amp analysis users manual method

... try to use the methods based on nonstationarity, since these methods utilize the time structure but not require the time structure of each IC to be different The nonstationarity methods work best, ... gives a simpler alternative to methods based on joint approximative diagonalization Such an extension allows estimation of the model in some cases where the simple method using a single time lag ... local autocorrelations An alternative method for using nonstationarity will be considered next 18.2.2 Using cross-cumulants Nonlinear autocorrelations A second method of using nonstationarity is...

Ngày tải lên: 20/01/2014, 11:20

... readily observable, a suite of methods, including spectral analysis, fractal analysis, wavelet analysis, scale variance, geostatistics, and multiscale object-specific analysis (e.g., Turner et al ... but unlike dimensional analysis, similarity analysis requires the governing equations of the phenomenon to be known (Blöschl and Sivapalan 1995) Examples of similarity analysis are abundant in ... theories, methods and case studies in scaling and uncertainty analysis that are relevant to ecology The series of case studies included here illustrate how scaling and uncertainty analysis are...

Ngày tải lên: 17/02/2014, 19:20

... automatic method based on Yasuda’s method and found that the method using ROUGE-2 and -3 could accurately estimate manual scores, and could outperform Kazawa’s method and the other automatic methods ... We therefore evaluated the automatic methods using Gap, which manually indicates the difference between the scores from a manual method and each automatic method that estimates the scores First, ... 608 Table Gap between the manual method and Yasuda’s method precision 0.8 0.6 0.4 0.2 0 0.2 0.4 0.6 0.8 threshold value Kazawa's method R-2 Figure Comparison of Kazawa’s method and ROUGE-2 (ratio:...

Ngày tải lên: 17/03/2014, 04:20

... be sampled may also be required What it includes: a) Selection of sampling procedures including procedures of analysis of samples b) Sampling locations c) Period of sampling, frequency of sampling ... effective average over the period of sampling 1|Page Sampling locations: Sampling locations are in general governed by factors like objectives, method of sampling and resources available If the ... obtained by sampling for a short time – i.e by sampling a known volume of air for the required averaging time Samples are then analyzed by established physical, chemical, and biological methods for...

Ngày tải lên: 29/03/2014, 14:20

Ngày tải lên: 31/03/2014, 15:17

... spectrophotometers Quantitative analysis: laws of molecular absorption Methods in quantitative analysis Analysis of a single analyte and purity control Multicomponent analysis (MCA) Methods of baseline correction ... Labelling methods 17.1 17.2 17.3 17.4 17.5 17.6 The principle of labelling methodologies Direct isotope dilution analysis with a radioactive label Substoichiometric isotope dilution analysis Radio ... analysis (IFA) 17.11 Stable isotope labelling 17.12 Neutron activation analysis (NAA) Problems 18 Elemental analysis 18.1 18.2 18.3 18.4 18.5 18.6 Particular analyses Elemental organic microanalysis...

Ngày tải lên: 01/04/2014, 10:59

... 0.1～10.0 Mfr Value: 0.1 F610 　 Sampling Cycle (S) Setting Range: 0.1～10.0 Mfr Value: 0.1 · Proportion and Gain Integration (P) Time (Ti) as shown in Fig 510 refers Sampling to that Extent limited ... set beeline V/F curve, polygonal line V/F curve and square V/F curve as per load Torque Promotion Manual setting torque promotion within 1～15％ Automatic Voltage Automatic setting output voltage ... remote control Please refer to P26 about the actual “stop” function 4.2 Functioon Parameters Setting Users can adopt various application modes for changing function-code parameters Please input user’s...

Ngày tải lên: 18/04/2014, 09:26

... Carsten Heiming, Till Kampetter, Damien Dams Krotkine, Robert Kulagowski, François Pons, Guillaume Poulin, Pascal Pixel Rigaux, John Rye Tools used in the making of this manual This manual was written ... described above, to achieve the same result 6.2.3 System Generic Users Whenever possible, we used two generic users in our examples: Queen Pingusa This user is created at installation time Peter ... different renderings The following table shows an example of each special word or group of words with its actual rendering and what this means Formatted Example Meaning inode This formatting is used...

Ngày tải lên: 28/04/2014, 16:53

... MENU Analysis Options 15-1 Building Active Degrees of Freedom 15-1 Dynamic Analysis Parameters 15-3 P-Delta Analysis Parameters 15-5 Run Analysis 15-8 Analyze Window 15-9 Run Static Nonlinear Analysis ... elements can be used in static linear analysis, static nonlinear analysis (pushover), dynamic (time history) linear analysis and dynamic nonlinear analysis Analysis Features Static analyses for ... either the SRSS or the ABS technique Composite modal damping effects from supplemental dampers are included in the analysis The linear time history analysis uses a variable time step closed form integration...

Ngày tải lên: 11/06/2014, 22:45

... sensitive methods have been developed to detect CTC in blood of cancer patients These methods include flow cytometry, immunohistochemistry and real time RT-PCR [23-27] Still, most of these methods ... 13% of examined samples These samples may represent tissues producing maximal level of GNRH1 or tissue fragments containing higher number of cancer cells Immunohistochemical analysis could verify ... informed consent Sample collection ml of blood from the patients and from the volunteers was collected in S-monovette tubes (SARSTEDT AG & Co., Numbrecht, Germany) The blood samples where diluted...

Ngày tải lên: 18/06/2014, 22:20

... modelling, fluid flow, sketch input, architectural software, geometric computing, structural analysis, statistical analysis, parsing, natural language processing, compiler writing, computer language translators, ... submit to analysis, realistic enough to be relevant, we admit that a programmer likewise needs a collection of software models: pure archetypical computational mechanisms that assist analysis ... must be used Common examples of simulated cellular automata are the numerical models for solution of partial differential equations This merges seamlessly with finite element analysis By including...

Ngày tải lên: 03/07/2014, 21:10

... because the methods are not mutually exclusive There is always a trade-off for each method selected In addition, no method is perfect and no single method dominates, making a triangulation of methods ... general, the methods available can be classified into quantitative and qualitative methods Quantitative Methods Quantitative methods are analytically more thorough than qualitative methods and ... is a framework for the analysis of the impacts of education on women Source: Valadez and Bamberger 1994 Methodology for Conducting Poverty Impact Analysis The choice of methodology used in PIA...

Ngày tải lên: 08/08/2014, 10:23

... poverty predictors As in the first method, specificity and sensitivity tests are also implemented Total and hardcore poverty are also examined in this method Method 3: Wealth Index PCA One of the ... the Engel law method The total and food poverty lines used in this study are shown in Appendix 1.2 Poverty Impact Analysis: Tools and Applications Chapter 59 Results Correlate Model Method When ... 33.48 Source: Authors’ calculation Poverty Impact Analysis: Tools and Applications Chapter 63 Poverty Probability Method The poverty probability method predicts poverty directly because of the...

Ngày tải lên: 08/08/2014, 10:23

... Data Analysis Method Data collected from the field survey were analyzed through quantitative and qualitative methods to validate variables that could be used as predictors The quantitative method ... perception method, 363 of the total 624 household samples were classified poor and 261 nonpoor—with all four sources mostly agreeing on the classification of the households as poor or nonpoor For example, ... the respondent is really poor Poverty Impact Analysis: Tools and Applications Chapter 79 Table 2.1 Assessing Poverty by Using the Weighted Perception Method Poverty Assessment from Local Perception...

Ngày tải lên: 08/08/2014, 10:23

... existing sampling design, each poor county with 5–10 sample villages and 10 households in each village are randomly sampled for the survey Since the village codes are randomly assigned to the sample ... models, the sample was split into two subsamples: Data1 and Data2 Village codes were randomly assigned to the sample villages and the splitting of the sample was done by assigning those with odd ... sample size of 50,000 households Excluding the households with missing values, the total sample would be 45,960 households For comparison and robustness tests of the regression models, the sample...

Ngày tải lên: 08/08/2014, 10:23

... for the subsample group Data1 in Sangui, Pingping, and Heng (2005) were applied to 450 sample households from the CRPMS to predict the per capita living expenditure for the said sample The result ... with the perception of household poverty status based on the independent assessments Validation Method As a preliminary step, the significance of the predictors of household poverty status was ... cross tabulated to reveal accuracy For the logit model, CNY stands for Chinese Yuan Poverty Impact Analysis: Tools and Applications Chapter 119 sensitivity and specificity coefficients were directly...

Ngày tải lên: 08/08/2014, 10:23

... trade liberalization The sampling method used in this pilot survey was the two-stage cluster random sampling The survey was conducted in Thanh Hoa and Nghe An with a sample size of 500 households ... was done by randomly drawing a subsample of 50 percent of the total sample as the learning data set for both rural and urban areas The other 50 percent subsample was used as the validation data ... variable were retained The analysis used Poverty Impact Analysis: Tools and Applications Chapter 131 an F-test for means for categorical variables (see Table 5.2 for an example) and a correlation...

Ngày tải lên: 08/08/2014, 10:23

... the result This second method is done by using household characteristics available from survey and census data sets Finally, a third method is to combine the first two methods by mapping poverty ... information from the household survey with the population census, replicating the method used by Elbers, Lanjouw, and Lanjouw (ELL Method) Cluster estimation was also used by Fujii (2005) to conduct small-area ... poverty mapping are available from BPS Indonesia Poverty Impact Analysis: Tools and Applications Chapter 171 Modeling Developments The methodology applied to this study, the ELL, is described in...

Ngày tải lên: 08/08/2014, 10:23

... Indonesian Government, 1945–2007 Poverty Impact Analysis: Tools and Applications Chapter 213 Applications of the CGE Modeling Framework for Poverty Impact Analysis 214 Computable General Equilibrium ... Indonesia in 1985, 1990, and 1993 Poverty Impact Analysis: Tools and Applications Chapter 215 Applications of the CGE Modeling Framework for Poverty Impact Analysis 216 Computable General Equilibrium ... 1985–1993 Change in Tariff Rate (%) Poverty Impact Analysis: Tools and Applications Chapter 217 Applications of the CGE Modeling Framework for Poverty Impact Analysis 218 Computable General Equilibrium...

Ngày tải lên: 08/08/2014, 10:23

... observation, the study selected these two infrastructure sectors for analysis Applications of the CGE Modeling Framework for Poverty Impact Analysis 244 CGE Model: Infrastructure Development and Poverty ... useful observations These studies can be grouped into two categories based on the methodology they use: econometric analysis and case studies With case studies, researchers evaluate the adoption ... 0.078, depending on the specific econometric method used In a similar study, Deichmann et al Applications of the CGE Modeling Framework for Poverty Impact Analysis 252 CGE Model: Infrastructure Development...

Ngày tải lên: 08/08/2014, 10:23