design and development of product

... define and characterise the supply chain such as: name of company and International Journal of Production Research 2103 Figure System diagram of SCEnAT showing input and output flow of data product ... packaging, delivery of the product to the consumers and end -of- life management of the product after its use The aim of the DSS or SCEnAT presented in this paper is to provide insights and evidence to ... of total material (in weight or in value) per unit of product Waste sent to landfill resulting from the production process as a percentage of total waste (in weight or in value) per unit of product

Ngày tải lên: 05/05/2020, 09:18

... FORMULATION DESIGN AND DEVELOPMENT OF TRANSDERMAL DELIVERY SYSTEM – NANOEMULSION OF SCHIZANDROL A CHEN YE (B. Sc., Shanghai Jiao Tong University) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY ... out... may be a spur to the development of lignan-based products 1.3 Objectives and Scope of Study The ultimate goal of the present work is to design and develop nanoemulsion- based ... of schizandrol A More specifically, the aims are: 1 Establishing a detailed preformulation and solubility profile of schizandrol A 3 Physicochemical properties of schizandrol

Ngày tải lên: 10/09/2015, 09:03

... properties and the macro/micro structure of the scaffolds (i.e. porosity and pore morphology). An interconnected internal structure of the scaffold is important for adequate flow of nutrients into and ... as reported by Darney et al (1989) and Ory et al (1983). Based on these clinical products, ε-caprolactone and PCL were regarded as non-toxic and hard and soft tissue compatible materials. Capronor ... is one of the most flexible and easy to process materials. Even though it has one of the slowest degradation rates of all such polymers, the structural stability of PCL permits the study of fabrication

Ngày tải lên: 14/09/2015, 10:20

... conditions and other design 125 Chapter Four: Results and Discussions parameter (FD) In this study, all the designs and processing conditions tested led to the development of scaffolds ... Influence of deposition speed on RW and porosity of the scaffolds fabricated with lay-down pattern of 0/90 and nozzle size of 500 µm Mariani et al (2006) investigated the influence of ... Mn of 5,000, dihydroxyl PEG with a Mn of 8,000, and an initial [CL]/[EO] ratio of 3/1 were selected as a compromise between the formation of high molecular weights, appropriate PEG content, and

Ngày tải lên: 14/09/2015, 10:23

... calculate the porosity and interconnectivity of the scaffolds 3. 5 .3. 1... ILH and ILV loading, one layer out of every 2 layers of filaments was aligned in the direction of loading For ... out of every 3 layers of filaments was aligned normal to the direction of loading In ILV loading, one layer out of every 3 layers of filaments was aligned in the direction of loading ... The distribution and ratio of viable and. .. avoid creation of isolated voids (Gibson and Ashby, 1997) Based on this phenomenon, various scaffolds with different values of FD were built

Ngày tải lên: 14/09/2015, 11:12

... DESIGN AND DEVELOPMENT OF A BENCH-TOP ELECTRO-ADSORPTION CHILLER SAI MAUNG AYE NATIONAL UNIVERSITY OF SINGAPORE 2004 Founded 1905 DESIGN AND DEVELOPMENT OF A BENCH-TOP ELECTRO-ADSORPTION ... thermocouples, thermisters and RTD sensors. TIC controller unit is used to monitor the pressure of evaporator, reactor beds and condenser. Agilent and TIC controller softwares are 29 Chapter 3. Design, development and ... or out of the beds during the heating (desorption) and cooling (adsorption) of the beds and this is controlled by small on/off valves. A timed controller activates the opening and closing of the

Ngày tải lên: 04/10/2015, 10:25

... DESIGN AND DEVELOPMENT OF A CMOS POWER AMPLIFIER FOR DIGITAL APPLICATIONS KHOO EE SZE NATIONAL UNIVERSITY OF SINGAPORE 2003 Design and Development of a CMOS Power Amplifier for ... dimensions scale down and fT and fmax scale up, a Design and Development of a CMOS Power Amplifier for Digital Applications 1 CHAPTER 1: Introduction great deal of interest and research has been ... load is given by the product of the voltage across the load and the current flowing into the load. RF power is characterized in terms of RMS power. Design and Development of a CMOS Power Amplifier

Ngày tải lên: 04/10/2015, 10:25

... DESIGN AND DEVELOPMENT OF A SOCIAL ROBOTIC HEAD – DOROTHY DAI DONGJIAO NATIONAL UNIVERSITY OF SINGAPORE 2010 DESIGN AND DEVELOPMENT OF A SOCIAL ROBOTIC HEAD – DOROTHY DAI ... thousands of years; the development of robotics has been exploited at the end of the last century. After decades of hype and disappointment, (1980s and 1990s) robots are at last moving out of the ... co-supervisor, Prof Budiman Sastra (Adjunct Research Professor, Division of Engineering and Technology Management, National University of Singapore), for his professional guidance and invaluable

Ngày tải lên: 04/10/2015, 10:26

... DESIGN AND DEVELOPMENT OF AN AUTONOMOUS OMNI-DIRECTIONAL MOBILE ROBOT SEAN EFREM SABASTIAN (B.Eng.(Hons.)), NUS A THESIS SUBMITTED FOR THE DEGREE OF MASTER OF ENGINEERING DEPARTMENT OF MECHANICAL ... computer aided design (Figure 4) was visualized and constructed. This allowed a better understanding in the design and details of the various parts be it the screws, dimensions and materials. ... mechanical and the electronics of the system, it is now time to cover the software. To write and develop codes for the ARM Cortex M3, a product of STMicroelectronics, Rasisonnance Integrated Development Environment,

Ngày tải lên: 04/10/2015, 10:26

... and Development CHAPTER THREE DESIGN AND DEVELOPMENT 3.1 INTRODUCTION One of the major goals of this study was the design and development of different components of the experimental setup which ... picture of the turn table from (a) front and (b) rear side 3.4 DESIGN AND DEVELOPMENT OF AN ON-MACHINE PROFILE MEASUREMENT SYSTEM One of the most important targets of this study was to design ... profile of ground surface. Coordinate measuring machines (CMM) have become more and more important in measurements and authentication of dimensional excellence of 34 Chapter 3: Design and Development manufactured

Ngày tải lên: 04/10/2015, 10:26

... command and control system architecture for the AUVs An overview of the architectural design is illustrated in Fig 3.1... design, and the development of control and software ... DESIGN AND DEVELOPMENT OF COMMAND AND CONTROL SYSTEM FOR AUTONOMOUS UNDERWATER VEHICLES By TAN YEW TECK SUBMITTED IN PARTIAL FULFILLMENT OF THE REQUIREMENTS FOR THE DEGREE OF MASTER OF ENGINEERING AT NATIONAL ... is the design and development of a generic control and software architecture for a single modular AUV while allowing natural extensions to multi-vehicle scenarios. The proposed command and control

Ngày tải lên: 04/10/2015, 10:26

... [9] U Rohde, Microwave and Wireless Synthesizers:Theory and Design, Paterson, NJ: John Wiley & Sons, pp 1–5, 1997 [10] L Yang, S Basat, and A Rida, ? ?Design and development of novel miniaturized ... prior permission of the publisher Design and Development of Radio Frequency Identification (RFID) and RFID-Enabled Sensors on Flexible Low Cost Substrates Li Yang, Amin Rida, and Manos M Tentzeris ... Design and Development of Radio Frequency Identification (RFID) and RFID-Enabled Sensors on Flexible Low Cost Substrates Synthesis Lectures on RF/Microwaves Editor Amir Mortazawi, University of

Ngày tải lên: 08/03/2016, 11:21

... ADDIS ABABA UNIVERSITY SCHOOL OF INFORMATION SCIENCE AND SCHOOL OF PUBLIC HEALTH M.sc in Health Informatics Program Design and Development of Web Based Maternal and Child Nutrition Information ... ADDIS ABABA UNIVERSITY SCHOOL OF INFORMATION SCIENCE AND SCHOOL OF PUBLIC HEALTH M.sc in Health Informatics Program Design and Development of Web Based Maternal and Child Nutrition Information ... The title of my project is ? ?Design and development of web based maternal and Child Nutrition information system” The aim of this preliminary survey is to assess the existing source of information,

Ngày tải lên: 14/08/2017, 16:46

... percent of national produccion of oil, 46 percent of the produccion of the gas, and 16.6 percent of gas liquids Currently the produccion of gas in the region is of 190 mmpcd in average Of this ... hydrocarbons, applying equations of state (Peng-Robinson and Soave-Redlich-Kwong) The accuracy of this SPE 59029 DESIGN AND DEVELOPMENT OF HYDROCARBON SURFACE PRODUCTION FACILITIES AND PIPELINES BASED ON ... characteristics of the system (Diameter, Length, Thickness, Material of Contruction, Right of Way and Topographic Profile); and the Compositional Analysis of the Hydrocarbons (C1 to C6+, CO2, N2, H2S and

Ngày tải lên: 23/06/2018, 22:45

... control the release of drug from a suspension The purpose of this article is to suggest ideas and review principles for the scientist responsible for the design and development of parenteral suspension ... in temperature and handling of the stored vials (shipping test) Efficient siliconization of the vial will promote efficient drainage of the suspension and reduce the probability of particle agglomeration ... the tank and striking the baffle plate to spread into an easily deaerated film Parenteral suspensions, as a result of the method of manufacture and handling of the powder or as a result of the

Ngày tải lên: 17/02/2021, 21:03

... MINISTRY OF EDUCATION AND TRAINING HO CHI MINH UNIVERSITY OF TECHNOLOGY AND EDUCATION FACULTY OF MECHANICAL ENGINEERING GRADUATION PROJECT DESIGN AND DEVELOPMENT OF ALOE VERA PEELING AND DICING ... TECHNOLOGY AND EDUCATION DEPARTMENT OF MACHINERY MANUFACTURING TECHNOLOGY GRADUATION PROJECT DESIGN AND DEVELOPMENT OF ALOE VERA PEELING AND DICING SYSTEM Advisor: Assoc.Prof., Dr NGUYEN TRUONG THINH ... vera and why we need to develop Aloe vera peeling and dicing system It highlights the detail design solutions considering the peeling principle Besides, chapter describes a method of design and development

Ngày tải lên: 25/12/2021, 23:12

... I2C subsystem, and USB gadgets. vi Embedded Linux System Design and Development Ⅲ Borland is a registered trademark of Borland Software Corporation in the United States and other countries. ... System Design and Development Support Denx Software Engineering provides software engineering services in the area of embedded and real-time systems with a strong focus on open source software, ... trademark of Apple computer. Ⅲ SuperH is a trademark of Hitachi, Ltd. Ⅲ Windows, WinCE and Microsoft are registered trademarks and MS-DOS and DirectX .are trademarks of Microsoft Corporation. ...

Ngày tải lên: 04/08/2012, 14:23

... shows the relative importance of the various kinds of data written to disk, both in terms of how much of the live blocks they occupy on disk and in terms of how much of the data written to the log ... 4 — Disk space and log bandwidth usage of /user6 For each block type, the table lists the percentage of the disk space in use on disk (Live data) and the percentage of the log bandwidth consumed ... consists of program development, text pro- cessing, electronic communication, and simula- tions. /pcs Home directories and project area for research on parallel processing and VLSI circuit design. /src/kernel Sources...

Ngày tải lên: 12/09/2012, 15:05

... Software Design & Development Software Design & Development Day 1 - Definitions and Overview Day 2 - Software Design Software Development Day 2 - Software Design Reviewing the design ... Software Design Software Design Day 2 - Software Design Analyze requirements Create design Analyze and review Correct and improve Utilize prototype to investigate and resolve key requirements and ... out and describe, review, improve, and approve the design. Day 2 - Software Design Design includes an evaluation of the adequacy of the detailed technical requirements, an evaluation of...

Ngày tải lên: 15/10/2013, 23:13