... square makes a model 6" high
10.Squash. 11.Valley up.
13.Form valley fold, allowing
squash to form at bottom.
14.Pull one layer through. 15.Valley folds.
16.Turn over.
12.Precrease.
17.Swing ... rabbit-ear
formation.
22.Swing over. 23.Petal up. 24.Swing up.
27.Valley outwards.26.Swing down.25.Sink triangularly.
28.Precrease flap halfway. 29.Valley along precrease. 30.Valley down point, w...
... the
resulting corner as
shown.
36. 37.
Bring up the top layer again then valley fold the next
layer
and then valley fold again
and crimp as illustrated.
38. 39.
Now bring down the layer ... open out the
layer on the left.
Fold up the lower portion of
the assembly as shown.
20. 21. 22.
Valley fold then crimp fold each
side.
Fold assembly in half while
lifting out the layer at the
top .....
... over.
26. Valley fold,
creasing sharply.
not to tip
27. Bring one layer to
front (closed sink).
$ Dragonfly, v2 (continued)
Copyright 1998-2000 Stephen Hecht. All Rights Reserved
28. Valley-fold ... half; the
standing flaps fall to the left. No
new creases. Rotate.
1/4
9. Reverse-fold on
existing creases.
$ Dragonfly, v2 (continued)
Copyright 1998-2000 Stephen Hecht. All Rights Reserved
1...
... crease and unfold.
2. Fold the edges in to the center.
3. Fold two diagonls across the bill and a valley
fold between the two x’s.
4. Using the diamond formed
by the 2 big x,s swivel fold
out
... over.
26. Valley fold,
creasing sharply.
not to tip
27. Bring one layer to
front (closed sink).
$ Dragonfly, v2 (continued)
Copyright 1998-2000 Stephen Hecht. All Rights Reserved
28. Valley-fold ... half; the
standing flaps fall to the left. No
new creases. Rotate.
1/4
9. Reverse-fold on
existing creases.
$ Dragonfly, v2 (continued)
Copyright 1998-2000 Stephen Hecht. All Rights Reserved
1...