ccna security lab manual 1 2 download

... 1 - 2 CCNA 1: Networking Basics v 3.0 - Lab 7 .1. 2 Copyright  20 03, Cisco Systems, Inc. Lab 7 .1. 2 Waveform Decoding Objective The purpose of this lab is to integrate ... automatically. Therefore, this lab provides an important foundation for future learning of network troubleshooting. A Digital Oscilloscope was attached to an Ethernet 10 BASE2 coaxial cable to capture ... possible to capture waveforms on 10 BASE-T and 10 0BASE-TX twisted pair media, the coaxial cable gives the cleanest and most readable waveform data. This data is available from the instructor. Decoding...

Ngày tải lên: 19/10/2013, 02:15

Ngày tải lên: 18/01/2014, 04:20

Ngày tải lên: 18/01/2014, 04:20

Ngày tải lên: 18/01/2014, 04:20

Ngày tải lên: 18/01/2014, 05:20

Ngày tải lên: 18/01/2014, 05:20

Ngày tải lên: 18/09/2012, 10:12

Ngày tải lên: 01/08/2014, 17:22

... FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 25 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 26 00 FastEthernet 0/0 (FA0/0) FastEthernet 0 /1 (FA0 /1) Serial 0/0 (S0/0) Serial 0 /1 (S0 /1) ... Interface #1 Ethernet Interface #2 Serial Interface #1 Serial Interface #2 800 (806) Ethernet 0 (E0) Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 ... the pool, use the following commands: campus(dhcp-config)#ip dhcp excluded-address 17 2 .16 . 12 .1 1 72 .16 . 12 .10 Step 7 Verifying DHCP Operation a. At each workstation on the directly connected...

Ngày tải lên: 11/12/2013, 13:15

... address 17 2 .16 .1. 2 255 .25 5 .25 5.0 BHM(config-if)#exit BHM(config)#interface fastethernet 0 BHM(config-if)#ip address 17 2 .16 .3 .1 25 5 .25 5 .25 5.0 BHM(config-if)#exit BHM(config)#exit 2 - 7 CCNA ... - Lab 1. 2. 5 Copyright  20 03, Cisco Systems, Inc. b. On the GAD router: GAD(config)#interface serial 0 GAD(config-if)#ip address 17 2 .16 .1. 1 25 5 .25 5 .25 5.0 GAD(config-if)#exit Step 15 ... the assigned lab to be performed. 1 - 7 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1. 2. 5 Copyright  20 03, Cisco Systems, Inc. Lab 1. 2. 5 Verifying RIP v2 Configuration...

Ngày tải lên: 11/12/2013, 13:15

... 3 Locate the RJ-45 to DB-9 adapter 1 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 1. 2. 5 Copyright  20 03, Cisco Systems, Inc. Lab 1. 2. 5 Connecting Console Interfaces Objective ... 2 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 1. 2. 5 Copyright  20 03, Cisco Systems, Inc. Step 1 Identify connectors and components a. Examine ... locate the RJ-45 connector labeled Console. Step 2 Identify the computer serial interface (COM 1 or 2) a. Examine the computer and locate a 9-pin or 25 -pin male connector labeled serial. It may...

Ngày tải lên: 11/12/2013, 13:15

... example of an IP address in 32- bit binary form and dotted decimal form. Binary IP Address: 11 000000 .10 1 010 00.0 010 110 1. 011 110 01 Decimal IP Address: 19 2 .16 8.45 . 12 1 A tool that makes the conversion ... with one and doubles, Base 2, for each position to the left. 8 7 6 5 4 3 2 1 12 8 64 32 16 8 4 2 1 Position Value 12 8 20 7 12 8 64 79 64 8 15 8 4 7 4 2 3 2 1 The same conversion ... cannot be divided by either 32 or 16 , put 0s in row three of our table under the 32 and 16 values. 1 - 2 CCNA 1: Networking Basics v 3.0 - Lab 1. 2. 5 Copyright  20 03, Cisco Systems, Inc. ...

Ngày tải lên: 11/12/2013, 13:15

... BHM(config-if)#ip address 17 2 .16 .3 .1 25 5 .25 5 .25 5.0 BHM(config-if)#exit BHM(config)#exit b. On the GAD router: GAD(config)#interface serial 0 GAD(config-if)#ip address 17 2 .16 .1. 1 25 5 .25 5 .25 5.0 GAD(config-if)#exit ... Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet 0 (FA0) FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 25 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial ... 7 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1. 2. 5 Copyright  20 03, Cisco Systems, Inc. BHM(config)#interface serial 0 BHM(config-if)#ip address 17 2 .16 .1. 2 255 .25 5 .25 5.0...

Ngày tải lên: 11/12/2013, 13:15

... DB25, depending on the computer. 2 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab 1. 2. 5 Copyright  20 03, Cisco Systems, Inc. Step 2 Identify the computer serial interface (COM 1 ... 3 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab 1. 2. 5 Copyright  20 03, Cisco Systems, Inc. Step 5 Connect cabling components ... Inc. Step 2 Identify the computer serial interface (COM 1 or 2) a. Examine the computer and locate a 9 or 25 pin male connector labeled serial. It may or may not be identified. Step 3 Locate...

Ngày tải lên: 11/12/2013, 13:15

... example of an IP address in 32- bit binary form and dotted decimal form. Binary IP Address: 11 000000 .10 1 010 00.0 010 110 1. 011 110 01 Decimal IP Address: 19 2 .16 8.45 . 12 1 A tool that makes the conversion ... remainder cannot be divided by either 32 or 16 , put 0s in row three of our table under the 32 and 16 values. 12 8 20 7 12 8 64 79 64 8 15 8 4 7 4 2 3 2 1 Position Value ... 1 - 2 CCNA 1: Networking Basics v 3.0 - Lab 1. 2. 5 Copyright  20 03, Cisco Systems, Inc. Lab 1. 2. 5 Decimal to Binary Conversion Objective...

Ngày tải lên: 11/12/2013, 13:15

... Quan, Q3, TP. HCM Tel: 3.9 322 .735 – 0 913 .735.906 Fax: 3.9 322 .734 www.nhatnghe.com Trang 1/ 9 LAB 1. 2. WINDOWS 7 USER ACCOUNT CONTROL I. GIỚI THIỆU Bài lab triển khai trên một máy ... VIỆT NAM 10 5 Bà Huyện Thanh Quan, Q3, TP. HCM Tel: 3.9 322 .735 – 0 913 .735.906 Fax: 3.9 322 .734 www.nhatnghe.com Trang 9/9 - Nhấp kộp Local Security Policy ặ Chn Local Policies ặ Security ... MICROSOFT TẠI VIỆT NAM 10 5 Bà Huyện Thanh Quan, Q3, TP. HCM Tel: 3.9 322 .735 – 0 913 .735.906 Fax: 3.9 322 .734 www.nhatnghe.com Trang 5/9 B. Phản ứng của UAC Notifications level 1 - Tạo 03 User:...

Ngày tải lên: 17/12/2013, 11:15

... address 17 2 .16 .0 .1 25 5 .25 5.0.0 GAD(config-if)#no shutdown GAD(config-if)#exit Step 11 Configure the IP host statements on router GAD GAD(config)#ip host BMH 17 2 .18 .0 .1 1 72 .17 .0 .1 Step 12 ... address 17 2 .18 .0 .1 25 5 .25 5.0.0 BHM(config-if)#no shutdown BHM(config-if)#exit Step 17 Configure the IP host statements on router BHM BHM(config)#ip host GAD 17 2 .16 .0 .1 1 72 .17 .0 .1 Step 18 ... FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 25 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 26 00 FastEthernet 0/0 (FA0/0) FastEthernet 0 /1 (FA0 /1) Serial 0/0 (S0/0) Serial 0/1...

Ngày tải lên: 21/12/2013, 19:15

... FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 25 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 26 00 FastEthernet 0/0 (FA0/0) FastEthernet 0 /1 (FA0 /1) Serial 0/0 (S0/0) Serial 0 /1 ... assigned lab to be performed. 1 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1. 2. 4 Copyright  20 03, Cisco Systems, Inc. Lab 1. 2. 4 Converting RIP v1 to RIP v2 Objective ... Ethernet Interface #2 Serial Interface #1 Serial Interface #2 800 (806) Ethernet 0 (E0) Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet...

Ngày tải lên: 21/12/2013, 19:15

... Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet 0 (FA0) FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 25 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 26 00 FastEthernet 0/0 ... Interface #1 Ethernet Interface #2 Serial Interface #1 Serial Interface #2 Interface #5 800 (806) Ethernet 0 (E0) Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 ... BHM(config-router)#version 2 BHM(config-router)#exit BHM(config)#exit 2 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1. 2. 4 Copyright  20 03, Cisco Systems, Inc. Lab 1. 2. 4 Converting...

Ngày tải lên: 21/12/2013, 19:15

... FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 25 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 26 00 FastEthernet 0/0 (FA0/0) FastEthernet 0 /1 (FA0 /1) Serial 0/0 (S0/0) Serial 0 /1 ... Ethernet Interface #2 Serial Interface #1 Serial Interface #2 800 (806) Ethernet 0 (E0) Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet ... Step 11 Enable RIP Version 2 Routing Enable version 2 of the RIP routing protocol on the Gadsden router only. 1 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1. 2. 6 Copyright...

Ngày tải lên: 21/12/2013, 19:15