... IGRP (EIGRP). The IPv4 protocol – Media independent• Describe the implications for the use of the IP as it is media independent• One major characteristic of the media that the Network layer ... Transmission Unit (MTU). Part of the control communication between the Data Link layer and the Network layer is the establishment of a maximum size for the packet. Network Layer FieldsHọc ... devices that connect the networks are called routers. The role of the router is to select paths for and direct packets toward their destination. This process is known as routing. 4. DecapsulationHọc...
... Explorationversion4. 0CCNA Explorationversion4. 0 Flow ControlWhen datagrams arrive too quickly for a host or gateway to process and the transport function can issue a “not ready” indicator to the ... directed to the web browser, and text from an instant message does not appear in an e-mail.SummaryHọc viện mạng Bách khoa - Website: www.bkacad.com 45 Chapter 4 - OSI Transport Layer CCNA Exploration ... www.bkacad.com 40 sender to stop sending data. When the receiver can handle additional data, the receiver sends a “ready”transport indicator. When this indicator is received, the sender can resume the...
... the context menu. CHAPTER 1 ■ INTRODUCING THE ADO.NET 4.0 ENTITY FRAMEWORK 11 The first version of the Entity Framework gave the Entity Name and the Entity Set Name the same name. There ... yourself. CHAPTER 2 ■ THE ENTITY DATA MODEL 22 Taking a Model-First Approach A new and welcomed feature to the EF 4.0 is the ability to create a conceptual model first and then derive the storage ... relationships CHAPTER 2 ■ THE ENTITY DATA MODEL 34 CHAPTER 2 ■ THE ENTITY DATA MODEL 26 We’re almost done. The next thing we need to do is add relationships, or associations. From the...
... King(config)#nameif ethernet4 tess security18 King(config)#interface ethernet4 100 full King(config)#ip address tess 1 72. 19 .4. 1 25 5 .25 5 .25 5 .0 QUESTION NO: 100 Type the command that reboots the PIX ... outgoing_src B. pix(config)#outbound 1 deny 0.0 .0. 00.0 .0. 0 java pix(config)#apply (inside) 1 outgoing_src C. pix(config)#outbound 1 deny 0.0 .0. 0 25 5 .25 5 .25 5 .25 5 java pix(config)#apply (inside) 1 ... B. They can be installed in either the 64- bit/66 MHz bus or the 32- bit/33 MHz bus; however, installing them in the 64- bit/66 MHz bus achieves the best possible system performance. C. They...
... outgoing_src B. pix(config)#outbound 1 deny 0.0 .0. 00.0 .0. 0 java pix(config)#apply (inside) 1 outgoing_src C. pix(config)#outbound 1 deny 0.0 .0. 0 25 5 .25 5 .25 5 .25 5 java pix(config)#apply (inside) 1 ... King(config)#nameif ethernet4 tess security18 King(config)#interface ethernet4 100 full King(config)#ip address tess 1 72. 19 .4. 1 25 5 .25 5 .25 5 .0 QUESTION NO: 100 Type the command that reboots the PIX ... must be installed in the 64- bit /22 MHz bus, and the PIX-4FE card must be installed in the 32- bit/33 MHz bus. B. They can be installed in either the 64- bit/66 MHz bus or the 32- bit/33 MHz bus;...
... 2 Mb/s) version of EIA/TIA -23 2. It uses a 36-pin D-connector and is capable of longer cable runs. There are several versions. This standard is also known as RS 422 and RS - 42 3. –EIA/TIA-6 12/ 613 ... speeds of up to 64 kb/s on a 25 -pin D-connector over short distances. It was formerly known as RS -23 2.The ITU-T V. 24 specification is effectively the same. –EIA/TIA -44 9/5 30 - This protocol ... ITE 1 Chapter 6 12 Cisco Thai Nguyen Networking Academy WAN Physical Layer Standards TheWAN physical layer also describes the interface between the DTE and the DCE. –EIA/TIA -23 2 - This...