Tài liệu tóm tắt thành phần của lớp phủ chống ăn mòn hữu cơ, bao gồm acrylic, polyurethane, polyester, alkyd, cao su clo, lớp phủ kẽm vô cơ và sắc tố bảo vệ chống ăn mòn. Tài liệu cũng mô tả các đặc tính và cơ chế bảo vệ của từng loại vật liệu này.
Ngày tải lên: 03/07/2014, 12:20
... epoxy coatings The surface modification with silane has the effect of increasing dispersibility, thus enhancing the reinforcing effect of hydrotalcite bearing BTSA inhibitor in epoxy coatings ... enhancing the reinforcing effect of hydrotalcite bearing molypdate inhibitor in epoxy coatings The 27 HTM modified by N-(2-aminoethyl)-3-aminopropyltrimethoxisilane has more reinforcing effect than ... used for corrosion protection of metal structures Pigment inhibits corrosion in paint film plays an important role in ensuring the anti -corrosion protection of coatings Chromates are the best inhibitive
Ngày tải lên: 09/01/2020, 15:36
Summary of chemical doctoral thesis: Synthesis of hydrotalcites bearing corrosion inhibitors and fabrication of nanocomposite coatings for corrosion protection of carbon steel
... epoxy coatings The surface modification with silane has the effect of increasing dispersibility, thus enhancing the reinforcing effect of hydrotalcite bearing BTSA inhibitor in epoxy coatings ... enhancing the reinforcing effect of hydrotalcite bearing molypdate inhibitor in epoxy coatings The 27 HTM modified by N-(2-aminoethyl)-3-aminopropyltrimethoxisilane has more reinforcing effect than ... used for corrosion protection of metal structures Pigment inhibits corrosion in paint film plays an important role in ensuring the anti -corrosion protection of coatings Chromates are the best inhibitive
Ngày tải lên: 15/01/2020, 11:18
Design and characterization of non toxic nano hybrid coatings for corrosion and fouling resistance
... disaggregation during curing, resulting in a more homogenous coating Nanoparticles tend to occupy small hole defects formed from local shrinkage during curing of the epoxy resin and act as a bridge interconnecting ... bridge interconnecting more molecules This results in a reduced total free volume as well as an increase in the cross-linking density [9,10], In addition, epoxy coatings containing nanoparticles ... the coatings tested exhibited the initial formation of corrosion products, which were inevitable, given their relatively thin nature The coating under investigation is made using epoxy resin which
Ngày tải lên: 17/03/2021, 20:10
A Monthly Struggle for Self-Control? Hyperbolic Discounting, Mental Accounting, and the Fall in Consumption Between Paydays ppt
... difficult to explain the decline Also, incorporating uncertainty about future consumption would increase the difficulty of explaining the decline with exponential discounting, in the standard ... differently during the pay period. In combination, these facts suggest the use of a mental accounting rule limiting borrowing. Overall, our findings are difficult to explain in the standard ... binding credit constraints, allowing the model to predict a “jump” in spending on the. .. but about half the level of spending in the two distance categories that unambiguously include
Ngày tải lên: 23/03/2014, 03:20
COMPREHENSIVE AND UNIFIED POLICY FOR TB CONTROL IN THE PHILIPPINES docx
... Sputum Examination (see Annex 2, p 62) Sputum Smear Examination: smearing, fixing, staining and reading slides Record the results in the Laboratory Request Form for Sputum Examination ... (not serious) HRZ for 2 months during the intensive phase HR for 4 months during the maintenance... Record keeping 1) Maintain and update the TB Register 2) Maintain and update ... this Comprehensive and Integrated Policy for TB Control in the Philippines. Beginning in January 2002, the organizing committee began a series of stakeholders’ meetings and on World TB Day,
Ngày tải lên: 29/03/2014, 03:20
Corrosion Control Through Organic Coatings P1 pps
... Amy Forsgren received her chemical engineering education at the University of Cincinnati in Ohio in 1986. She then did research in coatings for the paper industry for 3 years, before moving ... years in anti- corrosion coatings research at Ford Motor Company, before returning to Sweden in 1996 to lead the protective coatings program at the Swedish Corrosion Institute. In 2001, she joined ... used only for identification and explanation without intent to infringe. Library of Congress Cataloging -in- Publication Data Forsgren, Amy. Corrosion control through organic coatings / Amy Forsgren.
Ngày tải lên: 03/07/2014, 12:20
Corrosion Control Through Organic Coatings Part 10 pot
... predict the actual performance of zinc-coated sub- strates and zinc-containing paints must be carefully examined because these materials are commonly used in the corrosion engineering field. Also, the ... 132 Corrosion Control Through Organic Coatings most automotive tests, including the cyclic corrosion tests, have been developed using coatings relevant to automotive ... basic adhesion by relieving preexisting internal stresses. The most commonly used methods of detaching coatings are applying a normal force at the interface plane or applying lateral stresses.
Ngày tải lên: 21/07/2014, 15:20
Corrosion Control Through Organic Coatings Part 9 ppt
... can be forced by increasing heat stress. Testing in the vicinity of the T g changes the properties of the coatings too much, so that the paint being tested is not very much like the paint that ... salts in solution, because airborne contaminants are believed to play a very minor role in paint aging. See Chapter 6 for information about air bourne contaminents. Testers may be tempted to force ... rather contain a good deal of empty space, for example: 1. Pinholes are created during cure by escaping solvents. 2. Void spaces are created by crosslinking. As crosslinking occurs during cure,
Ngày tải lên: 21/07/2014, 15:20
Corrosion Control Through Organic Coatings Part 8 ppt
... effect on coating performance. If a coating forms high levels of internal stress during cure — not uncommon in thick, highly crosslinked coatings — then applying other stresses during water uptake ... 102 Corrosion Control Through Organic Coatings Because the polymer chains in the cured film are well anchored and already crosslinked, further crosslinking results in additional tightening of ... and voids in the paint film, and can accu- mulate at the metal-coating interface. Once corrosion has begun, water can exist in blisters or in corrosion products at the coating-metal interface.
Ngày tải lên: 21/07/2014, 15:20
Corrosion Control Through Organic Coatings Part 7 doc
... Administration (OSHA) or the Mine Safety and Health Administration. For more information, the interested reader is encouraged to obtain the free document, Request for Assistance in Preventing ... feasible for the quantities or types of heavy abrasives used in maintenance coatings. They are described here for those wanting a general orientation in the area of lead-contaminated blasting debris. ... Control for the Metal Finishing Industry, Report EPA-600/8 -78 -010, Environmental Protection Agency, Washington DC, 1 978 , 59 20 Means, J et al., in Engineering Aspects... Materials, Washington
Ngày tải lên: 21/07/2014, 15:20
Corrosion Control Through Organic Coatings Part 6 potx
... Most maintenance painting jobs do not involve painting new constructions but rather repainting existing structures whose coatings have deteriorated. Surface prep- aration involves removing all ... 68 Corrosion Control Through Organic Coatings 4.1 INTRODUCTION TO BLAST CLEANING By far, the most common pretreatment for steel constructions prior to painting is blast cleaning, in which ... before painting, prevent the coating from obtaining good adhesion to the substrate... epidemic of silicosis was in the drilling of the Gauley Bridge Tunnel in West Virginia in the 1930s During the
Ngày tải lên: 21/07/2014, 15:20
Corrosion Control Through Organic Coatings Part 5 docx
... growth in coatings, both in- can and in the cured paint. They are more important in waterborne coatings than in solvent-borne coatings. Antifouling agents prevent the growth of mussels, sea urchins, ... to control wetting and viscosity and to main- tain dispersion. Whether or not a waterborne paint will succeed in forming a continuous film depends on a number of factors, including: • Wetting ... 50 Corrosion Control Through Organic Coatings 2.4.2 REACTIVE REAGENTS Reactive reagents generally aid in film formation, forming bonds to the substrate, crosslinking, and curing. Examples
Ngày tải lên: 21/07/2014, 15:20
Corrosion Control Through Organic Coatings Part 4 ppsx
... alkaline compounds [38]. This group includes: • Zinc aluminum phosphate. It is formed by combining zinc phosphate and aluminum phosphate in the wet phase; the aluminum ions hydrolyze, caus- ing ... corroding, zinc ions are released into the coating. These ions can react with other species in the coating to form insoluble zinc salts. As they precipitate, these salts fill in the pores in the ... the Anticorrosion Coating 39 they suggest, react with aggressive species that are permeating into the coating and thus prevent them from reaching the metal-coating interface. An interesting aspect
Ngày tải lên: 21/07/2014, 15:20
Corrosion Control Through Organic Coatings Part 2 ppt
... coatings was the dominant factor in predicting performance However, in a generally similar method with no sodium chloride, oxygen permeation was the rate-controlling factor for the same coatings ... coating-metal interface and passivate it by supporting the formation of thin layers of insoluble corrosion products, which inhibit further corrosion [44-46] For more information about anticorrosion ... concerns and choices faced by maintenance engineers who use heavy-duty coating, including: • • • • • • • Composition of anticorrosion coatings Waterborne coatings Blast-cleaning and other heavy surface
Ngày tải lên: 21/07/2014, 15:20
Corrosion Control Through Organic Coatings Part 1 docx
... Author Amy Forsgren received her chemical engineering education at the University of Cincinnati in Ohio in 1986 She then did research in coatings for the paper industry for years, before moving to ... years in anticorrosion coatings research at Ford Motor Company, before returning to Sweden in 1996 to lead the protective coatings program at the Swedish Corrosion Institute In 2001, she joined ... for identification and explanation without intent to infringe Library of Congress Cataloging -in- Publication Data Forsgren, Amy Corrosion control through organic coatings / Amy Forsgren p cm Includes
Ngày tải lên: 21/07/2014, 15:20
Corrosion Control Through Organic Coatings Part 0 pps
... Amy Forsgren received her chemical engineering education at the University of Cincinnati in Ohio in 1986. She then did research in coatings for the paper industry for 3 years, before moving ... years in anti- corrosion coatings research at Ford Motor Company, before returning to Sweden in 1996 to lead the protective coatings program at the Swedish Corrosion Institute. In 2001, she joined ... used only for identification and explanation without intent to infringe. Library of Congress Cataloging -in- Publication Data Forsgren, Amy. Corrosion control through organic coatings / Amy Forsgren.
Ngày tải lên: 05/08/2014, 21:20
The Potential of Biofumigants as Alternatives to Methyl Bromide for the Control of Pest Infestation in Grain and Dry Food Products
... Metabolism, 154 Industrial sector, 107–116 Inteins, 83 Intellectual Property Rights, 378 International Institute for Tropical Agriculture (IITA), 375 International Potato Center (CIP) in Lima, 375 International ... Research Institute (IRRI), 375 International Rice Research Institute in Los Ba ˜ nos, Philippines, 375 International Union for Conservation of Nature (IUCN), 364 Inverse metabolic engineering (IME), ... benzaldehyde (C 7 H 6 O) for the control of stored-product insects. During previous centuries, traditional agriculture in developing countries has developed effective means for insect control using botanicals....
Ngày tải lên: 25/10/2013, 05:20
Alternative Processing Technologies for the Control of Spoilage Bacteria in Fruit Juices and Beverages
... properly before processing is among the main reasons for contamination in fruit juice. Washing and brushing fruit before the juicing step is common in juice processing. According to one industry survey, ... particulate-containing liquids offer the best opportunity for commercialization of PEF technology. A commercial system combining PEF processing and aseptic packaging is being designed by a university/industry consortium. 35 ... production, including preharvest practices of planting, growing of fruit, harvesting, post- harvest handling, washing, and cooling and storage. P REVENTIVE M EASURES IN THE ...
Ngày tải lên: 25/10/2013, 21:20
Tài liệu Corrosion control through organic coatings docx
... the coatings was the dominant factor in predicting performance. How- ever, in a generally similar method with no sodium chloride, oxygen permeation was the rate-controlling factor for the same coatings ... Extracts Formed with Certain Oleoresinous Binders Inhibitive aqueous extracts form with certain oleoresinous binders. Com- ponents of the binder, such as carboxylic and hydroxyl groups, form complexes ... needed. Chlorinated rubber coatings have low solids contents, in the 15% to 25% (vol/vol) range. Chlorinated rubber coatings are not crosslinked; the resin undergoes no chemical reaction during cure...
Ngày tải lên: 25/12/2013, 23:17
Bạn có muốn tìm thêm với từ khóa: