bridging smt and tm

Ngày tải lên: 23/03/2014, 16:20

... distribution of the diploid and aneuploid cell fractions after treatment with TMZ alone and with TMZ-BioShuttle shows different pat- terns. The amount of the diploid cell fraction and of the aneuploid ... coupled with TMZ. The NLS-sequence allows an active delivery of the TMZ into the cell nucleus after trans- membrane passage of the TMZ-BioShuttle and intra-cytoplasm enzymatic cleavage and separation ... study were: 1. to achieve a rapid and high local concentration and an accumulation of TMZ derivative within the cell nuclei using the TMZ-BioShuttle as delivery and targeting system. Int. J....

Ngày tải lên: 26/10/2012, 09:48

Ngày tải lên: 14/02/2014, 16:20

Ngày tải lên: 06/03/2014, 18:21

Ngày tải lên: 29/03/2014, 15:20

... assembly, and linear assembly code 3.1 INTRODUCTION Texas Instruments introduced the first-generation TMS32010 digital signal proces- sor in 1982, the TMS320C25 in 1986 [1], and the TMS320C50 ... Processing with the TMS320C25, Wiley, New York, 1990. 2. R. Chassaing, Digital Signal Processing Laboratory Experiments Using C and the TMS320C31 DSK, Wiley, New York, 1999. 100 Architecture and Instruction ... paths A and B, as shown in Figure 3.1. Each path has a unit for multiply operations (.M), for logical and arithmetic operations (.L), for branch, bit manipulation, and arithmetic operations (.S), and...

Ngày tải lên: 17/10/2013, 19:15

... and the edges of both passbands and stopbands are fixed, and the coefficients are varied to provide this equiripple approximation. This minimizes the ripple in both the passbands and the stopbands. ... 4.14. FIR program with pseudorandom noise sequence as input (FIRPRN.c). 126 3. Bandpass: C 0 = ␯ 2 - ␯ 1 (4.39) 4. Bandstop: C 0 = 1 - (␯ 2 - ␯ 1 ) (4.40) where ␯ 1 and ␯ 2 are the normalized cutoff ... shift in the frequency spectrum with upper and lower sidebands. On the lower sideband that represents the audible speech range, the low tones are high tones, and vice versa. Figure 4.26 is a block...

Ngày tải lên: 24/10/2013, 09:15

... equation (5.24), or (5.30) In the case of bandpass and bandstop filters with lower and upper cutoff frequen- cies w D1 and w D2 , the two analog frequencies w A1 and w A2 need to be solved. The exercises ... Circuit and Systems, Apr. 1977, pp. 191–194. 5. R. Chassaing and D. W. Horning, Digital Signal Processing with the TMS320C25, Wiley, New York, 1990. 6. A. H. Gray and J. D. Markel, Digital lattice and ... Butterworth-type filters, which have monotonic responses in both passbands and stopbands. An elliptic design has equiripple in both bands and achieves a lower order than a Hs Hz sj ze A j D T () = () = = w w ...

Ngày tải lên: 28/10/2013, 16:15

... View Æ Watch Window and insert the two expressions j and out (right click on the Watch window). Click on +out to expand and view out[0] and out[1] that represent the real and imaginary components, ... Experiments Using C and the TMS320C31 DSK, Wiley, New York, 1999. 14. R. Chassaing, Digital Signal Processing with C and the TMS320C30, Wiley, New York, 1992. 15. P. M. Embree and B. Kimble, C Language ... values of N. For example, for N = 64, represented by six bits, the first and sixth bits, the second and fifth bits, and the third and fourth bits are swapped. Several examples in this chapter illustrate...

Ngày tải lên: 07/11/2013, 10:15

... C and the TMS320C31 DSK, Wiley, New York, 1999. 12. R. Chassaing et al., Student projects on applications in digital signal processing with C and the TMS320C30, Proceedings of the 2nd Annual TMS320 ... fixed unknown FIR bandpass filter. A pseudorandom noise sequence is generated within the program (see Exam- ples 2.16 and 4.4) and becomes the input to both the fixed (unknown) and the adaptive ... of a wideband signal. The desired wideband signal with an additive narrowband inter- ference is delayed and becomes the input to a 60-coefficient adaptive FIR filter. The desired wideband signal...

Ngày tải lên: 07/11/2013, 10:15

... MPYSP, and ADD becomes ADDSP. Both MPYSP and ADDSP have three delays slots. As a result, the loop kernel starts in cycle 10 (not cycle 8). The SUB and B instructions start in cycles 4 and 5, ... about alignment of pointers and arrays and of valid opti- mization schemes, such as word-wide optimization. 6. uint_lo(double) and uint_hi(double) obtain the low and high 32 bits of a double ... ;64-bit data in A2 and A3 || LDDW .D2 *B4++,B3:B2 ;64-bit data in B2 and B3 ;cycle 2 || LDDW .D1 *A4++,A3:A2 ;64-bit data in A2 and A3 || LDDW .D2 *B4++,B3:B2 ;64-bit data in B2 and B3 ;cycle 3 ||...

Ngày tải lên: 14/12/2013, 14:15

... low- frequency band, 0 to 4kHz, and a high-frequency band, 4 to 8kHz. The low- and high-frequency signals are encoded separately by dynamically quantizing an adap- tive predictor’s output error.The low and ... signal sampled at 16kHz and separates it into a low band and a high band. The filter coefficients represent a 4-kHz lowpass filter. The sampled signal is separated into odd and even samples, with ... decimation, interpolation and narrow-band filtering, IEEE Transactions on Acoustics, Speech, and Signal Processing, Vol. ASSP-23, 1975, pp. 444–456. 41. R. E. Crochiere and L. R. Rabiner, Further...

Ngày tải lên: 14/12/2013, 14:15

... other types of bridging, including source route bridging, source route transparent bridging, and source route Half-Duplex Full-Duplex Send and/ or receive Send or receive Send and receive Connection ... Default screen 7 Bridging and Switching CERTIFICATION OBJECTIVES 7.01 Bridges and Switches 7.02 Functions of Bridging and Switching 7.03 The Spanning Tree Protocol 7.04 1900 and 2950 Configuration ✓ Two-Minute ... screen translational bridging, that appear in mixed media networks, such as Ethernet, Token Ring, and FDDI. However, since the CCNA exam focuses on transparent bridging, and Token Ring and FDDI are,...

Ngày tải lên: 21/12/2013, 19:15

... address and the remote router’s address. 5 ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○ Advanced Network Theory: Bridging and LAN Switching ➤ Integrated routing and bridging (IRB) ➤ Encapsulated bridging ➤ ... Bridging and LAN Switching The biggest benefits of ATM are speed and multifunction capabilities. ATM is extremely fast and switches cells in hardware. It also supports data, voice, and video. ... to understand the two main switching methods—cut-through and store and forward. Large Switched Networks In some instances, you might have a large switch backbone and you need to create and delete...

Ngày tải lên: 21/12/2013, 19:15

... system and device driver developers, who work with low-level assembly language and operating system calls. Instead, programmers use standard Internet services, and let the operating system and ... and software standards such as Sun's Jini already exist to help devices and hardware talk to each other over networks and to allow instant plug -and- play functionality. Devices and services ... products like Borland JBuilder, and has a fully featured API offering code editing, visual design, compiling, and debugging. It also has extra modules that can be incorporated, and a handy auto- update...

Ngày tải lên: 19/01/2014, 19:20

... reserved. Apache::Registry PerlHandler Versus Custom PerlHandler | 455 We will add these settings to httpd.conf: PerlModule Benchmark::Handler <Location /benchmark_handler> SetHandler perl-script PerlHandler ... Benchmark::Handler </Location> The first directive preloads and compiles the Benchmark::Handler module. The remaining lines tell Apache to execute the subroutine Benchmark::Handler::handler when ... reserved. 492 | Chapter 13: TMTOWTDI: Convenience and Habit Versus Performance At the end we print the calendar and finish the HTML: print $calendar; print qq{</body></html>}; The entire...

Ngày tải lên: 26/01/2014, 07:20

... Processing with C and the TMS320C30, Wiley, New York, 1992. 3. R. Chassaing and D. W. Horning, Digital Signal Processing with the TMS320C25, Wiley, New York, 1990. 4. N. Kehtarnavaz and M. Keramat, ... (megabytes) of synchronous dynamic RAM (SDRAM) and 128kB (kilobytes) of flash ROM. Two connectors on the board provide input and output and are labeled IN (J7) and OUT (J6), respectively.Three of the ... voltage regulators that provide 1.8 V for the C6711 core and 3.3V for its memory and peripherals. 1.2.2 TMS320C6711 Digital Signal Processor The TMS320C6711 (C6711) is based on the very-long-instruction-word...

Ngày tải lên: 26/01/2014, 07:20

... the sideband signal and a 2-kHz carrier signal from a lookup table. Build this project as AM_extin. Test this project using a sinusoidal sideband signal with an amplitude below 0.35 V and a frequency ... an amplitude of approximately 1 – 2 V p-p and a frequency of 1kHz. Run and verify your output results. Use CCS to plot the input data, in both the time and frequency domains (see also Example 1.2). ... speed), and the incremental frequency with step_freq. Example 2.16: Pseudorandom Noise Sequence Generation (noise_gen) The program noise_gen.c, shown in Figure 2.27, generates a pseudorandom noise sequence....

Ngày tải lên: 26/01/2014, 07:20

... chemical product is nontoxic and easy in handle [3,4]. Compared to etching in KOH solution, SiO 2 and Si 3 N 4 are better mask materials for etching processes in TMAH. Especially, the studies ... condition of TMAH 20 wt.%, temperature 80 0 C, and 150-rpm agitation as shown by SEM picture in Fig. 10. The etched surface (100) was very smooth with Ra = 12 nm, Rt = 63 nm. 4. TMAH application ... that, it is quite possible to control etch rate and lower etched surface roughness by controlling temperature and agitation suitably. In the TMAH solution of 20 % in weight, the optimized silicon...

Ngày tải lên: 13/02/2014, 04:20

Ngày tải lên: 15/02/2014, 01:20