design for interoperability with external systems

... CONTROLLER DESIGN FOR PROCESS WITH TIME DELAY VIETNAM NATIONAL UNIVERSITY – HO CHI MINH CITY PRESS HO CHI MINH CITY UNIVERSITY OF TECHNOLOGY AND EDUCATION TRUONG NGUYEN LUAN VU PID CONTROLLER DESIGN FOR ... CHAPTER DESIGN OF ADVANCED PID CONTROLLERS FOR TIME-DELAY PROCESSES 13 1.1 INTRODUCTION 13 1.2 GENERALIZED IMC APPROACH FOR PID CONTROLLER DESIGN 14 1.3 DESIGN OF PID ... CONTROLLERS FOR CASCADE CONTROL SYSTEM 140 5.3.1 FOPI Controller Design Procedure for General Process Models 140 5.3.2 Design of Secondary Controller 140 5.3.3 Design of Primary

Ngày tải lên: 22/11/2022, 23:04

... a target metric for designing the DS-CDMA FIR receiver filters for BPSK signaling, where the receiver has one FIR multiple- input single-output (MISO) filter with block memory for each user. It ... DS-CDMA systems are shown in Figure 3 for different number of users N.FromFigure 3, it is seen that when N = 1, the performances of the MMSE and minimum BER systems are almost the same for all ... studied minimum BER receiver filter for single-user SISO systems and no transmitter filter was considered. An adaptive algorithm for finding minimum BER filters without block memory in the receiver

Ngày tải lên: 21/06/2014, 22:20

... performance for channel estimation with different lengths MSE for δ estimation T f = 30 ns, Tw = 10 ns, D = 4 ns 10−1 PDo for T(x) with P = 3 and for T1 (x): experimental 1 0.9 MSE for ... estimator with different equalizers are investigated We employ Lw = 30 ns for synchronization Figure 11 shows the BER performance The BER performance for the MF equalizer (lines with ◦ markers) ... the performances for the ZF (lines with ∗ markers) and the LMMSE equalizers (lines with markers) approach 0 after 10 dB Hence, the MF... which are used as boundaries for the overall performance

Ngày tải lên: 21/06/2014, 23:20

... specification with formal techniques for properties such as boundedness of memory, (periodic) schedulability, deadlocks, and so forth. Section 4 presents the model and the tasks performed during design ... communication for multiprocessor sys- tems. During design space exploration, Koski uses simu- lation for performance evaluation. Also, Koski has many similarities with SystemCoDesigner, there ... combination of functional simulation together with performance simulation While performing design space exploration, there is a need for a rapid performance evaluation... Battacharyya, E A

Ngày tải lên: 22/06/2014, 19:20

... BER versus SNR for matrix-pencil-based approach with different codes, multirate configuration with N = 8 for the high-ra te user and N = 16 for the low-rate user, respectively. and without the matrix-pencil ... 20 Without MP, N = 16 Without MP, N = 8 With MP, N = 16 With MP, N = 8 SNR (dB) MSE of channel estimation (dB) Figure 3: Normalized MSE of channel estimation versus SNR, single-rate cases with ... −3 10 −4 10 −5 0 5 10 15 20 Without MP, N = 16 Without MP, N = 8 With MP, N = 16 With MP, N = 8 SNR (dB) SNR Figure 4: Comparison of BER versus SNR, single-rate cases with N = 8andN = 16, respectively.

Ngày tải lên: 23/06/2014, 00:20

... We also provide a thorough performance analysis of the proposed receivers; in particular, we derive closed- form formulas for the conditional error probability and for the near-far resistance, ... Carlo-based performance evaluation technique With regard to the performance of the blind receivers, results of Monte Carlo... results with respect to the soft integration one for the nonblind ... terms of both detection performance and computational complexity. A closed form expression is also derived for the conditional error probability and a lower bound for the near-far resistance

Ngày tải lên: 23/06/2014, 01:20

... acquisition performance without utilizing the deci- sion feedback adaptation versus SNR parameterized by J for L = 6JN, M = 2, and NFR = 3dB. competitive performance with the detectors with a larger ... mensionality reducing transformation with column vectors forming a basis associated with an M-dimensional subspace of the MWF, where M<JNS. Evidently, the M basis vectors for the M-stage truncated ... Thus, the estimated information symbol  d 1 is utilized as the feedback informa- tion to provide an accurate estimation of vector u in (17). An efficient recursive formula for updating the estimate

Ngày tải lên: 23/06/2014, 01:20

... study on the design of a software-defined radio platform Part III Design Tools and Methodology for Multidomain Embedded Systems Part III covers Model-Based Design for multidomain systems Continuoustime ... performance analysis in the design process of such platforms, and we review different analysis approaches Model-Based Design for Embedded Systems 1.1.1 Distributed Embedded Platforms Embedded systems ... developing new methodologies for Model-Based Design for that are able to take into account the heterogeneity in multidomain systems Model-Based Design for illustrative heterogeneous systems such as optoelectromechanical

Ngày tải lên: 02/07/2014, 15:20

... Model-Based Design for Embedded Systems In addition, in many cases, the same simulation environment can be used for both function and performance verifications However, most simulationbased performance ... Network interface LR LCD TV HR Model-Based Design for Embedded Systems Performance Prediction of Distributed Platforms In Section 1.3, we at first will formally describe the above system in the ... the video decoding example in Section 1.2: (a) without resource interaction, and (b) with resource interaction 10 Model-Based Design for Embedded Systems number of tokens in a time interval Note

Ngày tải lên: 02/07/2014, 15:20

... 88 57 58 Model-Based Design for Embedded Systems 3.1 Introduction Formal approaches to system performance modeling have always been used in the design of real-time systems With increasing system ... are already using such formal methods for the early evaluation and exploration of a design, as well as for a formally complete performance verification toward the end of the design cycle—neither ... formal approach to MpSoC performance verification Computer, 36(4):60–67, 2003 54 Model-Based Design for Embedded Systems 34 K Richter, D Ziegenbein, M Jersak, and R Ernst Model composition for

Ngày tải lên: 02/07/2014, 15:20

... complex embedded real-time systems Real-Time Systems Journal, 39(1–3):31–72, 2008 Formal Performance Analysis 91 32 J Real and A Crespo Mode change protocols for real-time systems: A survey and a ... models for the analysis of heterogeneous multiprocessor systems In Proceedings of the 6th IEEE/ACM/IFIP International Conference on 92 Model-Based Design for Embedded Systems Hardware/Software Codesign ... the Design- Trotter [24] Though extremely useful for early design exploration by providing very adequate performance estimates, for example, memory usage, energy consumption, and options for parallelizations,

Ngày tải lên: 02/07/2014, 15:20

... Nicolescu/Model-Based Design for Embedded Systems 67842_C005 Finals Page 126 2009-10-13 126 Model-Based Design for Embedded Systems Application Mapping Execution platform Network m 1 f 1 f 2 ... . For details concerning such calculations we refer to [BHM08]. Nicolescu/Model-Based Design for Embedded Systems 67842_C005 Finals Page 134 2009-10-13 134 Model-Based Design for Embedded Systems ... better designs exist, for instance, where less power is used A general-purpose processor could, for example,... framework for multiprocessor systems- on-chip modelling Design Automation for

Ngày tải lên: 02/07/2014, 15:20

... waits for client requests for its methods Server host systems maintain a list of these ports, known as object endpoints, in the registry 8 Module 7: Integrating with External Systems For a client ... http://msdn.microsoft.com/msdn-files/027/000/242/SOAPTK.exe Note For more information about Web Services, see http://msdn.microsoft.com/library/periodic/period00/webplatform.htm Module 7: Integrating with External Systems 13 Time-Bound ... Integrating with External Systems Transport Options Topic Objective To explain the transport options available for B2B solutions Lead-in There are several transport options available for B2B solutions...

Ngày tải lên: 10/12/2013, 16:16

... mechanisms responsible for metal immobilization Determining specific mechanisms responsible for pollutant removal within SuDS provides data that can be used to enhance SuDS design and performance First, ... Cu, Pb and Zn removed within the sand columns for single metal 166 Figure 5.12 Summary of percentage of Cu, Pb and Zn removed within the sand columns for mixed systems 166 Figure ... treatment systems in order to optimise for pollutant removal, particularly heavy metals, within SuDS Comprehensive research with regards to specific pollutant removal capacity of SuDS systems is...

Ngày tải lên: 22/12/2014, 17:08

... iterations for BI-GDFE and EM for SCCP 82 5.6 The MSE performance of SCCP 83 ix LIST OF FIGURES 5.7 BER v.s SNR for different iterations of BI-GDFE and EM for MCCDMA ... number of iterations for BI-GDFE and EM for MC-CDMA 85 5.9 The MSE performance of MC-CDMA 85 5.10 BER v.s SNR for different iterations of BI-GDFE and EM for CPCDMA ... ZF Zero Forcing w.r.t with respect to xv Introduction Chapter Introduction 1.1 Motivations Wireless communication systems have proved themselves to be very effective and convenient for information...

Ngày tải lên: 12/09/2015, 08:19

... is not a good option for low frequency designs or extremely high frequency designs For low frequency designs, the broadband coupler consumes a large area For high frequency design up to 80 GHz, ... topologies with a small phase error and a high return loss for broadband and dual-band applications Design tradeoffs and design procedures are considered specifically for Computer Aided Design (CAD) ... explore novel topologies for broadband and high performance designs One set of general formulas, which includes the formulas of conventional method as a special case, is found for the high-pass/low-pass...

Ngày tải lên: 12/09/2015, 09:21

... controllers designed for G8-γ 36 Table 4.1 Summary of tuning parameters for the proposed 47 EVRFT design Table 4.2 Tracking errors for various design methods 48 Table 4.3 Tracking errors for various design ... design of PID controllers for stable processes with inverse response dynamics is developed using VRFT design framework Adaptive PID controller design using EVRFT method for stable processes with ... zero for stable processes with inverse response in this thesis 14 Chapter VRFT Design of PID Controllers for Stable Processes with Inverse Response Chapter VRFT Design of PID Controllers for Stable...

Ngày tải lên: 22/09/2015, 15:18

... and volume potentiometer for external speaker Microphone for audio input Battery level indication Connectors for actuators and sensors: • Digital camera • DC motors with encoders • 12 Servos ... This gave students not only the enjoyment of working with real robots but, more importantly, hands-on experience with control systems, real-time systems, concurrency, fault tolerance, sensor and ... VV Preface well as simulation systems for driving robots (“EyeSim”) and underwater robots (“SubSim”) EyeCon controllers are used in several other projects, with and without mobile robots Numerous...

Ngày tải lên: 17/02/2016, 09:34

... performance of the Baxley design is similar to the proposed design for QPSK-modulated data However, for 16-PSK and 64-PSK modulation, our proposed design outperforms the Baxley design Also, for ... between the design with l2 norm and the design with l∞ norm However, the computational complexity of the design with l2 norm is quite lower than the computational complexity of the design with l ∞ ... non-uniform power distribution for an OFDM frame with null subcarriers Furthermore, the result underlines the potential of our proposed scheme in designing pilot symbols for OFDM systems with different...

Ngày tải lên: 21/06/2014, 03:20

... 8) (a) (b) Figure 15: Performance and complexity of SDA for × MIMO systems with 16-QAM modulation (a) SER (b) Complexity K = 32 for proposed K-Best SDA; K = 32 and 52 for conventional K-Best SDAs ... without proposed CML (K = 4) Complex K-Best SDA without proposed CML (K = 8) Complex K-Best SDA without proposed CML (K = 12) Complex K-Best SDA with proposed CML (K = 4) Complex K-Best SDA with ... (K = 4) Complex K-Best SDA with proposed CML (K = 12) MLD (4 × 4) (a) (b) Figure 11: Performance of complex K-Best SDA for × MIMO systems (a) 16-QAM modulation K = and for complex K-Best SDA incoporating...

Ngày tải lên: 21/06/2014, 07:20