cisco catalyst 296024tt ethernet switch
Tài liệu Cisco Catalyst Switch 4006 vaø 3524XL ppt
... tạo – Phần B: Cisco Catalyst Switch 4006 và 3524XL Trang 5 Hình 1-2: Catalyst 3524XL switch. Catalyst 3500 series XL switches là một workgroup switch hỗ trợ kết nối Gigabit Ethernet và ... Catalyst3 524_1(config-if)#switchport mode trunk Catalyst3 524_1(config-if)#switchport trunk encapsulation dot1q Catalyst3 524_1#sh interfaces gigabitEthernet 0/1 switchport Name: Gi0/1 Switchport: ... B: Cisco Catalyst Switch 4006 và 3524XL Trang 38 2/2 1-2 Catalyst4 006> (enable) Catalyst3 524_1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Catalyst3 524_1(config)#interface...
Ngày tải lên: 20/12/2013, 22:15
Tài liệu Cisco Catalyst LAN Switching docx
... Medium-Sized Catalyst Switches 107 Catalyst 1900 108 Catalyst 2820 110 Catalyst 2900XL Series 111 Catalyst 3000 Series 113 Catalyst 3900 Series 114 Catalyst 4000 Series 115 Page vii Chapter 6 The Catalyst ... Line Cards 131 Catalyst 8510 Line Cards 132 The Chassis 132 Catalyst 2900 Series 132 Catalyst 5002 Series 133 Catalyst 5000 134 Catalyst 5505 135 Catalyst 5509 135 Catalyst 5500 136 Catalyst 5000 ... Fast Ethernet, much less Gigabit Ethernet. In the backbone there will be the need to pass traffic now flowing from Fast Ethernet and Switched Ethernet stations as opposed to the Shared Ethernet Page...
Ngày tải lên: 21/12/2013, 04:18
VIRTUAL CHASSIS TECHNOLOGY ON EX8200 ETHERNET SWITCH MODULAR PLATFORMS
Ngày tải lên: 28/06/2013, 08:59
Lab 6.2.9 Firmware Upgrade of a Catalyst 2900 Series Switch
... bytes free) ALSwitch# c. As a precaution, enter the following to disable access to the switch HTML pages: ALSwitch(config)#no ip http server Remove existing html files ALSwitch# delete ... may be needed. b. Re-enable access to the switch HTML pages as follows: ALSwitch(config)#ip http server Step 7 Restart the switch a. Restart the switch using the reload command to see if the ... the Basic Switch Configuration lab. Step 2 Configure the host attached to the switch Configure the host to use the same IP subnet for the address, mask, and default gateway as on the switch. ...
Ngày tải lên: 16/10/2013, 21:15
Tài liệu Lab 6.2.8 Password Recovery Procedure on a Catalyst 2900 Series Switches ppt
Ngày tải lên: 24/01/2014, 19:20
Tài liệu Lab 6.2.8 Password Recovery Procedure on a Catalyst 2900 Series Switches docx
Ngày tải lên: 24/01/2014, 19:20
Tài liệu Lab 6.2.9 Firmware Upgrade of a Catalyst 2900 Series Switch doc
Ngày tải lên: 24/01/2014, 19:20
NSH-5632 quản lí 24 khe Fasst Ethernet SFP 4G combo Switch L3
... Thông số kỹ thuật: NSH-5632 Quản lý 24 khe Fast Ethernet SFP + 4G Combo Switch L3 Tiêu chuẩn: IEEE 802.3u 100Base-FX Thông qua: 14,880/148,800/1,488,000 gói/giây ...
Ngày tải lên: 01/02/2013, 11:53
CCNA - V3 P1 - Configuring Catalyst Switch Operations
... B. • The switch has the address for station B in the MAC address table. © 2002, Cisco Systems, Inc. All rights reserved. 2 Configuring Catalyst Switch Operations Module 3 © 2002, Cisco Systems, ... reserved. © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-6 • Address learning • Forward/filter decision • Loop avoidance Ethernet Switches and Bridges © 2002, Cisco Systems, Inc. ... Layer 2 switching and bridging operations and modes • Describe how LAN switches use and populate the MAC address table © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-4© 2002, Cisco...
Ngày tải lên: 08/07/2013, 01:27
CCNA P3 V3 Configuring a Catalyst Switch
... redundant switched or bridged topologies © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-8 Spanning-Tree Port States (Cont.) © 2002, Cisco Systems, Inc. All rights reserved. © 2002, Cisco ... 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-14 Rapid Transition to Forwarding © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-13 Rapid Spanning-Tree Protocol © 2002, Cisco ... lowest bridge ID • Bridge ID = • In the example, which switch has the lowest bridge ID? Spanning-Tree Protocol Root Bridge Selection © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-15 Summary • STP...
Ngày tải lên: 08/07/2013, 01:27
VLANs and TRUNKING (Catalyst 1900 Switches)
... - CATALYST 2950 SWITCH CONFIGURATION 1. In this lab, you will configure basic IOS commands on switch3 and switch4 which are Catalyst 2950 switches. 2. From the NetSim tool bar, select Switch3 ... Rights Reserved. LAB 13 – VLANs and TRUNKING (Catalyst 2950 Switches) 1. In this lab, you will set up VLANs on switch3 and switch4 (Catalyst 2950 switches) and test them by pinging between router3 ... Reserved. LAB 11 – VLANS and TRUNKING (Catalyst 1900 Switches) 5a. Question: what VTP operating mode are the switches in? • Answer: the Catalyst 1900 switch defaults to ‘server’ mode. 6a....
Ngày tải lên: 29/09/2013, 22:20
Study Guide Switching 3.0 (Building Cisco Multilayer Switched Networks)
... Multilayer Switching Multilayer Switching Route Processor Multilayer Switching Switch Engine Multilayer Switching Protocol Multicast Open Shortest Path First Multistation Access Unit Multilayer Switch ... 1.5.2.5 Layer 3 Core 2. Basic Switch and Port Configuration 2.1 Network Technologies 2.1.1 Ethernet 2.1.1.1 Ethernet Switches 2.1.1.2 Ethernet Media 640-604 Switching 3.0 www.testking.com ... CLI-based switches only, this command can only be applied to them. 640-604 Switching 3.0 www.testking.com - 29 - 1.5.1 The Switch Block The switch block is a combination of layer 2 switches...
Ngày tải lên: 16/10/2013, 13:15
Cisco CCNP Switching Exam Certification Guide
... Access on an IOS-Based Switch 82 Enabling Remote Access on a CLI-Based Switch 82 Communicating Between Switches 83 Cisco Discovery Protocol 83 Switch Clustering and Stacking 85 Switch Port Configuration ... people working for Cisco Resellers and Certified Partners. Cisco fulfills only a small portion of its orders via direct sale from Cisco; most times, a Cisco reseller is involved. Cisco has not attempted ... Design Chapter 3, “Basic Switch and Port Configuration” Desktop Connectivity with Ethernet, Desktop Connectivity with Token Ring, Connecting Switches, Switch Management, and Switch Port Configuration Chapter...
Ngày tải lên: 18/10/2013, 18:15
Những điều căn bản trong quản trị Switch Cisco – phần 1
... trong quản lý switch bằng Cisco IOS giao diện dòng lệnh. Hiển thị cấu hình switch Cũng giống như trên một router, lệnh IOS dùng để hiển thị cấu hình switch với tất cả các cổng Ethernet. Muốn ... trị Switch của Cisco. Vậy, hãy thử khám phá những bước cơ bản về vị trí n ày. Đăng nhập Trước khi bạn có thể quản trị Switch, bạn cần biết một số thông tin căn bản sau: • Địa chỉ IP của switch ... interface và sử dụng lệnh speed: Trên switch này, tốc độ của 10/100 cổng Ethernet được đặt là auto, 10 và 100. Trên c ổng Gigabit Ethernet bạn chỉ có thể điều chỉnh switch với tốc độ của cổng l à...
Ngày tải lên: 20/10/2013, 04:15