Doc Nr Revision Stand Hot-Jet S Umbauanleitung / Conversion instructions 1.0 PRI 31.03.2010 Hot-Jet S: Umbauanleitung elektronische Schaltung DNS 1A/B Î HCU 04A Betroffene Geräte: Hot-Jet S bis Produktionscode 1008 • Die braune Litze vom/zum Fototransistor ist durch eine Litze mit 180mm Länge (ArtikelNr 100.839) zu ersetzen Diese wird in die neue Lưtfahne beim Potentiometer zur Temperatureinstellung eingelưtet • Die blaue Litze vom/zum Fototransistor wird in die nun freie Lötfahne beim Triac eingelötet (Lötfahnen mit Isolierlack 2451, schwarz, überziehen) Elektronische Schaltung DNS 1A/B Electronic circuit DNS 1A/B Braun / Brown Braun / Brown Blau / Blue Ansicht von unten Bottom view Ansicht von oben Elektronische Schaltung HCU 04A Braun / Brown Top view Electronic circuit HCU 04A Braun / Brown Blau / Blue Blau / Blue Ansicht von unten Bottom view Ansicht von oben Top view Hot-Jet S: Conversion instructions electronic circuit DNS 1A/B Ỵ HCU 04A Affected tools: Hot-Jet S up to production code 1008 • Replace the brown flex wire from/to the photo transistor by a flex wire of 180mm length (article no 100.839) Solder this flex wire into the new soldering tag next to the potentiometer for temperature adjustment • Solder the blue flex wire from/to the photo transistor into the soldering tag next to the triac (cover soldering tags with insulation varnish 2451, black) File: Hot-Jet S Umbauanleitung_Conversion instructions.doc Page 1/1