INTERNATIONAL STANDARD IS0 8526 2 1990 TECHNICAL CORRIGENDUM 1 Published 1992 07 01 INTERNATIONAL ORGANIZATION FOR STANDARDlZATlON*MEXflYHAPO~HAB OPTAHM3AL/MR I IO CTAHflAPTM3Al@lM l ORGANISATION INTE[.]
INTERNATIONAL STANDARD TECHNICAL CORRIGENDUM Published INTERNATIONAL ORGANIZATION Modular FOR STANDARDlZATlON*MEXflYHAPO~HAB units Part 2: Workholding &ments - pour machines-outils Partie 2: Palettes Porte-pike RECTIFICATIF TECHNIQUE Technical corrigendum tools, Sub-Committee tools I-IO CTAHflAPTM3Al@lM l ORGANISATION INTERNATIONALE - Workholding DE NORMALISATION pallets - pallets of nominal size greater than 800 mm TECHNICAL CORRIGENDUM standards 1992-07-01 OPTAHM3AL/MR for machine IS0 8526-2 : 1990 de dimension Palettes nominale supkrieure ;5 800 rnl~l 1 to International Standard IS0 8526-2 : 1990 was prepared SC 3, Modular units for machine tools by Technical Committee ISO/TC 39, Machine Page 10 Figure Replace this figure with the following UDC 621.9-229.3 : 621.869.82 Descriptors figure : machine tools, IS0 1992 Printed in Switzerland modular units, work-holding Ref No IS0 8526-2 : 199OEor.l devices, specifications, dimensions, designation : 1992 (E) IS0 8526-2 : 199OKor.l : 1992 (E) Dimensions in millimetres x-x - L6 1R/4 I I s AI I- Enlarged DI t-+-i - T k+ counterbored holes Lo, ,- counterbored holes Figure - Details of edge locators (when fitted) On this new figure, the dimensions 20 mm and 40 mm specified for the two edge locators shown at the lower right replace the former dimensions 18 mm and 36 mm respectively, and hence correspond to the dimensions specified at the upper left Page 14 Figure B.1 Replace this figure with the following figure B.l IS0 8526-2 : 199OEor.l : 1992 (E) Dimensions in millimetres Figure The new figure shows the T-slots B.l - Pallets with an arithmetic for pallets with nominal dimension progression of the T-slot pitches 250 mm This page intentionally left blank