cisco catalyst 2960 network switch

Tài liệu Cisco Catalyst Switch 4006 vaø 3524XL ppt

Tài liệu Cisco Catalyst Switch 4006 vaø 3524XL ppt

... Tài liệu đào tạo – Phần B: Cisco Catalyst Switch 4006 và 3524XL Trang 5 Hình 1-2: Catalyst 3524XL switch. Catalyst 3500 series XL switches là một workgroup switch hỗ trợ kết nối Gigabit ... Catalyst3 524_1(config-if)#switchport mode trunk Catalyst3 524_1(config-if)#switchport trunk encapsulation dot1q Catalyst3 524_1#sh interfaces gigabitEthernet 0/1 switchport Name: Gi0/1 Switchport: ... B: Cisco Catalyst Switch 4006 và 3524XL Trang 38 2/2 1-2 Catalyst4 006> (enable) Catalyst3 524_1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Catalyst3 524_1(config)#interface...

Ngày tải lên: 20/12/2013, 22:15

59 519 3
Tài liệu Cisco Catalyst LAN Switching docx

Tài liệu Cisco Catalyst LAN Switching docx

... Medium-Sized Catalyst Switches 107 Catalyst 1900 108 Catalyst 2820 110 Catalyst 2900XL Series 111 Catalyst 3000 Series 113 Catalyst 3900 Series 114 Catalyst 4000 Series 115 Page vii Chapter 6 The Catalyst ... Line Cards 131 Catalyst 8510 Line Cards 132 The Chassis 132 Catalyst 2900 Series 132 Catalyst 5002 Series 133 Catalyst 5000 134 Catalyst 5505 135 Catalyst 5509 135 Catalyst 5500 136 Catalyst 5000 ... thinking that the switch provided all the segmentation necessary. A flat network is a network with little or no logical segmentation. The networks in Figures 1-11 through 1-13 are all flat networks....

Ngày tải lên: 21/12/2013, 04:18

379 342 0
Lab 6.2.9 Firmware Upgrade of a Catalyst 2900 Series Switch

Lab 6.2.9 Firmware Upgrade of a Catalyst 2900 Series Switch

... bytes free) ALSwitch# c. As a precaution, enter the following to disable access to the switch HTML pages: ALSwitch(config)#no ip http server Remove existing html files ALSwitch# delete ... may be needed. b. Re-enable access to the switch HTML pages as follows: ALSwitch(config)#ip http server Step 7 Restart the switch a. Restart the switch using the reload command to see if the ... the Basic Switch Configuration lab. Step 2 Configure the host attached to the switch Configure the host to use the same IP subnet for the address, mask, and default gateway as on the switch. ...

Ngày tải lên: 16/10/2013, 21:15

4 337 0
The Network Switching Subsystem

The Network Switching Subsystem

... being used in the network. Each GSM phone has a unique identifier, its IMEI, which cannot be altered without destroying the phone. The IMEI contains a serial number and a The Network Switching Subsystem 37 VLR ... benefit from such synergy. 34 GSM Networks: Protocols, Terminology, and Implementation VLR VLR VLR HLR HLR MSC MSC MSC MSC MSC Figure 4.3 The NSS hierarchy. 4 The Network Switching Subsystem The NSS ... area, while the HLR deals with tasks that are independent of a subscriber’s location. The The Network Switching Subsystem 33 subscriber A: Ki 12345678 subscriber B: Ki 23415670 subscriber C: Ki...

Ngày tải lên: 19/10/2013, 03:20

8 424 0
Tài liệu Cisco IP Telephony Network Design Guide docx

Tài liệu Cisco IP Telephony Network Design Guide docx

... phone IP Catalyst switch 40779 Chapter 2 Campus Infrastructure Considerations Network Infrastructure 2-6 Cisco IP Telephony Network Design Guide 78-11103-03 Figure 2-2 Switched 10/100 Ethernet Network ... Telephony Network Design Guide 78-11103-03 Figure 1-2 Single-Site Model IP WAN PSTN Catalyst backbone Catalyst wiring closet Cisco CallManager cluster Msg store Msg store LDAP Directory Cisco uOne GateServer IP IP IP IP 40764 ... 95134-1706 USA http://www .cisco. com Cisco Systems, Inc. Corporate Headquarters Tel: 800 553-NETS (6387) 408 526-4000 Fax: 408 526-4100 Cisco IP Telephony Network Design Guide Cisco CallManager Release...

Ngày tải lên: 10/12/2013, 16:15

262 484 0
Tài liệu Cisco IP Telephony Network Design Guide - Cisco CallManager Release 3.0(5) doc

Tài liệu Cisco IP Telephony Network Design Guide - Cisco CallManager Release 3.0(5) doc

... a Cisco AVVID network. Chapter 11 Network Management Introduces features of CiscoWorks2000 and Remote Serviceability for Cisco CallManager that provide network management capabilities for Cisco ... inline power method requires Catalyst software Release 5.5 for Catalyst 6000, Cisco CatOS 6.1 or higher for Catalyst 4000, and Cisco IOS Release 12.0(5)XU or later for Catalyst 3524-PWR. These ... WAN PSTN Catalyst backbone Catalyst wiring closet Cisco CallManager cluster Msg store Msg store LDAP Directory Cisco uOne GateServer IP IP IP IP 40764 Contents iv Cisco IP Telephony Network...

Ngày tải lên: 21/12/2013, 04:19

262 470 0
CCNA - V3 P1 - Configuring Catalyst Switch Operations

CCNA - V3 P1 - Configuring Catalyst Switch Operations

... B. • The switch has the address for station B in the MAC address table. © 2002, Cisco Systems, Inc. All rights reserved. 2 Configuring Catalyst Switch Operations Module 3 © 2002, Cisco Systems, ... flooded). © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-14 Summary • Ethernet switches and bridges increase the available bandwidth of a network by creating dedicated network segments ... Layer 2 switching and bridging operations and modes • Describe how LAN switches use and populate the MAC address table © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-4© 2002, Cisco...

Ngày tải lên: 08/07/2013, 01:27

15 281 1
CCNA P3 V3 Configuring a Catalyst Switch

CCNA P3 V3 Configuring a Catalyst Switch

... redundant switched or bridged topologies © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-8 Spanning-Tree Port States (Cont.) © 2002, Cisco Systems, Inc. All rights reserved. © 2002, Cisco ... the blocking state. • When the network topology changes, switches and bridges must recompute the Spanning-Tree Protocol, which disrupts user traffic. © 2002, Cisco Systems, Inc. All rights ... 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-13 Rapid Spanning-Tree Protocol © 2002, Cisco Systems, Inc. All rights reserved. ICND v2.0—3-11 Spanning-Tree Recalculation © 2002, Cisco...

Ngày tải lên: 08/07/2013, 01:27

16 324 0
VLANs and TRUNKING (Catalyst 1900 Switches)

VLANs and TRUNKING (Catalyst 1900 Switches)

... - CATALYST 2950 SWITCH CONFIGURATION 1. In this lab, you will configure basic IOS commands on switch3 and switch4 which are Catalyst 2950 switches. 2. From the NetSim tool bar, select Switch3 ... Rights Reserved. LAB 13 – VLANs and TRUNKING (Catalyst 2950 Switches) 1. In this lab, you will set up VLANs on switch3 and switch4 (Catalyst 2950 switches) and test them by pinging between router3 ... Reserved. LAB 11 – VLANS and TRUNKING (Catalyst 1900 Switches) 5a. Question: what VTP operating mode are the switches in? • Answer: the Catalyst 1900 switch defaults to ‘server’ mode. 6a....

Ngày tải lên: 29/09/2013, 22:20

29 428 1
Study Guide Switching 3.0 (Building Cisco Multilayer Switched Networks)

Study Guide Switching 3.0 (Building Cisco Multilayer Switched Networks)

... (Model) 640-604 Switching 3.0 www.testking.com - 19 - Switching 3.0 (Building Cisco Multilayer Switched Networks) Exam Code: 640-604 Certifications: Cisco Certified Network Professional ... sublayer) Metropolitan-Area Network Message Digest Algorithm 5 Multilayer Switching Multilayer Switching Route Processor Multilayer Switching Switch Engine Multilayer Switching Protocol Multicast ... information, the switch will not be able to produce wire-speed results. 1.4.1.5 Multi-Layer Switching (MLS) Multi-layer switching combines layer 2 switching, layer 3 switching, and layer 4 switching...

Ngày tải lên: 16/10/2013, 13:15

121 408 2

Bạn có muốn tìm thêm với từ khóa:

w