... Mechanics and StrengthofMaterials Vitor Dias da Silva Mechanics and StrengthofMaterials ABC Vitor Dias da Silva Department of Civil Engineering Faculty of Science & Technology University of Coimbra ... awareness of the lack of a treatise, written in European Portuguese, which contains the theoretical material taught in the disciplines of the Mechanics of Solid Materials and the Strengthof Materials, ... disciplines of Applied Mechanics II (Introduction to the Mechanics of Materials) and Strengthof Materials, taught by the author in the Civil Engineering course and also in the Geological Engineering, Materials...
... awareness of the lack of a treatise, written in European Portuguese, which contains the theoretical material taught in the disciplines of the Mechanics of Solid Materials and the Strengthof Materials, ... disciplines of Applied Mechanics II (Introduction to the Mechanics of Materials) and Strengthof Materials, taught by the author in the Civil Engineering course and also in the Geological Engineering, Materials ... Mechanics ofMaterials I Introduction I.1 General Considerations Materials are of a discrete nature, since they are made of atoms and molecules, in the case of liquids and gases, or, in the case of...
... curve of Figure 1.2 is not typical of all materials; it is reasonably typical, however, of the behaviour of brittle materials, which are discussed more fully in Section 1.5 An important feature of ... Strain energy of elastic torsion 16.8 Plastic torsion of a circular shaft 16.9 Torsion of thin tubes of non-circular cross-section 16.10 Torsion of a flat rectangular strip 16.11 Torsion of thin-walled ... of the Systeme Internationale d’Unites; this is usually referred to as the SI system In the field of the strengthofmaterials and structures we are concerned with the following basic units of...