Tài liệu Fundamentals of electromechanical energy conversion docx

... Engineering  E Levi, 2002 1 FUNDAMENTALS OF ELECTROMECHANICAL ENERGY CONVERSION 1. PRELIMINARY CONSIDERATIONS Electromechanical energy conversion is achievable in a number of ways. These possibilities ... Illustration of generation. It is important to note here that the process of electromechanical energy conversion is reversible. This means that either electric...

Ngày tải lên: 23/01/2014, 06:20

... Engineering  E Levi, 2002 1 FUNDAMENTALS OF ELECTROMECHANICAL ENERGY CONVERSION 1. PRELIMINARY CONSIDERATIONS Electromechanical energy conversion is achievable in a number of ways. These possibilities ... Illustration of generation. It is important to note here that the process of electromechanical energy conversion is reversible. This means that either electric...

Ngày tải lên: 23/01/2014, 06:20

... yield point of 350 MPa. Find the required diameter using (a) Maximum shear stress theory (b) Maximum distortion energy theory Take a factor of safety of 2.5. Maximum distortion energy theory Maximum ... tensile yield point. Total strain energy E T and strain energy for volume change E V can be given as Substituting strains in terms of stresses the distortion en...

Ngày tải lên: 25/12/2013, 23:18

... However, in the presence of notches and cracks determination of total strain is difficult. 3.4.1.2F- Plots of strain amplitude vs number of stress reversals for failure. ... At the end of this lesson, the students should be able to understand • Design of components subjected to low cycle fatigue; concept and necessary formulations. • Design of...

Ngày tải lên: 25/12/2013, 23:18

... (8.1.1) Where, M : Bending moment at the point of interest d o : Outer diameter of the shaft k : Ratio of inner to outer diameters of the shaft ( k = 0 for a solid shaft because ... Kamalesh, Design of Machine Elements, Prentice Hall of India, New Delhi, 2003. Version 2 ME , IIT Kharagpur Module 8 Design of Shaft...

Ngày tải lên: 23/01/2014, 04:20

... junctions we ld weld 9.2.2.4F- Method of construction of multilayered cylinder 3. Autofrettage In some applications of thick cylinders such as gun barrels no inelastic deformation ... find the radial displacements of the cylinder walls at the contact we consider that ( r u1 rE θθ ) ε == σ−νσ. This gives the radial displacement of the inner wall of the...

Ngày tải lên: 27/01/2014, 14:20

Ngày tải lên: 20/12/2013, 17:15

... cost/performance trade-offs than those using current costs. The caption of Figure 1.3 discusses some of the long-term trends in DRAM cost. FIGURE 1.3 Prices of four generations of DRAMs over time ... instruction formats, and a large number of registers. Figure 2.30 shows the ratio of the number of instructions executed, the ratio of CPIs, and the ratio of performance measu...

Ngày tải lên: 22/12/2013, 10:16

Ngày tải lên: 18/02/2014, 12:20

Ngày tải lên: 22/02/2014, 06:20