000450U001 2007 SECTION II, PART A SA/EN 10028 3 SPECIFICATION FOR FLAT PRODUCTS MADE OF STEELS FOR PRESSURE PURPOSES PART 3 WELDABLE FINE GRAIN STEELS, NORMALIZED SA/EN 10028 3 (Identical with BS EN[.]
2007 SECTION II, PART A SA/EN 10028-3 SPECIFICATION FOR FLAT PRODUCTS MADE OF STEELS FOR PRESSURE PURPOSES PART 3: WELDABLE FINE GRAIN STEELS, NORMALIZED SA/EN 10028-3 (Identical with BS EN 10028-3-1992, with the additional requirements listed on this cover sheet No other Edition is approved for ASME use.) stamped with the letter “G” following the stamped specification designation ```,,,,,,``,`,``,,`````,`,`,``-`-`,,`,,`,`,,` - Additional Requirements 1.1 Marking In addition to the marking requirements of this specification, the prefix, SA/, shall be added ahead of the marking on all products required to be marked by this specification, and to the material identification used on all documentation required by the specification Material that has been given the full heat treatment required by para 8.2.1 or 8.2.2 shall be marked with the letters “MT”, following the marked specification designation, by the party performing the heat treatment Plates that are not heat treated but that are qualified on the basis of heat treated specimens per para 8.2.3 shall be Mechanical Properties The mechanical properties required in Table for product thickness over 150 mm shall be the same as those for 100–150 mm Source 3.1 See Nonmandatory Appendix A for ordering information 1655 Copyright ASME International Provided by IHS under license with ASME No reproduction or networking permitted without license from IHS Licensee=Chevron Corp/5912388100 Not for Resale, 08/28/2008 11:19:59 MDT 07 1656 Copyright ASME International Provided by IHS under license with ASME No reproduction or networking permitted without license from IHS Licensee=Chevron Corp/5912388100 Not for Resale, 08/28/2008 11:19:59 MDT