conversion, hydrogen yield, H 2 and CO in the products. Heat and Mass Transfer – Modeling and ... driving gas and carrying gas with an inlet pressure of 1.4 and 1.6 MPa for the heating gas and powder carrying gas separately. Heating gas temperature range is 573 K to 773 K. Stand-off distance ... than the copper coating. Probable Heat and Mass Transfer – Modeling and Simulation 78 Morphology of the cold sprayed NiO/Al 2 O 3 coating before and after SRM is also shown in Fig.8....
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 6 pptx
... natural and forced convective heat and mass transfer regimes for nanofluids flowing in semi-infinite geometries, i.e. external boundary layer flows along Heat and Mass Transfer – Modeling and ... velocity profiles, streamlines and boundary layer thickness. Heat transfer characteristics are then presented by means of wall temperature distribution and convective heat transfer coefficients. 2. ... Foundation of China (50906104) and project No.CDJZR10140010 supported by Fundamental Research Funds for the Central Universities. Heat and Mass Transfer – Modeling and Simulation 110 The temperature...
Ngày tải lên: 19/06/2014, 10:20
Heat and Mass Transfer Modeling and Simulation Part 7 doc
... the gravity m.s -2 h heat transfer coefficient W.m -2 .K -1 Heat and Mass Transfer – Modeling and Simulation 116 Wang, X Q. &, Mujumdar, A.S. (2007). Heat transfer characteristics ... Buoyancy-driven heat transfer enhancement in a two-dimensional enclosure using nanofluids. Int. J. Heat Mass Transf. Vol. 46 pp.3639-3653. Heat and Mass Transfer – Modeling and Simulation ... per mass Heat and Mass Transfer in External Boundary Layer Flows Using Nanofluids 115 Maïga, S.E.B. Palm, S.J., Nguyen, C.T., Roy, G. & Galanis, N. (2005). Heat transfer enhancement by...
Ngày tải lên: 19/06/2014, 10:20