maquette MCIS501E INTERNATIONAL STANDARD ISO 13127 2012 TECHNICAL CORRIGENDUM 1 Published 2012 12 01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ ORGA[.]
INTERNATIONAL STANDARD ISO 13127:2012 TECHNICAL CORRIGENDUM Published 2012-12-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ ORGANISATION INTERNATIONALE DE NORMALISATION Packaging — Child resistant packaging — Mechanical test methods for reclosable child resistant packaging systems TECHNICAL CORRIGENDUM Emballages — Emballages l'épreuve des enfants — Méthodes d'essais mécaniques pour systèmes d'emballage refermables l'épreuve des enfants RECTIFICATIF TECHNIQUE Technical Corrigendum to ISO 13127:2012 was prepared by Technical Committee ISO/TC 122, Packaging, Subcommittee SC 3, Performance requirements and tests for means of packaging, packages and unit loads ICS 55.020 © ISO 2012 – All rights reserved Published in Switzerland Ref No ISO 13127:2012/Cor.1:2012(E) ISO 13127:2012/Cor.1:2012(E) Page 4, Figure Add two arrows to the drawing as indicated by the ovals: Risk assessment (note 1) Identify essential characteristics impacted by proposed change & potential effects of these on child resistant functionality Can effects be assessed by mechanical tests in 6.3? No Yes Record the test rationale & Conduct mechanical testing All test package data fall within the same range as the Reference Data/|Specification ? No Some, but not all test package data fall within the same range as the Reference Data /Specification? No Data for all or most tests fall outside of the range of the Reference Data or Specification and/or, the deviations show no consistent trend to be all lower, or all higher Yes Yes Test results are lower than Reference Data/Specification ? No Test results are higher than Reference Data/Specification? Yes Approved Conduct Child Panel Test (Note 2) Conduct Adult Panel Test (Note 2) Conduct Full Panel Testing (Note 2) Pass Not Approved Fail Notes Consideration should be given for using suitable risk assessment methodology, (e g IEC ISO 31010 Risk management – Risk assessment techniques) Or reject modification Figure — Decision flowchart for the use of mechanical testing of modifications to a type approved package © ISO 2012 – All rights reserved