configure cisco catalyst 2950 switch

... Medium-Sized Catalyst Switches 107 Catalyst 1900 108 Catalyst 2820 110 Catalyst 2900XL Series 111 Catalyst 3000 Series 113 Catalyst 3900 Series 114 Catalyst 4000 Series 115 Page vii Chapter 6 The Catalyst ... Line Cards 131 Catalyst 8510 Line Cards 132 The Chassis 132 Catalyst 2900 Series 132 Catalyst 5002 Series 133 Catalyst 5000 134 Catalyst 5505 135 Catalyst 5509 135 Catalyst 5500 136 Catalyst 5000 ... Routing) 249 Configuring the Route Switch Module (RSM) 251 Multilayer Switching (MLS) Defined 252 Configuring Multilayer Switching 262 Chapter 9 Configuring Token Ring and FDDI on the Catalyst Switch 271 Token...

Ngày tải lên: 21/12/2013, 04:18

... Tài liệu đào tạo – Phần B: Cisco Catalyst Switch 4006 và 3524XL Trang 5 Hình 1-2: Catalyst 3524XL switch. Catalyst 3500 series XL switches là một workgroup switch hỗ trợ kết nối Gigabit ... Catalyst3 524_1(config-if)#switchport mode trunk Catalyst3 524_1(config-if)#switchport trunk encapsulation dot1q Catalyst3 524_1#sh interfaces gigabitEthernet 0/1 switchport Name: Gi0/1 Switchport: ... B: Cisco Catalyst Switch 4006 và 3524XL Trang 38 2/2 1-2 Catalyst4 006> (enable) Catalyst3 524_1 #configure terminal Enter configuration commands, one per line. End with CNTL/Z. Catalyst3 524_1(config)#interface...

Ngày tải lên: 20/12/2013, 22:15

Ngày tải lên: 25/07/2014, 08:20

Ngày tải lên: 25/07/2014, 08:20

Ngày tải lên: 17/10/2014, 15:52

... - CATALYST 2950 SWITCH CONFIGURATION 1. In this lab, you will configure basic IOS commands on switch3 and switch4 which are Catalyst 2950 switches. 2. From the NetSim tool bar, select Switch3 ... Rights Reserved. LAB 13 – VLANs and TRUNKING (Catalyst 2950 Switches) 1. In this lab, you will set up VLANs on switch3 and switch4 (Catalyst 2950 switches) and test them by pinging between router3 ... protocol does the 2950 use – ISL or 802.1Q? 2950swx(config)# interface fa0/12 2950swx(config-if)# switchport mode trunk 2950swx(config-if)# ctrl-z 2950swx# show interface fa0/12 switchport 10....

Ngày tải lên: 29/09/2013, 22:20

Ngày tải lên: 21/12/2013, 04:18

Ngày tải lên: 21/12/2013, 04:19

Ngày tải lên: 21/12/2013, 19:15

Ngày tải lên: 17/02/2014, 08:20

Ngày tải lên: 24/03/2014, 08:20

Ngày tải lên: 17/02/2014, 08:20

... B. • The switch has the address for station B in the MAC address table. © 2002, Cisco Systems, Inc. All rights reserved. 2 Configuring Catalyst Switch Operations Module 3 © 2002, Cisco Systems, ... Layer 2 switching and bridging operations and modes • Describe how LAN switches use and populate the MAC address table © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-4© 2002, Cisco ... reserved. © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-6 • Address learning • Forward/filter decision • Loop avoidance Ethernet Switches and Bridges © 2002, Cisco Systems, Inc....

Ngày tải lên: 08/07/2013, 01:27

... redundant switched or bridged topologies © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-8 Spanning-Tree Port States (Cont.) © 2002, Cisco Systems, Inc. All rights reserved. © 2002, Cisco ... 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-14 Rapid Transition to Forwarding © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-13 Rapid Spanning-Tree Protocol © 2002, Cisco ... lowest bridge ID • Bridge ID = • In the example, which switch has the lowest bridge ID? Spanning-Tree Protocol Root Bridge Selection © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-15 Summary • STP...

Ngày tải lên: 08/07/2013, 01:27

... Multilayer Switching Multilayer Switching Route Processor Multilayer Switching Switch Engine Multilayer Switching Protocol Multicast Open Shortest Path First Multistation Access Unit Multilayer Switch ... distribution layer switches must also be able to participate in multi-layer switching (MLS) and be able to handle a route processor. The Cisco switches that provide these functions are: 640-604 Switching ... CLI-based switches only, this command can only be applied to them. 640-604 Switching 3.0 www.testking.com - 29 - 1.5.1 The Switch Block The switch block is a combination of layer 2 switches...

Ngày tải lên: 16/10/2013, 13:15

... the Basic Switch Configuration lab. Step 2 Configure the host attached to the switch Configure the host to use the same IP subnet for the address, mask, and default gateway as on the switch. ... TFTP server. ALSwitch#rename flash: c2950-c3h2s-mz.120-5.3.WC.1.bin flash: c2950- c3h2s-mz.120-5.3.WC.1.old b. Enter the following to verify that the renaming was successful: ALSwitch#dir flash: ... bytes free) ALSwitch# c. As a precaution, enter the following to disable access to the switch HTML pages: ALSwitch(config)#no ip http server Remove existing html files ALSwitch# delete...

Ngày tải lên: 16/10/2013, 21:15

... workplace. Table 1-2 Additional Cisco Certifications Certification Purpose, Prerequisites CCNA-WAN Basic certification for Cisco WAN switches. CCNP-WAN Intermediate certification for Cisco WAN switches. Requires ... people working for Cisco Resellers and Certified Partners. Cisco fulfills only a small portion of its orders via direct sale from Cisco; most times, a Cisco reseller is involved. Cisco has not attempted ... 82 Communicating Between Switches 83 Cisco Discovery Protocol 83 Switch Clustering and Stacking 85 Switch Port Configuration 86 Identifying Ports 86 Assigning a Port Description on an IOS-Based Switch 86 Assigning...

Ngày tải lên: 18/10/2013, 18:15

... trị Switch của Cisco. Vậy, hãy thử khám phá những bước cơ bản về vị trí n ày. Đăng nhập Trước khi bạn có thể quản trị Switch, bạn cần biết một số thông tin căn bản sau: • Địa chỉ IP của switch ... bước cơ bản trong quản lý switch bằng Cisco IOS giao diện dòng lệnh. Hiển thị cấu hình switch Cũng giống như trên một router, lệnh IOS dùng để hiển thị cấu hình switch với tất cả các cổng Ethernet. ... interface để thấy tình tr ạng của nó Những điều căn bản trong quản trị Switch Cisco – phần 1 Đôi khi, bạn sẽ phải cấu hình một cổng switch hoặc tìm địa chỉ MAC trên mỗi cổng. Có thể, đây không phải...

Ngày tải lên: 20/10/2013, 04:15

... troubleshooting InterVLAN routing on a Cisco IOS-based switch? A. Switch( config)#ip routing B. Switch# show ip routing C. Switch( config)#routing D. Switch# show routing Answer: B Explanation: ... 1. Which Cisco switch command will you use? A. Switch( config)#vlan 10-20 instance 1 B. Switch( config)#instance 1 vlan 10-20 C. Switch( config-mst)#vlan 10-20 instance 1 D. Switch( config-mst)#instance ... A. Multiplayer switching B. Cisco express routing C. Multilayer switching D. Multilayer routing E. Router express forwarding Answer: C Explanation: Multilayer Switching Switch Engine...

Ngày tải lên: 26/10/2013, 23:15