1. Trang chủ
  2. » Kỹ Thuật - Công Nghệ

Shop manual máy đào HuynDai R170W-9 (Phần 5) - P5.12

1 308 2
Tài liệu đã được kiểm tra trùng lặp

Đang tải... (xem toàn văn)

THÔNG TIN TÀI LIỆU

Thông tin cơ bản

Định dạng
Số trang 1
Dung lượng 13,64 MB

Nội dung

Shop manual máy đào HuynDai R170W-9 (Phần 5) Phần hệ thống cơ điện tử

5-275-271. MCU and Engine ECM1. MCU and Engine ECM (Electronic Control Module)GROUP 12 ENGINE CONTROL SYSTEMGROUP 12 ENGINE CONTROL SYSTEM2. MCU ASSEMBLY2. MCU ASSEMBLYTo match the pump absorption torque with the engine torque, MCU varies EPPR valve output pressure, which control pump discharge amount whenever feedbacked engine speed drops under the reference rpm of each mode set.Three LED lamps on the MCU display as below.1)2)SEEKVOLMODECALLMUTEV 1 MCU 2 Fuel tank 3 Bolt (M8)14W95MS13G : green, R : red, Y : yellowLED lamp Trouble ServiceG is turned ON Normal· -G and R are turned ON Trouble on MCU ·Change the MCUG and Y are turned ONTrouble on serialcommunication line·Check if serial communicationlines between controller and cluster are disconnectedThree LED are turned OFF Trouble on MCU power··Check if the input power wire (24 V, GND) of controller is disconnectedCheck the fuse . 5-2 7 5-2 71. MCU and Engine ECM1. MCU and Engine ECM (Electronic Control Module)GROUP 12 ENGINE CONTROL SYSTEMGROUP 12 ENGINE CONTROL. R : red, Y : yellowLED lamp Trouble ServiceG is turned ON Normal· -G and R are turned ON Trouble on MCU ·Change the MCUG and Y are turned ONTrouble

Ngày đăng: 29/10/2012, 15:08

TỪ KHÓA LIÊN QUAN