F 1950 – 99 Designation F 1950 – 99 Standard Specification for Physical Information to be Transferred With Used Amusement Rides and Devices 1 This standard is issued under the fixed designation F 1950[.]
Designation: F 1950 – 99 AMERICAN SOCIETY FOR TESTING AND MATERIALS 100 Barr Harbor Dr., West Conshohocken, PA 19428 Reprinted from the Annual Book of ASTM Standards Copyright ASTM Standard Specification for Physical Information to be Transferred With Used Amusement Rides and Devices1 This standard is issued under the fixed designation F 1950; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision A number in parentheses indicates the year of last reapproval A superscript epsilon (e) indicates an editorial change since the last revision or reapproval Scope 1.1 This specification covers the requirements for information that shall supplement the sale or transfer of ownership of an amusement ride or device 1.2 This specification applies only to amusement rides and devices, which have previously been in operation, and which are being sold or transferred as a used amusement ride or device provide to the new owner written notice of major modifications the seller has made or caused to be made, and component operational and maintenance manuals in the seller’s possession 3.2 Purchaser’s Responsibility: 3.2.1 The purchaser of a used amusement ride or device shall notify the original manufacturer of the ride or device being purchased of the change in ownership of the ride or device 3.2.2 The purchaser shall request from the original manufacturer all updated owner, operational, and maintenance manuals and service bulletins 3.3 Manufacturer’s Responsibility: 3.3.1 The original manufacturer of the used amusement ride or device being sold shall make available, upon request by the purchaser, owner, operational, and maintenance information along with updates, if any 3.3.2 The original manufacturer of the used amusement ride or device being sold shall make available to the purchaser information regarding any major modifications made to the ride or device, which the manufacturer authorized or otherwise performed on the ride or device Significance and Use 2.1 The purpose of this specification is to provide to the new owner of an amusement ride or device, available information for the identification, placement, erection, operation, and maintenance of the amusement ride or device Information Requirements 3.1 Seller’s Responsibility: 3.1.1 The seller of a used amusement ride or device shall provide to the new owner existing manufacturer’s documentation, in seller’s possession 3.1.2 The seller of a used amusement ride or device shall Keywords 4.1 major modifications; sale or transfer; used amusement rides and devices This specification is under the jurisdiction of ASTM Committee F-24 on Amusement Rides and Devices and is the direct responsibility of Subcommittee F24.20 on Specifications and Terminology Current edition approved Jan 10, 1999 Published May 1999 The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years and if not revised, either reapproved or withdrawn Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, 100 Barr Harbor Drive, West Conshohocken, PA 19428