Tài liệu Configuring Frame Relay PVC pdf

... 5.2.2 Configuring Frame Relay PVC Objective • Configure two routers back-to-back as a Frame Relay permanent virtual circuit (PVC) . This will be done manually, in the absence of a Frame Relay ... Dublin(config-if)#description PVC to Washington, DLCI 102, Circuit #DASS465866 Contact Pat White (091-6543211) Step 6 Verifying Frame Relay PVC a. On the Washington...

Ngày tải lên: 18/01/2014, 05:20

... 192.168.6.0 Step 7 Verifying Frame Relay PVC a. On the Amsterdam router, issue the command show frame- relay pvc: Amsterdam#show frame- relay pvc b. How many active local PVCs are there? _____________________________________________ ... across the PVC. Step 8 Show the Frame Relay maps a. Look at the frame relay maps by typing the command show frame- rela...

Ngày tải lên: 18/01/2014, 05:20

... this PVC In Bytes Number of bytes received on this PVC Out Bytes Number of bytes sent on this PVC Dropped Pkts Number of incoming and outgoing packets dropped by the router at the Frame Relay ... broadcast bytes PVC Create Time Time the PVC was created Last Time PVC Status Changed Time the PVC changed status (active to inactive) Service Type Type of service perfo...

Ngày tải lên: 11/12/2013, 14:15

... encapsulation frame- relay no ip mroute-cache cdp enable frame- relay interface-dlci 18 frame- relay lmi-type ansi As was discovered earlier, the encapsulation is frame- relay and the frame- relay ... information about each router. • show interface • show frame- relay lmi • show frame- relay pvc • show frame- relay map • debug frame- relay lmi...

Ngày tải lên: 11/12/2013, 14:15

... Lab 5.2.1 Configuring Frame Relay Objective • Configure a router to establish a connection to a local Frame Relay switch. Background/Preparation An Adtran Atlas550 Frame Relay emulator ... lab. Step 2 Configuring the serial interface a. In Frame Relay, the customer router is considered the DTE device. In order to configure the serial interface the Layer 2 Fram...

Ngày tải lên: 18/01/2014, 05:20

... 192.168.6.0 Step 7 Verifying Frame Relay PVC a. On the Amsterdam router, issue the command show frame- relay pvc: Amsterdam#show frame- relay pvc b. How many active local PVCs are there? _____________________________________________ ... across the PVC. Step 8 Show the Frame Relay maps a. Look at the frame relay maps by typing the command show frame- rela...

Ngày tải lên: 18/01/2014, 05:20

... 5.2.2 Configuring Frame Relay PVC Objective • Configure two routers back-to-back as a Frame Relay permanent virtual circuit (PVC) . This will be done manually, in the absence of a Frame Relay ... Dublin(config-if)#description PVC to Washington, DLCI 102, Circuit #DASS465866 Contact Pat White (091-6543211) Step 6 Verifying Frame Relay PVC a. On the Washington...

Ngày tải lên: 11/12/2013, 14:15

... 192.168.6.0 Step 7 Verifying Frame Relay PVC a. On the Amsterdam router, issue the command show frame- relay pvc: Amsterdam#show frame- relay pvc b. How many active local PVCs are there? _____________________________________________ ... across the PVC. Step 8 Show the Frame Relay maps a. Look at the frame relay maps by typing the command show frame- rel...

Ngày tải lên: 11/12/2013, 14:15

... address via a “static” frame- relay map statement. “CISCO” identifies the Frame Relay encapsulation used with frame- relay map statement, which is the default Frame Relay encapsulation on Cisco ... broadcast frame- relay lmi-type ansi Remove the incorrect frame- relay map statement. Singapore(config-if)#no frame- relay map ip 192.168.192.2 17 broadcast Reen...

Ngày tải lên: 11/12/2013, 14:15

... as DLCI 16] not shown or referenced below.) Singapore#show frame- relay pvc PVC Statistics for interface Serial0/0 (Frame Relay DTE) Active Inactive Deleted Static Local 1 0 1 0 ... Turn debug frame- relay packet off. Singapore#no debug frame- relay packet or no debug all 4. Based upon the map being dynamically established and output from the debug frame...

Ngày tải lên: 11/12/2013, 14:15