code of practice for wind loads

... eave details for flat roofs Figure 18 — Key for inset storey Figure 19 — Key for monopitch roofs Figure 20 — Key for duopitch roofs Figure 21 — Key for hipped roofs Figure 22 — Key for mansard ... STANDARD Loading for buildings — Part 2: Code of practice for wind loads ICS 91.080.01 BS 6399-2: 1997 BS 6399-2:1997 Committees responsible for this British Standard The preparation of this British ... estimation of extreme winds Journal of Wind Engineering and Industrial Aerodynamics 1982, 9, 295-323 [12] COOK, N.J Note on directional and seasonal assessment of extreme winds for design Journal of Wind

Ngày tải lên: 08/07/2014, 22:20

... Specification for SI units and recommendations for the use of their multiples and of certain other units Loading for buildings Code of practice for wind loads Code of practice for imposed roof loads ... inertia, loads, but excluding wind loads 3.3 storage height The height of the space between a floor and a physical constraint to the height of storage formed by a ceiling, soffit of a floor, roof or ... Inside front cover Foreword ii Code of practice Scope References Definitions Dead loads Imposed floor and ceiling loads Reduction in total imposed floor loads Imposed roof loads Crane gantry girders

Ngày tải lên: 08/07/2014, 22:20

... account to be taken of the variation of snow in the United Kingdom and the effect of redistribution of snow on roofs due to wind. Use of the uniformly distributed snow loads are subject to ... c) a uniformly distributed load of 0.6 kN/m 2 measured on plan for roof slopes of 30° or less; or a uniformly distributed load of 0.6 [(60 – a)/30] kN/m 2 measured on plan for roof slopes ... Specification for SI units and recommendations for the use of their multiples and of certain other units1) BS 6399, Loading for buildings BS 6399-1 ,Code of practice for dead and

Ngày tải lên: 08/07/2014, 22:20

... Department of Agriculture of Environment of Health for Planning and Infrastructure ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS IN WESTERN AUSTRALIA Environmental Code of Practice for Poultry ... ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS IN WESTERN AUSTRALIA 52 ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS IN WESTERN AUSTRALIA PART APPENDICES 53 ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY ... Farmers Association of WA President WA Broiler Growers Association May 2004 iii ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS IN WESTERN AUSTRALIA iv ENVIRONMENTAL CODE OF PRACTICE FOR POULTRY FARMS

Ngày tải lên: 17/03/2014, 10:20

... Code of Practice for Revenue Audit www.revenue.ie To serve the community by fairly and efficiently collecting taxes and duties and implementing Customs controls CODE OF PRACTICE FOR REVENUE ... FINALISATION OF A REVENUE AUDIT 4.1 MONETARY SETTLEMENT 4.2 BASIS OF AUDIT SETTLEMENT 4.3 INTEREST 4.4 SURCHARGE FOR LATE SUBMISSION OF RETURNS 4.5 PENALTIES 4.6 CATEGORIES OF TAX DEFAULT 4.7 TIMEFRAME FOR ... Acquisitions Tax (CAT) Within 12 months of the due date for filing the relevant return *Self–correction for VAT Before the due date for filing the IT or CT return for the chargeable period within which

Ngày tải lên: 29/03/2014, 22:20

... Part 4: Code of practice for design of composite slabs with profiled steel sheeting; — Part 5: Code of practice for design of cold formed sections; — Part 61): Code of practice for design of light ... for buildings BS 6399-1:1984, Code of practice for dead and imposed loads BS 6399-3:1988, Code of practice for imposed roof loads BS 8110, Structural use of concrete BS 8110-1:1985, Code of practice ... construction BS 5950-6, Code of practice for design of light gauge sheeting, decking and cladding7) BS 5950-8:1990, Code of practice for fire resistant design BS 5975:1982, Code of practice for falsework

Ngày tải lên: 08/07/2014, 22:20

... use of steelwork in building Code of practice for design of cold formed sections Loading for buildings Code of practice for dead and imposed loads Code of practice for wind loading Code of practice ... construction Code of practice for design of simple and continuous composite beams Code of practice for design of composite slabs with profiled steel sheeting Code of practice for design of cold formed sections ... sections Code of practice for design of light gauge profiled steel sheeting Specification for materials and workmanship: cold formed sections Code of practice for fire resistant design Code of practice

Ngày tải lên: 08/07/2014, 22:20

... 3.21): Code of practice for design of composite columns and frames; — Part 4: Code of practice for design of floors with profiled steel sheeting; — Part 5: Code of practice for design in cold formed ... Code of practice for design of floors with profiled steel sheeting BS 8110, Structural use of concrete BS 8110-2, Code of practice for special circumstances CP 290, Code of practice for suspended ... 61): Code of practice for design in light gauge sheeting, decking and cladding; — Part 71): Specification for materials and workmanship: cold formed sections; — Part 8: Code of practice for fire

Ngày tải lên: 08/07/2014, 22:20

... 5950-4:1982, Code of practice for design of floors with profiled steel sheeting BS 5950-5:1987, Code of practice for design of cold formed sections BS 5950-6, Code of practice for design of light ... 3.1 Code of practice for design of simple and continuous composite beams; — Part 4: Code of practice for design of composite slabs with profiled steel sheeting; — Part 5: Code of practice for ... 6399-3:1988, Code of practice for imposed roof loads BS 8004:1986, Code of practice for foundations BS EN 10002, Tensile testing of metallic materials BS EN 10002-1:1990, Method of test at ambient

Ngày tải lên: 08/07/2014, 22:20

... requirements of paragraph(9.1) Page 19 of 20 Code of Practice for Energy Efficiency of Air Conditioning Installations 10 SUBMISSION OF INFORMATION The following information ... device for regulation of temperature Page 7 of 20 Code of Practice for Energy Efficiency of Air Conditioning Installations 7.1.2 Thermostatic controls for comfort... ... assumed for cement or black matt surfaces at indoor still air condition Page 14 of 20 Code of Practice for Energy Efficiency of Air Conditioning Installations. .. for

Ngày tải lên: 28/09/2014, 23:44

... of Code of Practice for Energy Efficiency of Electrical Installations * - delete as appropriate... _ Page 13 of 46 Code of Practice for Energy Efficiency of ... Page 12 of 46 Code of Practice for Energy Efficiency of Electrical Installations _ SCHEDULE OF FORMS Page FORM EL-1: Electrical Installations Summary 14 FORM EL-2: ... comply with the Code of Practice for Energy Efficiency of Lift & Escalator Installations? Yes No D Power Factor Improvement... Page 9 of 46 Code of Practice for Energy

Ngày tải lên: 28/09/2014, 23:44

... Code of Practice for Energy Efficiency of Lift and Escalator Installations Foreword The Code of Practice for Energy Efficiency of Lift and Escalator Installations ... Special Administrative Region Page of 20 Code of Practice for Energy Efficiency of Lift and Escalator Installations Code of Practice On The Design and Construction of Lifts and Escalators published ... conflicting requirements of this Code of Practice: Code of Practice For The Electricity Wiring Regulation published by Electrical & Mechanical Services Department, Government of The Hong Kong Special

Ngày tải lên: 28/09/2014, 23:44

... Density FORM LG-3 : List of Submitted Drawings and Documents Page 10 of 38 Code of Practice for Energy Efficiency of Lighting Installations Schedule of Forms FORM LG -(G) ... Documents Code of Practice for Energy Efficiency of Lighting Installations Note: this page is blank FORM LG – (G) Ref No [ for office use only ] Summary of Information on ... [...]... SUBMISSION OF INFORMATION 5.1 The following standard forms are relevant to the provision of information in relation to this Code :FORM LG-1 : Data of Lamps & Luminaires FORM LG-2 :

Ngày tải lên: 28/09/2014, 23:45

... Guidelines for completing the ship/shore safety checklist Appendix - Form for cargo information I:\ASSEMBLY\20\RES\862 A 20/Res.862 -4- CODE OF PRACTICE FOR THE SAFE LOADING AND UNLOADING OF BULK ... unloading of bulk carriers, RECOGNIZING FURTHER that such improvement could be achieved by the establishment of a composite code of practice for the safe loading and unloading of bulk carriers, For ... This Code of Practice for the Safe Loading and Unloading of Bulk Carriers has been developed by the International Maritime Organization to minimize losses of bulk carriers The purpose of the Code

Ngày tải lên: 26/04/2016, 08:19

... Appendix Guidelines for completing the ship/shore safety checklist 20 Appendix Form for cargo information 25 INTRODUCTION This Code of Practice for the Safe Loading and Unloading of Bulk Carriers ... of the ship 5.1.4 Any requirement for cargo trimming should be in accordance with the procedures of the IMO Code of Safe Practice for Solid Bulk Cargoes (BC Code) or the International Grain Code, ... In the event of a conflict between this Code and the International Code for the Safe Carriage of Grain in Bulk (International Grain Code) , the provisions of the International Grain Code should

Ngày tải lên: 08/05/2016, 08:37

... Institute on 15/8/2005 P295: Commentary on BS 5400-3: 2000, Code of practice for the design of steel bridges tailieuxdcd@gmail.com FOREWORD Foreword to Commentary on BS 5400-3: 1982 Licensed copy:fm03, ... Code of practice for the design of steel bridges iii tailieuxdcd@gmail.com Licensed copy:fm03, Faber Maunsell, 15/08/2007, Uncontrolled Copy, © SCI P295: Commentary on BS 5400-3: 2000, Code of ... 15/8/2005 P295: Commentary on BS 5400-3: 2000, Code of practice for the design of steel bridges 155 vii tailieuxdcd@gmail.com By enhancing the design force the Code does not make it clear that both bending

Ngày tải lên: 31/10/2016, 20:47

... 7/9/02 10:24 Page i Code of Practice for Project Management for Construction and Development 00 7/9/02 10:24 Page ii 00 7/9/02 10:24 Page iii Code of Practice for Project Management for Construction ... Management for Construction and Development, 2nd edition (1996), The Chartered Institute of Building ■ Code of Practice for Selection of Main Contractors (1997), Construction Industry Board ■ Code of Practice ... Institution of Chartered Surveyors ■ Code of Estimating Practice, 5th edition (1983), The Chartered Institute of Building 207 07 7/9/02 10:29 Page 208 Bibliography 208 ■ Code of Practice for Project

Ngày tải lên: 06/04/2017, 04:21

... Hong Kong codes relevant to building structures These are: the Code of Practice on Wind Effects, the Code of Practice for the Structural Use of Concrete 2004, the Code of Practice for Precast ... designing to normal codes of practice Typically, for example, the performance specification might state:- “The design must comply with the Code of Practice for the Structural Use of Steel 2005” When ... reviewed in the preparation of the Code of Practice for the Structural Use of Steel 2005 (the ? ?Code? ??), and should be read in conjunction with the Code Elaborations on robustness of structures, steel

Ngày tải lên: 30/04/2018, 09:04

... edition 2005-06-15 Information technology — Security techniques — Code of practice for information security management Technologies de l'information — Techniques de sécurité — Code de pratique ... guidelines This code of practice may be regarded as a starting point for developing organization specific guidelines. Not all of the controls and guidance in this code of practice may be applicable. ... 13.2.3 for collection of evidence). The formal disciplinary process should ensure correct and fair treatment for employees who are suspected of committing breaches of security. The formal...

Ngày tải lên: 21/02/2014, 10:20

... types of luminaires, their ratings and operating characteristics; Code of Practice for Building Energy Audit EAC_2012 1 of 11 EMSD 1. Introduction 1.1 This Code of Practice titled Code of ... first day of operation of the building; ii) indication of the EUI per annum (MJ/m 2 /annum) (based on the total energy consumption data in item i)), respectively for - Code of Practice for Building ... Audit Form, to reflect the energy usage intensity of the central building services installations. The Energy Audit Form is a specified form under the Ordinance. Code of Practice for Building...

Ngày tải lên: 15/03/2014, 20:20