0

bộ thu phát không dây tplink tlwr841n

Tài liệu Adaptive thu phát không dây P8 pptx

Tài liệu Adaptive thu phát không dây P8 pptx

Hóa học - Dầu khí

... positive, if the associated synapse is excitatory and it is negative, if the synapse is inhibitory. Thus, signal xi at the input of synapse i, connected to neuron j, is multiplied by the synaptic ... Section 8.6 and on the so-called self-organizing map [263] constitutes a model-free classifier, thus requiring a long training period and large networks. The schematic of the RBF equalizer ... (8.68) where ci, i = 1,2, . . . , M, is the set of RBF centres to be determined. Thus, with the aid of Equation 8.67 and Equation 8.68 we have M F*(x) = CW~G(X; ci) Gill)....
  • 85
  • 311
  • 0
Tài liệu Adaptive thu phát không dây P9 pptx

Tài liệu Adaptive thu phát không dây P9 pptx

Hóa học - Dầu khí

... mode is employed, in order to provide an acceptable BER, when the chan- nel exhibits a deep fade. Thus, adaptive modulation is not only used to combat the fading effects of a narrow-band channel, ... we observe that the transmission blocking mode was dominant in the SNR range of OdB to 4dB and thus the mean BER performance was not recorded in that range of SNRs in Figure 9.9(b). Comparing ... scheme with and without transmission blocking, if the channel SNR is in excess of about 22dB. Thus, the advantage of using an adaptive scheme with transmission blocking 9.4. JOINT ADAPTIVE...
  • 31
  • 321
  • 0
Tài liệu Adaptive thu phát không dây P10 docx

Tài liệu Adaptive thu phát không dây P10 docx

Hóa học - Dầu khí

... all modulation modes was obtained according to Equation 9.15 and Equation 10.15, respectively. Thus, we have the estimated short-term BER of the received data burst before and after decoding ... However, for NO TX bursts, where only dummy data are transmitted, turbo decoding is not necessary. Thus, for NO TX bursts we use the short-term BER before decoding as the switching metric. scheme ... addition, a subtraction, a table look-up and a max operation according to Equa- tion 10.1, thus reducing the computational complexity. The term 1n(Eizl exp(wi + Vil,)) requires 3M -...
  • 36
  • 301
  • 0
Tài liệu Adaptive thu phát không dây P11 doc

Tài liệu Adaptive thu phát không dây P11 doc

Hóa học - Dầu khí

... RBF TURBO EQUALISER PERFORMANCE 463 increases. Observe in Figure 1 1.4 that as a rule of thumb, the feedforward order of the Jaco- bian RBF DFE must not exceed the CIR length (L + 1)...
  • 41
  • 247
  • 0
Tài liệu Adaptive thu phát không dây P12 pdf

Tài liệu Adaptive thu phát không dây P12 pdf

Hóa học - Dầu khí

... 4. The throughput performance values were normalized to the minimum throughput of 68 kbits/s, thus giving minimum and max- imum normalized throughput values of 1 and 4, respectively. We...
  • 38
  • 322
  • 0
Tài liệu Adaptive thu phát không dây P13 ppt

Tài liệu Adaptive thu phát không dây P13 ppt

Hóa học - Dầu khí

... By using a shorter DFT for this reference symbol pair, the subcarrier distance is increased and thus the frequency error es- timation range is extended. Clal3en [442,443] proposed to use binary ... reference, encoding information in the phase difference between consecutive modulated symbols. DPSK is thus only affected by the differential channel phase distortion between two consecutive symbols ... can be usefully employed, however, to make an OFDM system more robust to time misalignments and thus to simplify the task of the time-domain FFT window synchronization system. 13.5 Synchronization...
  • 53
  • 294
  • 0
Thiết kế mạch đo nhiệt độ sử dụng board arduino, hiển thị trên 4 led 7 thanh và truyền phát không dây sử dụng module nRF24L01

Thiết kế mạch đo nhiệt độ sử dụng board arduino, hiển thị trên 4 led 7 thanh và truyền phát không dây sử dụng module nRF24L01

Điện - Điện tử - Viễn thông

... truyền phát không dây Trang 22 Chương 2 THIẾT KẾ, LẬP TRÌNH VÀ LẮP ĐẶT MẠCH ĐO NHIỆT ĐỘ VÀ TRUYỀN PHÁT KHÔNG DÂY. 2.1. Thiết kế mạch trên Proteus 2.1.1. Thiết kế mạch đo nhiệt độ không ... THIẾT KẾ, LẬP TRÌNH VÀ LẮP ĐẶT MẠCH ĐO NHIỆT ĐỘ VÀ TRUYỀN PHÁT KHÔNG DÂY Hình 2.1. Sơ đồ nguyên lý mạch đo nhiệt độ không truyền phát thiết kế trên Proteus. 23 Hình 2.2. Mô phỏng hiển thị ... sẽ không được lắp đặt cảm biến LM35, các linh kiện còn lại mạch phátthu được kết nối giống nhau. 2.2. Lập trình cho mạch đo nhiệt độ 2.2.1. Lập trình cho mạch đo nhiệt độ không truyền phát...
  • 62
  • 4,395
  • 21
Hệ thống FSO với bộ thu phát cấu trúc cầu

Hệ thống FSO với bộ thu phát cấu trúc cầu

Điện - Điện tử - Viễn thông

... giữa hai bộ thu, phát (cm)θ Góc chiếu của một bộ thu, phát (Rad)φ Góc giữa hai bộ thu, phát liền kề (Rad)L Vùng phủ của một bộ thu, phát (cm2)C Vùng phủ hiệu dụng của một bộ thu, phát (cm2)I ... cặp thu, phát bên cạnh donhiễu, trừ phi ta sử dụng WDM cho các bộ thu, phát tinh chỉnh. Có thể vẫn thu đượcliên kết LOS giữa các cặp thu, phát trong vùng nhiễu I, tuy nhiên các bộ thu, phát ... phụ thu c vào rất nhiều tham số khác nhaucủa bộ thu, phát và cấu trúc nút FSO, vì thế không có một con số bộ thu, phát tối ưuxác định nào. Tùy thu c vào từng điều kiện của hệ thống mà số bộ thu, ...
  • 61
  • 772
  • 8

Xem thêm