crude fiber test method

Tài liệu Standard Test Method forPour Point of Petroleum Products1 ppt

... of Residual Fuel Oil 4 D 2500 Test Method for Cloud Point of Petroleum Products D 3245 Test Method for Pumpability of Industrial Fuel Oils D 5853 Test Method for Pour Point of Crude Oils E1 Specification ... used, the ASTM test method designation number specific to the technique shall be reported with the results. A procedure for testing the pour point of crude oils is described in Test Method D 5853. 1.3 ... the IP, this test method is under the jurisdiction of the Standardization Committee. This test method was adopted as a joint ASTM-IP Standard in 1965. 2 Statements defining this test and its significance...

Ngày tải lên: 19/02/2014, 20:20

9 597 0

Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)

... speci- ﬁcations. Further, this test method is referenced by numerous other speciﬁcations and test methods. Caution must be exer- cised in using the results of this test method to predict the strength ... changes to this test method since the last issue, C109/C109M – 05, that may impact the use of this test method. (Approved August 15, 2007). (1) Revised 5.9.3. TABLE A1.5 Bias Tests (Example Using ... Defense. 1. Scope* 1.1 This test method covers determination of the compressive strength of hydraulic cement mortars, using 2-in. or [50-mm] cube specimens. NOTE 1 Test Method C349 provides an...

Ngày tải lên: 26/03/2014, 21:55

10 852 0

CONSTRUCTION MATERIALS TESTING TEST METHOD SELECTION LIST docx

... CONSTRUCTION MATERIALS TESTING APPLICATION (REV. 2005-08-10) PAGE 1 OF 10 CONSTRUCTION MATERIALS TESTING TEST METHOD SELECTION LIST Instructions: Check each test method for which you are ... programs. The proficiency sample program involves testing a sample of material in accordance with the standard test methods specified. The test results are returned for statistical analysis. ... NVLAP Code Test Method Designation Short Title ADMIXTURES _____ 02/A35 ASTM C233 Testing Air-Entraining Admixtures for Concrete _____ 02/A36 ASTM C311 Sampling and Testing Fly Ash...

Ngày tải lên: 10/07/2014, 23:20

10 475 1

Pressure Piping Alternative Test Methods Procedure Requirements ppsx

... Table 341.3.2) Initial Service Leak Test Visual Examination Acce ptable Record Test Pressure: Alternative Test Methods in Lieu of Hydrostatic Leak Test Request Form, QC Documents, NDE ... 1 Alternative Test Methods in Lieu of Hydrostatic Leak Testing for Pre ssure Piping Constructed to ASME B31.3 Purpose: This AB - 519 Pressure Piping Alternative Test Methods Procedure ... justify the use of alternative test methods in lieu of a hydrostatic leak test. In such cases each submission for a specific closure weld that would use alternative test methods would require accep tance...

Ngày tải lên: 31/07/2014, 23:21

13 415 2

ASTM D5453 Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons, Spark Ignition Engine Fuel, Diesel Engine Fuel, and Engine Oil by Ultraviolet Fluorescence

... Documents 2.1 ASTM Standards: 2 D1298 Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Prod- ucts by Hydrometer Method D4052 Test Method for Density, Relative ... mass of the test specimen and the total mass of the test specimen and solvent. 11.1.2 Volumetric Dilution (mass/volume)— Record the mass of the test specimen and the total volume of the test specimen ... response for test specimen solution, counts, K g = gravimetric dilution factor, mass of test specimen/ mass of test specimen and solvent, g/g, K v = volumetric dilution factor, mass of test specimen/ volume...

Ngày tải lên: 20/10/2014, 17:16

11 1,7K 2

ASTM D129 Standard Test Method for Sulfur in Petroleum Products (General High Pressure Decomposition Device Method)

... Section(s): Standards Body: e ASTM D129: Standard Test Method for Sulfur in Petroleum Products (General Bomb Method) 40 CFR 60.106(j)(2) American Society for Testing and Materials ...

Ngày tải lên: 20/10/2014, 17:16

6 406 4

ASTM D86 Standard Test Method for Distillation of Petroleum Products at Atmospheric Pressure

... Measurement D5949 Test Method for Pour Point of Petroleum Products (Automatic Pressure Pulsing Method) D5950 Test Method for Pour Point of Petroleum Products (Automatic Tilt Method) D5985 Test Method for ... and Petroleum Products D4953 Test Method for Vapor Pressure of Gasoline and Gasoline-Oxygenate Blends (Dry Method) D5190 Test Method for Vapor Pressure of Petroleum Prod- ucts (Automatic Method) (Withdrawn ... of the method( s) identiﬁed may be required. 2.2 ASTM Standards: 3 D97 Test Method for Pour Point of Petroleum Products D323 Test Method for Vapor Pressure of Petroleum Products (Reid Method) D4057...