analysis design and simulation

... (Editor) VOLUME 17 Molecular and Nano Electronics: Analysis, Design and Simulation J.M Seminario (Editor) VOLUME 18 Nanomaterials: Design and Simulation P.B Balbuena and J.M Seminario (Editors) ... C H E M I ST RY Molecular and Nano Electronics :Analysis, Design and Simulation Edited by J M Seminario Department of Chemical Engineering and Department of Electrical and Computer Engineering ... Molecular and Nano Electronics: Analysis, Design and Simulation J M Seminario (Editor) © 2007 Elsevier B.V All rights reserved Chapter Metal–molecule–semiconductor junctions: An ab initio analysis...

Ngày tải lên: 04/06/2014, 14:36

... .3 Sensing Element Design 2.1 Overview 2.2 Mechanical Design and Analysis 2.2.1 Spring Design 2.2.2 Damping and Quality Factor ... sensor Actuation fingers are separated and shielded from sensing fingers to simplify clock design and minimize possible feedthrough 2.2 Mechanical Design and Analysis The schematic shown in Figure ... noise, and can be neglected 29 SYSTEM SIMULATIONS 4.1 Introduction System-level simulation combining mechanical and electrical elements is extremely important for MEMS design More specifically, design...

Ngày tải lên: 27/10/2013, 23:15

... .3 Sensing Element Design 2.1 Overview 2.2 Mechanical Design and Analysis 2.2.1 Spring Design 2.2.2 Damping and Quality Factor ... sensor Actuation fingers are separated and shielded from sensing fingers to simplify clock design and minimize possible feedthrough 2.2 Mechanical Design and Analysis The schematic shown in Figure ... noise, and can be neglected 29 SYSTEM SIMULATIONS 4.1 Introduction System-level simulation combining mechanical and electrical elements is extremely important for MEMS design More specifically, design...

Ngày tải lên: 22/12/2013, 08:16

Ngày tải lên: 26/01/2014, 07:20

... wait for a time tswitch Gsec off, Ysec off and Rsec on, and Gsec off, Ysec off and Rsec on, and Gsec on, Ysec off and Rsec off, and Gsec off, Ysec on and Rsec off, and End loop When an interrupt occurs, ... effects of such design on the electronic design, and on the control system design In this approach, the interaction between the three systems (mechanical, electronic, and control) and their effects ... (mechanical, electronics, and control) is what mechatronics offers for a better design Design of the mechanical system Design of the electronic system Design of the control and instrumentation system...

Ngày tải lên: 08/03/2014, 19:20

... new design paradigm designated today by Process Integration Its application relies on the intensive use of Process Simulation Combining design and simulation allows the designer to understand ... Engineering (B Braunschweig and R Gani, Editors) Computer Aided Molecular Design: Theory and Practice (L.E.K Achenie, R Gani and V Venkatasubramanian, Editors) Integrated Design and Simulation of Chemical ... criteria and the environment of constraints Computer simulation is the main tool for analysis and synthesis However, the quality and efficiency of the final design depends on the capacity of the designer...

Ngày tải lên: 02/04/2014, 15:49

... behavior and associated issues of tail fin design and aerodynamic over-speed protection are covered in Chap The text describes and lists a number of Matlab programs for wind turbine analysis and design ... connection • Detailed dynamics analysis for more accurate stress calculations and fatigue analysis • Foundation design, and • Control engineering help in devising and implementing a control strategy ... Energy and Technology For further volumes: http://www.springer.com/series/8059 David Wood Small Wind Turbines Analysis, Design, and Application 123 Dr David Wood Department of Mechanical and Manufacturing...

Ngày tải lên: 31/05/2014, 02:01

... (Editor) VOLUME 17 Molecular and Nano Electronics: Analysis, Design and Simulation J.M Seminario (Editor) VOLUME 18 Nanomaterials: Design and Simulation P.B Balbuena and J.M Seminario (Editors) ... Carolina Herrera, and Jorge M Seminario Structural Properties of Pure and Binary Nanoclusters Investigated by Computer Simulations 35 Giulia Rossi and Riccardo Ferrando Computer Simulation of the ... C H E M I ST RY Nanomaterials: Design and Simulation Edited by Perla B Balbuena Jorge M Seminario Department of Chemical Engineering and Department of Electrical and Computer Engineering Texas...

Ngày tải lên: 04/06/2014, 14:38

... configuration The simulation and measurement results are presented in Figure 7, 8, and 10 The average deviations between IDEA1 simulations and testbed measurements are 5.2, 3.2, 6.5 and 3.4%, respectively ... 49.3 and 45.8%, respectively The ones between IDEA1_NOHW and NS-2 are 1.0, 2.6, 8.3 and 7.2% Therefore, the average deviation between IDEA1_HW and NS-2 is 26.7%, and the one between IDEA1_NOHW and ... topology and the analysis of simulation results - The simulation results of IDEA1 have been validated by a testbed consisting of nodes - The performances of IDEA1 have also been compared with NS-2 Design...

Ngày tải lên: 20/06/2014, 22:20

... receiver, the parallel active filter consists of a DC-link static power converter and an energy storage element Design and Simulation of a Shunt Active Filter 55 The control circuit performs synthesis ...   ~ p   ~ ur  q  q  u r  ur   and the equivalent three-phase components will be, respectively: 1  p 0     (12) Design and Simulation of a Shunt Active Filter * iFa  * ... Simulink model Fig and show the current waveforms and their harmonic spectrum in case of a non-linear load taken for study, whereas Fig and present the compensated current waveforms and harmonic spectrum...

Ngày tải lên: 06/07/2014, 09:20

... be 23 Gb/s without coding, and 75 Gb/s with a (255,239) Reed Solomon code The effect of non-rectangular spectra on receiver sensitivity is investigated for both OOK and FSK transmission, assuming ... and FSK transmission, assuming the system (de)multiplexer filters to be N’th order Butterworth bandpass Although narrower filters are recommended for improving power budget, it is shown that system ... environment Performance-optimized spectrum-sliced WDM systems have potential use in both local loop and long-distance fiber communication systems which require low-cost WDM equipment for high data...

Ngày tải lên: 06/08/2014, 00:20

... Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com xii Preface that many use but few understand and address the HOWS and WHYS of system analysis, design, and development ... arrive at the steps and practices necessary to plan and implement system analysis, design, and development strategy without sacrificing best practices objectives Part II System Design and Development ... Engineering Standards, Frames of Reference, and Conventions 544 29 Understanding Specification Requirements 315 46 System Design and Development Documentation 562 30 Specification Analysis 327 31...

Ngày tải lên: 13/08/2014, 08:21

... Standard Glossary of Modeling and Simulation Terminology Institute of Electrical and Electronic Engineers (IEEE) New York, NY MIL-HDBK-470A 1997 Designing and Developing Maintainable Products and ... findings and observations REFERENCES Kossiakoff, Alexander, and Sweet, William N 2003 Systems Engineering Principles and Practice New York: Wiley-InterScience DoD 5000.59-M 1998 DoD Modeling and Simulation ... (Source: Mil-HDBK-881, Appendix H, para 3.7.1) Support and Handling EQUIPMENT Support and handling EQUIPMENT consists of the deliverable tools and handling equipment used for support of the MISSION...

Ngày tải lên: 13/08/2014, 08:21

... inadequate and requires yet a more specialized solution including the following sequences of design actions: Design action 1: Design action 2: Design action 3: Design action 4: Design action 5: Design ... threat analysis is typically performed via failure modes and effects analysis (FMEA) For mission critical components, the FMEA may be expanded into a failure modes, effects, and criticality analysis ... by-products, and services In operation, the SOI (1) responds to command and control guidance and direction from the HIGHER ORDER systems element that consists of ORGANIZATION (10), ROLES AND MISSIONS...

Ngày tải lên: 13/08/2014, 08:21

... modeling and simulation; and trade study analysis of alternatives System design and development requires on-going integrity assessments to ensure that the system is being designed correctly and will ... schedule, and risk The System Design and Development Practices series consists of Chapters 34–46 and cover a diverse range of system design and development practices Our discussions include: understanding ... developed, and reviewed The System Specification Practices provide the cornerstone for our next topical discussion, System Design and Development Practices System Design and Development Practices The design...

Ngày tải lên: 13/08/2014, 08:21

... Chapter Merge and Analysis Competitive Analysis Do the specification requirements favor or target a competitor’s products, services, or organizational capabilities? Modeling and Simulation Analysis ... a use case analysis, and derives sibling requirements A_11 and B_11 Author’s Note 32.2 At this point, the SEIT has not allocated requirements A_11 and B_11 to SUBSYSTEMs A and B We designate each ... Follow a Standard Specification Outline Many specification issues are traceable to a lack of commitment to establish and employ standard specification development outlines and guidelines Standard outlines...

Ngày tải lên: 13/08/2014, 08:21

... mission and operations analysis, field interviews with the User, analyze existing system trouble reports, and understand the OPERATING ENVIRONMENT and its players and threats Step 2: Capture and Bound ... strategy and tailor them to suit your own business domain and systems application Step 1: Understand the problem and solution space(s) Step 2: Capture and bound entity requirements Step 3: Analyze and ... decentralized, and distributed processing; fault tolerant architectural design; environmental, safety, and health (ES&H) considerations, fire detection and suppression; and security and protection...

Ngày tải lên: 13/08/2014, 08:21

... 44.2 Display and Control Design 44.3 Design of Equipment, Vehicles, and Other Systems 10 11 44.4 Workplace, Crew Station, and Facilities Design Console and workstation dimensions and layout General ... next topic, system command and control (C2) devices SYSTEM Command and Control (C2) Devices PERSONNEL require mechanisms to command and control (C2) SYSTEM operations and performance We refer ... employing similar and effective user dialogues, interfaces, and procedures 44.5 Displays and Controls Design and arrangement of displays and controls to be consistent with the operator’s and maintainer’s...

Ngày tải lên: 13/08/2014, 08:21

... performance evaluation and analysis 47.5 SYSTEM PERFORMANCE EVALUATION AND ANALYSIS System performance evaluation and analysis is the investigation, study, and operational analysis of actual or ... and task analysis Environmental analysis Fault tree analysis (FTA) Finite element analysis (FEA) Mechanical analysis Electromagnetic interference (EMI)/electromagnetic countermeasures (EMC) analysis ... modeling and simulation results and develop a prototype of the system for further analysis and Simpo PDF 48 Statistical Influences on System DesignVersion - http://www.simpopdf.com 590 Chapter Merge and...

Ngày tải lên: 13/08/2014, 08:21

... development, PRODUCTS A, B, and C are MODELED and incorporated into simulations: Simulation A (4); Simulations B1 (7), B2 (9), B3 (8); and Simulation Subsystem Subsystem Simulation B1 Simulation B1 PRODUCT ... Adapter Adapter Subsystem Subsystem Simulation B3 Simulation B3 Subsystem Subsystem Simulation B2 Simulation B2 12 Simulation Simulation C C Where: Figure 51.7 Simulation Testbed Approach to System ... system 51.6 MODELING AND SIMULATION CHALLENGES AND ISSUES Although modeling and simulation offer great opportunities for SEs to exploit technology to understand the problem and solution spaces,...

Ngày tải lên: 13/08/2014, 08:21