electrical power and energy calculations

Ngày tải lên: 26/12/2013, 01:18

Ngày tải lên: 26/12/2013, 01:18

... infrequent and unreliable. The capacities of the power stations installed in Dokan and Derbandikhan are (5 x 80 MW) and (3 x 83 MW) respectively, which are insufficient to meet the power demand [4]. ... Sulaimani and Erbil governorate. 3. Case study 11 and 12 reliability of the regional power system evaluated by disjoint technique and compared with the previous case studies. 4. Case study 13 and ... The power network of Governorates Erbil and Sulaimani had been cut off from the national grid. The power supply of the two Governorates had to rely on the two hydropower stations at Derbandikhan...

Ngày tải lên: 03/01/2014, 19:39

Ngày tải lên: 26/06/2014, 23:20

Ngày tải lên: 12/08/2014, 05:20

... FACTS, IEEE Power and Energy Society General Meeting-Conversion and Delivery of Electrical Energy in the 21st Century, 2008. Electrical Generation and Distribution Systems and Power Quality ... coefficient. bs and bw are a scaling dilation coefficient and a Electrical Generation and Distribution Systems and Power Quality Disturbances 56 Fig. 2. Temperature and irradiance effects ... In the last section, the power quality analysis is discussed. The output prediction is performed to obtain electrical outputs of the model and its electrical power. The power quality nature is...

Ngày tải lên: 12/08/2014, 05:20

... for Power Quality Analysis 75 6.2.3 Power factor, apparent power, active power and reactive power The power factor, the apparent power S (VA), the active power P (W), and the reactive power ... scholarship and research grant supports. 9. References [1] Bollen M. H. J. and Hager M., Power quality: integrations between distributed energy resources, the grid, and other customers. Electrical Power ... “Improvement of power quality using distributed generation”, Electrical Power and Energy Systems 32 (2010) 1069–1076 [9] P.R.Khatri, V.S.Jape, N.M.Lokhande, B.S.Motling, “Improving Power Quality...

Ngày tải lên: 12/08/2014, 05:20

... become stricter and stricter to meet very high power quality standards like unity power factor, less harmonic distortion, voltage and frequency control, active and reactive power control, fast ... conventional energy sources are limited and have pollution to environment as more attention and interest have been paid on the utilization of renewable energy sources such as wind energy, fuel cells and ... power sent to the grid, control of reactive power transferred between the DPGS and the grid, control of the DC-link voltage, control of power quality and grid synchronization. Gird filter and...

Ngày tải lên: 12/08/2014, 05:20

... ( m s) Ampiltude of Reactive power (VAr) Fig. 16. (a) Single phase instantaneous reactive power (b) Three phase reactive power a) b) Electrical Generation and Distribution Systems and Power Quality ... )} V Lvtdt=−  (1) Loss of Energy: The loss of energy “LE” is defined as the integral of the drop in energy during the event: Electrical Generation and Distribution Systems and Power Quality Disturbances ... Electrical Generation and Distribution Systems and Power Quality Disturbances 128 2 1 1 DF THD = + (14) Total power factor = DF*DPF (15) 2 1 1 0.0441 DF = + = 0.999029011 Total power...

Ngày tải lên: 12/08/2014, 05:20

... industrial and commercial power systems IEEE Std. 1100, (1999). IEEE Recommended Practice for Powering and Grounding Electronic Equipment Power Quality and Voltage Sag Indices in Electrical Power ... to electrical safety and earthing defines the limits for AC and DC transients and continuous voltage in the railway environment. Power Quality and Voltage Sag Indices in Electrical Power ... magnitude and duration of the sag and the number of events. These events can be grouped in order to make their counting easier and more Power Quality and Voltage Sag Indices in Electrical Power...

Ngày tải lên: 12/08/2014, 05:20

... transmission losses, and wide range of load and generation schedules. Electrical Generation and Distribution Systems and Power Quality Disturbances 216 In Fig. 14 combined shunt and series controllers ... profiles with continuation power flow: case: Without SVC Electrical Generation and Distribution Systems and Power Quality Disturbances 224 5. Simulation test and results using SimFACTS ... and the dynamic interpretation of the results and the interactive visual communication between users and computer solution processes. The physical and technical phenomena and data of the power...

Ngày tải lên: 12/08/2014, 05:20

... s ff== and 2.5kHz sv f = . Electrical Generation and Distribution Systems and Power Quality Disturbances 248 Hong, D.; Lee J. & Choi, J. (2006). Power Quality Monitoring System using Power ... and (iii) lower input current distortion. However, it has only unidirectional power flow capability, and needs complicated power switch and two serially connected capacitors. The specific power ... imbalance caused by source voltage and switching operation, and it can provide fault tolerant operation. Electrical Generation and Distribution Systems and Power Quality Disturbances 252...

Ngày tải lên: 12/08/2014, 05:20

... with power factor correction, Proceedings of IEEE Applied Power Electronics Conference and Exposition, IEEE, USA, pp. 760–763. Roberts, B. (2009). Active power filters: A review, IEEE Power and Energy ... used. 303 Battery Charger with Power Quality Improvement Electrical Generation and Distribution Systems and Power Quality Disturbances 288 Supply, Proceedings of IEEE Power Electronics Specialists ... harmonic s uppression and input power factor correction, IEEE Transactions on Industrial Electronics Vol. 42(No. 6): 629– 635. 304 Electrical Generation and Distribution Systems and Power Quality Disturbances ...

Ngày tải lên: 12/08/2014, 05:20

... of Electrical Engineering and Computer Science 6.087: Practical Programming in C IAP 2010 Problem Set 3 Control flow. Functions. Variable scope. Static and global variables. I/O: printf and ... File I/O. Character arrays. Error handling. Labels and goto. Out: Wednesday, January 13, 2010. Due: Friday, January 15, 2010. Problem 3.1 Code profiling and registers. In this problem, we will ... reproduced at the end of this problem set (and can be downloaded from Stellar). The main() function handles the code profiling, calling fibonacci() many times and measuring the average processor time....

Ngày tải lên: 25/04/2013, 08:07

Ngày tải lên: 20/08/2013, 23:29

Ngày tải lên: 05/09/2013, 14:58

Ngày tải lên: 05/09/2013, 16:10

Ngày tải lên: 12/12/2013, 08:18

... equipment 7 Ensure that the electrical installation is safe ■ install new electrical systems to a suitable standard, eg BS 7671 Requirements for electrical installations, and then maintain them in ... 1 Selection and use of electric handlamps PM38 HSE Books 1992 ISBN 0 11 886360 6 Memorandum of guidance on the Electricity at Work Regulations 1989 HSR25 HSE Books 1989 ISBN 0 7176 1602 9 GUIDANCE ON ELECTRICAL ... Note: The inspection and testing intervals for electrical equipment given in these publications are recommendations and are not legal requirements. BS 7671: 1992 Requirements for electrical installations....

Ngày tải lên: 12/12/2013, 21:15

Ngày tải lên: 13/12/2013, 05:17