Microsoft Word C042764e doc ICS 23 100 50 Ref No ISO 20401 2005/Cor 1 2005(E) © ISO 2005 – All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 20401 2005 TECHNICAL CORRIGENDUM 1 Pu[.]
INTERNATIONAL STANDARD ISO 20401:2005 TECHNICAL CORRIGENDUM Published 2005-08-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION Pneumatic fluid power systems — Directional control valves — Specification of pin assignment for electrical round connectors of diameters mm and 12 mm TECHNICAL CORRIGENDUM Transmissions pneumatiques — Distributeurs de commande directionnels — Spécification de l'affectation des broches des connecteurs électriques ronds de diamètres mm et 12 mm RECTIFICATIF TECHNIQUE Technical Corrigendum to ISO 20401:2005 was prepared by Technical Committee ISO/TC 131, Fluid power systems, Subcommittee SC 5, Control products and components Page 1, Scope Replace Figure D.2 of IEC 60947-5-2:2004, shown in a simplified version, with the following ICS 23.100.50 © ISO 2005 – All rights reserved Published in Switzerland Ref No ISO 20401:2005/Cor.1:2005(E)